查询词典 width

The effects of laser process parameters on kerf width and quality were studied.

系统研究了工艺参数对切缝宽度和切缝质量的影响规律。

Range of kerf width and exposure may be changed for optimized performance.

一系列的切缝宽度和曝光可能会改为优化的表现。

This is achieved by using a unique multi beam technology, demonstrated in figure 2, which reduces the power density, minimizes the thermal load, and reduces the kerf width in the wafer.

这是采用独特的多光束技术实现的，图2显示了其工作原理，降低了功率密度，减小了热负载，缩小了刻线宽度。

Cutting machine used to cut sheet alloy up to 1 meter in diameter, which saw kerf depth of up to 40 cm, while the width, but 0.8 centimeters.

切割机用的合金切割片直径达1米，其锯缝深度可达40厘米，而宽度不过0.8厘米。

Second, a 3D unsteady-state numerical model of heat transfer in laser circular cutting of pipe was set up for the first time, and the kerf width, the cut front profile, the temperature field and the heat affected zone were calculated by using the model.

其次，首次建立了管材激光圆周切割传热过程的三维非稳态温度场计算模型，并计算了不同管径和切割速度条件下的切缝宽度、切割前沿及其相邻基材的温度场和热影响区大小。

The results showed that with the increasing of repetition frequencies, power density, and pulse width of laser beam and with the decreasing of scanning speed, the kerf quality could be improved. Besides, a formula of estimating the kerf surface roughness was also presented, which can explain the experiment results well.

在加工电子行业中表面组装用的模板时，一般采用化学刻蚀法，其缺点是加工精度低、工序多、周期长，特别是受刻蚀因子的限制，模板的最小缝隙宽度不能低于模板厚度的 1 2 ，因而难以满足日益发展的微电子技术对电子线路制作精度的要求。

With longger fruit and more key fruits,moreover, the two traits showed significantly positive correlation (r=0.888). Of the 11 floral and fruit quantitative traits, the length and width of perianth segment and 6 other traits were different significantly among the three groups,which were successfully used in group-discrimination by means of the method of principal component analysis.

在所研究的11 个花果数量性状中，花被片长度和宽度等10 个性状在三大类群间差异极显著，主成分分析结果表明第1 主成分(贡献率69.11%)综合了各性状的主要信息，依据第1 主成分可以对三大类群进行区分，其中北美鹅掌楸类群第1 主成分值最大(变幅0.7156～1.3916，平均1.0408)，杂交鹅掌楸类群(变幅-0.0865～0.3959，平均0.2646)居于两个亲本类群之间，鹅掌楸类群(变幅-1.5443～-0.8855，平均-1.2426)最小。

All input and output bore aiameter,length and width of keyway can be machined with user's requirements.

订货：所有传动形势的输入与输出孔径大小，长度及健槽尺寸均按用户要求加工。

The kinetic theory based two-fluid model was used to simulate 2-dimensional fluidized beds with the width of 0.2 m, 0.4 m and 0.8 m,respectively, covering regimes from bubbling to turbulent fluidization.

应用基于颗粒动理学的双流体模型系统地对床宽分别为0.2、0.4、0.8 m的二维流化床在鼓泡区和湍动区的气固两相流动行为进行数值模拟。

This design proposal is the prestressed reinforcement concrete conatant cross-section box shape continuous bridge, Main span disposal is 45+45+45m, the bridge floor width is 28m, the king post uses is the single box single room.

本设计方案为预应力钢筋混凝土等截面箱形连续梁桥，主桥布置为45+45+45m，梁桥面宽28m，采用单箱单室梁。

Don not attempt to do something which you can not to do.

不要企图做那些办不到的事情。

The expression of CTGF and TNF-αweredetected by immunochemistry and the number of Clara Cells was calculated.

光镜下观察肺组织的病理变化，采用免疫组化染色观察肺组织中结缔组织生长因子和肿瘤坏死因子-α的表达和Clara细胞的数量。