查询词典 width

The influences of injecting current, pulse periods, and pulse width are discussed.

对注入电流，脉冲周期和宽度的影响进行了分析。

The adjustments of current pulse width and frequency are achieved by using SMC and CPLD.

介绍了激光二极管脉冲驱动源的控制技术。

This paper analyzes the deviation of cambered form witch is composed of batten and sheet in concrete construction,and then educes a relationship between width of sheet,deviation of cambered form and curvature radius of camber,in order to solve the problem of assemble spline form work and increase construction quality of concrete curved surface.

分析了用板条和铁皮组装而成的曲面模板在曲面混凝土施工中的误差情况，同时给出了施工中板条宽度、曲面误差、曲面曲率半径之间的关系，以解决好拼装样条模板的问题，从而提高混凝土曲面的施工质量。

A simplified method was proposed to deal with the boundary condition at the turbine unit for transient calculation. This method is based on the statistical analysis of turbine hill chart and the Eular equation for water turbines. According to the Eular equation, the basic geometry parameters of the turbine, such as guide vane opening a, blade outlet angle β2, the relative blade width of outletb2, the relative height of wicket gateb0 and the relative turbine exit radiusr2 are obtained through curvilinear regression of the water turbine hill charts.

为解决目前水轮机过渡过程计算中确定水轮机边界条件时通常使用的外特性法和内特性法的不足之处，结合这2种方法的优点，提出一种在水轮机过渡过程计算中处理水轮机边界条件的方法，即根据综合特性曲线的数据，利用统计分析方法和水轮机基本理论公式，计算水轮机基于内特性解析方程的基本参教，如出流角α、转轮出口安放角β、转轮出口相对宽度b2、导叶相对高度b0、转轮出口相对半径r2，在特性曲线上的规律。

After treatment the changes of dental arch width in first and second premolar region were larger than that of cuspid and first molar regions.

上颌第一、二双尖牙间各自宽度较尖牙间、一磨牙间宽度增加显著。

Writer analyzed some process parameters affectmachining quality, including cutter, cutting dosage (federate, cutting deep, cutting width), advance and retract mode, finish machining row distance, cut mode, cut step excess and deviation etc.

作者对影响加工质量的一些工艺参数，包括刀具、切削用量(进给率、切削深度与宽度)、进退刀方式、精加工行距、走刀方式、工步余量与偏差等进行了分析，并对影响这些参数选择的因素进行了综合分析，得出了理想的选择方案和确定原则。

Lettering means: Heat turns imprint means (300dpi) displays screen: LCD liquid crystal shows: 64x132 prints rate like element: 25mm/ second 10.0mm/ second the biggest length that print: Bushing: 20 meters, label paster: 5Rice inputs character at most: Dimension of 2000 character font: 2, 3, 4, 6mm Gao Ke uses label measure: Paster width 5, 9, 12mm bushing cut mode: Cut automatically partly, the hand moves cut interior to remember a capacity comple

印字方法：热转印方法(300dpi)表明银幕：LCD液晶表明：64x132分辩率复印速率：25mm/秒10.0mm/秒最大复印长度：套管：20米，标记帖纸：5米至多输进字节：2000个字节书体大小：2，3，4，6mm高可用标记大小：帖纸长度5，9，12mm套管切分方式：自行半切，手动全切里面回忆容积：40，000个字节(20字节x100组x20数夹)供给电源：DC：12V，1.3A电源耗损最大20W控制周围的环境：慑氏15to35度外型大小：286x287x95mm质量：2斤

Whatever system of dewing is used, the piece shouid afterwards be allowed to stand overnight in cuttle form, that is, loose transverse folds open-width, so that the moisture may be absorbed evenly.

无论是否使用给湿系统，布匹事后都以折叠或者松散的横向折叠的形式放置一晚，使水分可均匀吸收。

By extending the VBG external cavity length, and inserting a convex cylindrical lens between external cavity and LDA for transmiting. Phase-locked of external cavity is achieved by tilting of Bragg Grating external cavity. Experiment studied the stability of the in-phase mode far-field output at 35A. Wavelength is locked at 802 nm. The Full-Width Half-Maximum of locked specrum narrowed to 0.2 nm and the corresponding far-field divergence angle is 1.8 mrad.

通过拉长VBG外腔腔长，在VBG外腔和LDA中间插入平凸柱面透镜，采用偏转体布拉格光栅外腔进行外腔锁相研究，在注入电流35A时，获得稳定的同相单瓣模远场输出，波长锁定在802nm，中心主瓣峰值半宽压窄到0.2nm，对应的远场发散角为1.8mrad。

The laser beam emitted by the laser is expanded to the cutting width required by the tipping paper via the laser beam expanding system, the expanded laser beam passes through the cylindrical surface focusing mirror and 4 focuses on the focal plane form a focal line and the tipping paper is cut off by the focal line on the focal plane.

由激光器发出的激光束经激光扩束系统将激光束扩大至水松纸所需的切割宽度，经扩束后的激光束通过柱面聚焦镜，在焦平面4聚焦形成一条聚焦线，水松纸在焦平面上被此条激光聚焦线割断。

Don not attempt to do something which you can not to do.

不要企图做那些办不到的事情。

The expression of CTGF and TNF-αweredetected by immunochemistry and the number of Clara Cells was calculated.

光镜下观察肺组织的病理变化，采用免疫组化染色观察肺组织中结缔组织生长因子和肿瘤坏死因子-α的表达和Clara细胞的数量。