查询词典 van load

Using the concept of load vector and load unbalance index in the grid, the product block scale and the release are adjusted for the semiconductor manufacturing line.

利用网格计算中的负载向量和失衡因子的概念，来控制半导体生产线上各加工机器处工件块的规模以及投料规模。

Round the actual weight is loaded through the load bearing axle parts, such as the role of the body in the weight-bearing load of the central hole roulette wheel, the weight-bearing pressure rim round the bottom of rubber board in the track.

负重轮的实际受载情况是负重轮轴通过轴承等零件将车体载荷作用在负重轮轮盘的中心孔上，负重轮下方橡胶轮缘压在履带板上。

The results showed that the two synthesized compounds have good thermal stability; two synthesized compounds as additives in 5 cst possess rather good antiwear property and load-carrying capacity, and the antiwear ability of the additive loma is stronger than that of the additive boma; there is a pronounced synergism between the additives loma/boma and zddp in terms of the anti-wear property and load-carrying capacity.

发现两种化合物有很好的热稳定性；两种化合物作为润滑油添加剂在5 mm2/s基础油中有相当好的抗磨性能和承载能力，其中含有三嗪环的抗磨添加剂比不含三嗪环的抗磨能力好；两种抗磨添加剂均与zddp有很好的协同抗磨减摩作用。

The article finally through analyzing of the Zhejiang YiwuBinwang bridge temperature load, obtained the CFST arch bridge temperature stress rules with the temperature load which is including from top to bottom and from margin to core of arch-rib when the temperature value、 steel pipe wall thickness value and marking value of concrete change. The rule is that the axial force、 bending moment, as well as the shearing force elevates along with the change of temperature increases, so the control section stress which is linear relationship is. The article further proved the change of steel pipe wall thickness and marking value of concrete is not remarkable influence on temperature stress and internal force of arch ribs control section.

文章最后通过对浙江义乌宾王大桥温度荷载分析，得出了在由上至下和由周边向核心呈梯度变化的温度荷载作用下钢管混凝土拱桥结构应力随温度值、钢管壁厚值和混凝土标号值变化时的规律，即：轴力、弯矩以及剪力随着温度变化值增大而增大；钢管混凝土拱桥主拱肋的控制截面应力值亦随之增大，基本呈线性关系；并通过计算论证了拱肋各截面应力、内力值同钢管壁厚的变化、核心混凝土标号变化无关。

Based on a bounding surface model of the concrete and elastic-plasticity constitutive relationship of steel, this paper establishes the finite element model of the self-stressing concrete filled steel tube short column under axial load and eccentric load. the mechanical performances are analyzed.

对本课题组共进行的37根轴压短柱的试验结果分析，采用分解分析的方法，回归出钢管自应力免振混凝土轴压结构核心混凝土的等效单轴本构关系，与传统的弹性、塑性、断裂、损伤等力学模型相比具有简单实用的特点，便于进行工程计算。

In this paper, single phase bridge controlled rectifier circuit with resistance load and with resistance and inductance load had been simulated and analyzed in MATLAB.

本文使用MATLAB软件对带电阻负载和带阻感负载的单相桥式全控整流电路进行了仿真分析。

Of the UPS output load should not be with SCR, thyristor rectifier bridge or half-wave rectifier load

4在 UPS 的输出端不宜带可控硅负载、可控硅桥式整流或半波整流式负载

As the development of our country's national economy and the highway transportation business , the highway transportation appeared the characteristics of "heavy load, great flow and canalization traffic", heavy trucks and overload vehicles'number are rising,it caused a sharply increase in the times of actual total amount of standard axle load.

长安大学，道路与铁道工程，2008年，博士随着我国国民经济和公路运输事业的告诉发展，公路运输出现了"重载、大流量和渠化交通"的特点，重型货车及超载车辆急剧上升，引起实际累计标准轴次的急剧增加。

If the DC load is very demanding of a smooth supply voltage, a 稳压器 may be used either instead of, or in addition to, the capacitor-input filter; this serves both to remove the last of the ripple and to deal with variations in supply and load characteristics.

是否要求非常严格的顺利供应电压直流负载而不是或除了到电容输入筛选器，就可使用一个稳压器；这是同时删除纹波的最后一个，应付供应变化和负载特性。

The Wrap Pack II is a fully automatic Wrap-Around Caser, which will accumulate the product, load the accumulated pattern onto a flat corrugated blank, form the blank around the load and seal it into a shippable container.

Wrap Pack II 是一款全自动化的卷绕的包装机，累积产品，装在存储样品到缩成皱纹的扁坯上，在装载物周围形成半成品，然后将它封在可运输的集装箱内。

There are different types of personal loans available.

有许多不同类型的个人贷款优惠。

The above mentioned teaching model of spiral rising can be used to avoid rigidness in teaching.

上述螺旋式上升的教学模式，可以避免教学形成模式後的僵化现象。