查询词典 universal coefficient formula

Then, it is pointed out that grey interval incidence coefficient formula is an improvement of classic grey incidence coefficient formula, while the method for grey interval clustering decision is generalization of method for classical grey clustering decision.

灰色区间关联系数公式是经典灰色关联系数公式的推广，而灰色区间聚类决策是经典灰色聚类决策方法的拓展。

Firstly, introduce a method based on ideal project for grey interval clustering decision together with some relational concepts, which consist of incidence coefficient formula and relative incidence coefficient formula for interval grey numbers.

提出了基于理想方案的灰色区间聚类方法及其相关概念，建立了灰色区间关联系数公式和灰色区间相对关联系数公式。

Angular spectral is spectral value map formed by estimating semblable coefficients of fast and slow shear wave or the variation of amplitude ratio of fast and slow shear wave with times and angles at a specified space point based on semblable theory of fast and slow shear wave, the angle value of this space point at a given time can be got by picking the maximum of angular spectral; the study reveals that fast and slow shear wave with different polarization direction should be separated using different rotation formula, eight formulas of separating fast and slow shear wave using clockwise rotation and counterclockwise rotation have been derived, and gained energy assignment rule and phase coincidence rule, in real data estimation, the rotation formula used for separating fast and slow shear wave can be uniquely determined on the two discriminating rules. On the basis of semblable theory of fast and slow shear wave, the delay time corresponding to the maximum of semblable coefficients at a specified point in a given time window is the delay time of fast and slow shear wave, delay time section of fast and slow shear wave can be got by moving space point and smoothing time window. The vertical variation values of delay time of fast and slow shear wave reflect the effect degree of vertical fractured reservoir on fast and slow shear wave which is defined as anisotropic coefficient, and section map of anisotropic coefficient can be obtained.

角度谱就是利用快慢横波的相似性原理，在某一空间点求出快慢横波的相似系数或快慢横波的振幅比值随着时间和角度的变化而形成的谱值图，拾取其极大值就得到该空间点某一时间的角度值；在研究中发现分离不同偏振方向的快慢横波应该采用不同的旋转公式，推导出了利用顺时针旋转和逆时针旋转分离快慢横波的八个公式，并给出了能量分配准则和相位一致性准则两个判别准则，在实际计算中利用这两个判别准则能唯一地确定分离快慢横波的旋转公式；根据快慢横波的相似性原理，在某一给定点和给定时窗内最大相似系数对应的延迟时间就是快慢横波的延迟时间，随着空间点的移动和时窗的滑动就可以得到快慢横波延迟时间的剖面图；快慢横波延迟时间与慢横波传播时间的比值定义为裂缝密度，并求出了裂缝密度剖面图；快慢横波延迟时间纵向上的变化值的大小反映了纵向上裂隙层对快慢横波影响的大小，定义为各向异性系数，并求出了各向异性系数的剖面图。

By using the direct distillation principle, an improved and quick method which can determine the protein content in maize, soybean meal, rapeseed meal, fish meal, wheat bran, formula feed for swine and formula feed for chicken was established. The result of the study on 142 products belonging to 7 kinds of feedstuffs in three laboratories suggested that: the DD method has fine correlation with the National Standard Method. The relative deviation of the two methods was in conform to the National Standard. The coefficient of variation between different laboratoies was lower than 3%, the coefficient of variation within single laboratory was lower than 2%.

利用直接蒸馏法原理，经研究改进而建立的快速测定玉米、豆粕、菜籽饼、鱼粉、麸皮、猪配合饲料、鸡配合饲料蛋白质含量的新方法。3个实验室对7种类型142个饲料产品的研究结果表明，本法与国标法有很好的相关性，两法测定值相对偏差均达到国家标准规定的要求。

The formula was established about calculating design parameters and technological parameters of ideal strip and bent strip in the period of forming. The thesis presented how to calculate the deformed area length and contact are radius of contact deforming between two elastic bodies on condition of the friction. The calculating formula of pinch force about plate-strip pinch mill was given and the results were analyzed that friction coefficient and radius of pinch rolls are very important for determining pinch force. Moreover, the rule of deforming and stress distribution of different 〓 ratio were gained on condition that the deforming was considered to be non-uniform distribution in the gap. The differential equations were got that calculate the displacements of large deflection of elastic cantilever rectangle plate with fixed end and the formula of the Finite Strip Method was conducted to study the regularity of mid-plane displacements, deformation and stresses for elastic-plastic large deflection bend of cantilever parallelogram plate with fixed or slidable end by integrating Prandtl-Reuss equation.

建立了一套完整的设计参数计算公式和在成型过程中理想带钢或具有月牙弯带钢的工艺参数的调整公式；在考虑摩擦力的条件下，对两弹性体接触变形过程中的接触变形区长度和接触弧半径用位移解法进行了研究，推导了板带递送机的递送力计算公式，从而得知在递送机设计过程中，应选择适当摩擦系数和辊身直径；另外，还从辊缝内带钢实际变形出发，分析了对于不同的〓值，带钢的变形规律及应力分布状况；建立了固定端悬臂矩形板弹性大挠度弯曲变形的控制方程，并且在对Prandtl-Reuss方程的积分处理的基础上，导出了固定端和滑动端悬臂平行四边形薄板的弹塑性大挠度的中面伸展位移、变形和应力的有限条元法公式，编写了Fortran语言计算程序，在各种参数条件下，对螺旋焊管成型过程变形规律进行了全面的分析研究，从而为螺旋焊管的生产和进一步的改进提供了理论依据。

In this paper, after taking over coupling effect between electronic spin and orbital angular momentum, to revise the formula of electronic angular momentum in Bohr's theory, and electronic speed formula is obtained in a single-electron system, and to correct the energy level formula of atomic orbit in Schr? dinger's method by relativistic effect, the theoretical improving formula is built for spectrum fine splitting calculation, the calculated values are in good agreement with experimental ones, and reflect changing law of spectrum fine splitting values.

本文在考虑了电子的自旋角动量与轨道角动量的耦合作用后，通过对Bohr理论中的电子运动角动量的修改，推导出单电子体系的电子速度公式，结合对Schrdinger的原子轨道能级表达式相对论效应修正，从而得出本文的氢及类氢离子光谱精细结构值的理论计算公式，应用此改进公式，所得的计算值与实验观测值符合得很好，计算结果也反映了氢及类氢离子光谱精细结构数据变化的规律性。

METHODS: C57BL/6J mice (15/group) were respectively received mash as AIN-93G formula, or 1% cholesterol supplemented AIN-93G formula, or 1% cholesterol and 14% long chain triglyceride rich in myristic acid supplemented AIN-93G formula, or 1%cholesterol and 14% MCT (caprylic acid/capric acid: 3/1) supplemented AIN-93G formula for 6 weeks.

分别用AIN-93G配方饲料，含1％胆固醇的AIN-93G配方饲料，含1％胆固醇和14%富含豆蔻酸的长链甘油三酯的AIN-93G配方饲料，含1％胆固醇和14％的中链甘油三酯的AIN-93G配方饲料喂养C57小鼠6周，每组15只。

By academic analyzing, it is concluded that two order discrete paraxial approximation formula of the paper, multiple transmitting formula and polynomial extrapolation formula are the different forms of continuous paraxial approximation formula, so they are with nearly equivalent precision and stability and with equivalent applicability and limitation.

据此文献[3]将傍轴近似公式归结为一类从特定的无限域模型导出的人工边界条件，并且提出了新的从一般无限域模型导出的具有普适性的、称为"多次透射公式"的局部人工边界条件。那么，是否也可以从一般无限域模型导出具有普适性的傍轴近似公式呢？

Combining Inclusion-Exclusion principle with Disjoint Sum of products formula,the new formula contains terms which correpond one by one to a class of special subnetworks. For a given newtork,terms of new formula are fewer than those of corresponding stryanarayna formula. Finally,an example illustrates our conclusion.

该公式本质上是将容斥原理公式和不交和公式融合在一起，公式中各项和网络的一类特殊子网络一一对应，与相应的Satyanarayanna公式比较，该公式包含更少的项和更少的算术运算，并给出一个算例验证上述这个结论。

Lagrange interpolation focus on the application of the formula .The comparison between the method of Transform and that of Lagrange's interpolation formula in square matrix form is made. Also the form of Lagrange's interpolation formula is generalized to include the double root case.The application of the generalized lagrange's interpolation formula in square matrix to solving state equations is found to be effective.

重点介绍了Lagrange插值公式在状态方程求解中的应用，用对角矩阵及相似矩阵的性质证明了，当状态转移矩阵中方阵的特征根相异时，拉格朗日插值公式与Laplace变换法对表达具有一致性，并用极限方法对方阵含二重根时拉格朗日插值公式的应用进行了推导。

This matter overthrew all basises I learned from Sunday school .

这件事把我从周日学校学到的所有道理都颠覆了。

It's one of the cruel ironies of aging: if you want to remember your favorite restaurants, the less you should eat at them.

这是一个老化的残酷讽刺：如果你想记住你最喜欢的餐馆，你应该更少吃到它们。