查询词典 ultimate tensile strength

Test results show that, with the addition of polyvinyl acetate, the compressive strength and compressive modulus of mortar decrease distinctly, but the ultimate strain increases significantly. The uniaxial tensile strength and bending strength increase a little, but the tensile peak-strain and the ratio of tensile-compressive and bending-compressive increase remarkably.

试验结果表明，随着聚醋酸乙烯的掺入，砂浆的轴压强度和弹性模量显著下降，但极限应变却明显增大；砂浆的轴拉强度和抗弯强度均略有提高，而极限应变、拉压强度比和弯压强度比则显著增加。

At the same time the use of higher-strength concrete does not greatly increase the ultimate tensile strain.

同时高强度混凝土的使用并未使极限抗拉强度得到很大提高。

The results showed the maximum cyclic stress of CFRP bar should be under 70 percent of ultimate tensile stress; when the maximum cyclic stress decrease 5 percent of ultimate tensile stress, the fatigue life of CFRP bars increase generally 10 times; with the decrease of cyclic ratios, the fatigue life of CFRP bars decrease heavily; for the brittleness, CFRP bar should possess a higher reserve of strength, the margin of safety against failure is a necessity; according to experimental cyclic stress-fatigue life curve, the fatigue behavior of CFRP bar is much better than the fatigue behavior of Q235 steel.

将纤维复合材料用于土木工程结构的研究成果，已应用于实际工程【2j_国外对CFRP筋的一些短期性能以及CFRP筋构件的粘结性能、CFRP加筋混凝土结构的抗弯性能等都做了大量的研究，但对其长国家自然科学基金50278029，50538020和交通部西部交通科技200l431882021资助项目。2OO6年2月13日收到初稿；2006年9月4日收到修改稿。本文联系人：欧进萍，院士期性能如疲劳性能的研究还不够

Another six specimens of each group was obtained for biomechanical test at 8 weeks. RESULTS: There were no significant differences between control group and fibrin group. In bFGF group compared with control and fibrin groups, appearance of the angiogenesis, fibroblast proliferation and collagen production in the sheath, epitenon and parenchyma at repair site occurred earlier and were more in quantity, the gliding excursion of the tendon was shorter, and the work of flexion and the ultimate tensile strength of the tendon were greater.

结果：对照组与纤维蛋白封闭剂组间各项观测指标比较均无显著性差别，与对照组和纤维蛋白封闭剂组相比，bFGF组修复部位腱鞘、腱外膜及腱实质的新生血管形成、成纤维细胞增殖较好，胶原的分泌出现早，数量也较多；肌腱滑动距离较短，屈曲功和肌腱最大抗拉力较大。

Totally 60 semi-circular bending specimens cored from superpave gyratory compactor with three groups of notch depths are tested at the temperature of-10 and 20℃ The experimental results reveal good repeatability in EAM characterization. The tensile strength ratio of SCB to the indirect tensile test is at a range of 1.4 to 1.7, and the ultimate strength of EAM is exponentially dependent on the notch depths. At the test temperatures, the critical J-integral value of EAM is much higher than that of hot mix asphalt with thermoplastic asphalt binder. The response mode of EAM changes from ductile mode to brittle mode and the fracture energy increases 30% when temperature decreases from 20 to-10℃, while its critical J-integral value decreases only 15%.

结果表明，环氧沥青混合料的半圆弯曲试验结果复现性好；由非切口试件的半圆弯曲试验与标准间接拉伸试验所测得的环氧沥青混合料的抗拉强度，其比值在1.4~1.7之间，且SCB抗拉强度与切缝深度指数相关；在20℃与－10℃试验条件下，环氧沥青混合料具有比热塑性HMA高得多的临界J-积只分值；当温度由20℃降至－10℃时，环氧沥青混合料的响应模式由延性变为脆性，断裂能增加30%，而临界J-积分值下降15%。

The material properties (ultimate yield strength, tensile yield strength, Kapp) and major performance attributes (fatigue crack growth, fracture toughness, static strength) of alloy 2199 wide-sheet and plate products also have contributed to their increased use.

2199合金宽板和金属板的物料性质（包括最终抗屈强度和抗拉屈服强度）和主要性能（包括疲劳裂缝增长，断裂韧度和静力强度）增强了产品耐用度。

The results show that the microstructure of the cladding wire by drawing at room temperature is vimineous grain as fibril shape from prime equiaxed grain. The fibril diameter is in inverse proportion to deformation and the fibril length is in direct proportion to the square of deformation approximately. The ultimate tensile strength of the cladding wire by drawing at room temperature goes up in direct proportion to square root of deformation, whereas the elongation decreases and fluctuates.

结果表明：显微组织自原始的等轴晶变为细长条纤维状，纤维直径与形变量近似地成反比，纤维长度与形变量的平方近似地成正比；经室温拉变形的铜包铝线的极限抗拉强度随形变量增大而增大，与形变量平方根呈直线关系；延伸率随形变量增大逐渐降低，但延伸率波动较大。

When the frequency is 15Hz and number of ampere turns is 20kA·turn, relative intracrytalline solubility of alloy elements (for Zn, Mg and Cu the solubility are 68.8%, 76.0% and 45.0％, respectively) is the highest; when the frequency is 15Hz and number of ampere turns is 20kA·turn, Vicker hardness is the highest of Hv160; when the frequency is 25Hz and number of ampere turns is 20kA·turn, ultimate tensile strength is the highest of 324MPa.

频率为15Hz，安匝数为20kA·turn时， Zn、 Mg和Cu元素相对溶质固溶百分数最高，分别为68.8%、 76.0%和45.0％；频率为15Hz，安匝数为20kA·turn时，锭坯维氏硬度最高为Hv160；频率为25Hz，安匝数为20kA·turn时，抗拉强度最高为324MPa。

The paper is concerned with the variation of corrosion weight loss and ultimate tensile strength of 18Ni (350) maraging steel and 7075 aluminium alloy at 120℃, 90℃, 60℃ and room temperature under UF 6 pressure of 13 kPa.

研究了国产18Ni（350）马氏体时效钢和7075铝合金在不同温度及UF6压力为13kPa条件下，腐蚀失重、抗拉强度随时间变化的规律。

Longer fatigue life is the key point for spring steel with ultimate tensile strength of 2 000 N/mm2 grade.

提高齿轮钢的强度需要改善其抗疲劳性能；1200N/mm2螺栓钢和2000N/mm2弹簧钢的强度需要改善抗延迟断裂性能和抗疲劳性能；提高微合金非调质钢的强度需要改善其韧性。

Further more, the simplified analysis method on stressed-skin effect of corrugated steel sheet is also discussed in detail.

此外还比较详细地探讨了蒙皮效应的简化分析方法。

If I had known her telephone number,I would have called her.

要是我知道她的电话号码，我就打电话给她了。