查询词典 torque spanner

By the effectively controlling the twist torque of the suspended rope to realize the CMG unloading control in real time, it is ensured that the CMG attitude control system can be stably controlled continuously and successfully.

CMG参数的选择考虑是整个CMG机械设计的依据。由于双子型CMG本身的结构特点和BST的要求，其控制回路的补偿设计是必要的。

For the SSR in transmission system,the complex torque coefficient approach based on time domain simulation is used to analyze the influence of different degrees of series compensation and generator putout on the SSR.

针对输电网中串联电容补偿引发的次同步谐振，采用基于时域仿真实现的复转矩系数法分析不同发电机出力以及不同串联补偿度对系统次同步振荡的影响。

The subsynchronous oscillation characteristics of a synchronous machine connected to a static VAR compensator is studied with the complex torque coefficient method realized by time domain simulation, and some important conclusions are obtained which can guide the design and operation of SVCs to avoid SSO problem.

4基于时域仿真实现的复转矩系数法，对与静止无功补偿器SVC相联接的同步发电机组的次同步振荡特性进行了深入的研究，得出了一些重要结论，可为SVC的设计和运行提供避免SSO的依据。

The friction performances of carbon face were investigated with an inertia friction tester. The torque curve of carbon face was ideal, the coefficient of static friction was lower than that of dynamic in 0.28 MPa, the friction coefficient of static and dynamic decreased with the braking pressure increasing. To the fiber face, the coefficient of dynamic friction of carbon face was more stable in cycle braking process, the wear rate was lower, and it was efficient to protect the couple plate not to be worn.

结果表明：碳质层的摩擦力矩在制动初期上升较快，中间过渡区平稳，尾部翘起较小；在制动压力小于0.28 MPa时静摩擦系数小于动摩擦系数，且动、静摩擦系数均随制动压力增加而减小；相对纤维层而言，采用碳质层摩擦时摩擦力矩曲线形态更好，连续制动时摩擦系数波动较小，磨损率低且能够有效保护偶件，是1种静/动摩擦系数比较低且适用于高载荷工况条件下使用的摩擦材料。

With increasing temperature of separate plate,shapes of friction torque became dissymmetrical,and dynamic and static coefficient of friction declined in this process.

以自制炭纤维增强纸基摩擦材料和45#钢为摩擦副，采用惯量试验方法研究了温度对摩擦副摩擦性能的影响。

The friction performances of carbon face were investigated with an inertia friction tester.The torque curve of carbon face was ideal,the coefficient of static friction was lower than that of dynamic in 0.28 MPa,the friction coefficient of static and dynamic decreased with the braking pressure increasing.To the fiber face,the coefficient of dynamic fric...

结果表明：碳质层的摩擦力矩在制动初期上升较快，中间过渡区平稳，尾部翘起较小；在制动压力小于0.28 MPa时静摩擦系数小于动摩擦系数，且动、静摩擦系数均随制动压力增加而减小；相对纤维层而言，采用碳质层摩擦时摩擦力矩曲线形态更好，连续制动时摩擦系数波动较小，磨损率低且能够有效保护偶件，是1种静/动摩擦系数比较低且适用于高载荷工况条件下使用的摩擦材料。

In practical production, dynamic torque was calculated and compensated, so that tension of coiler was stable and operation was reliable, thin strip breaking has been eliminated, and yield was improved.

实际生产运行表明，采用该方法对动态转矩进行计算并补偿后，卷取机张力稳定，运行可靠，克服了以往薄带容易断带的现象，提高了成品率。

It produces a colossal 500 PS and 1,000 Nm of torque.

它产生一个巨大的500 PS和1000 Nm的扭矩。

Close discharge valve, the need to open and close with the Coma Berenices two pieces formed between the sealing suce sealing certain specific pressure, while also overcoming the stem and the packing between the stem and the nut thread between the stem end Department and other friction parts bearing friction, and must exert a certain degree of closing force and closing moments, PUMP CONTROL VALVE EN700X the valve in the open and close the process, the required hoisting hoisting force and torque is the change, Its maximum is in the closed or open end of the initial transient instantaneous.

关闭放料阀门时，需要使启闭件与发座两密封面间形成一定的密封比压，同时还要克服阀杆与填料之间、阀杆与螺母的螺纹之间、阀杆端部支承处及其他磨擦部位的摩擦力，因而必须施加一定的关闭力和关闭力矩，阀门在启闭过程中，所需要的启闭力和启闭力矩是变化的，其最大值是在关闭的最终瞬时或开启的最初瞬时。

Department of Internal Combustion Engine Engineering, JilinUniversity, Changchun 130025, ChinaAbstract: Combustion parameters were studied from a turbocharged inter-cooled diesel engine under constant speed and increasing torque operating conditions with combustion analyzer.

为了研究车用增压柴油机瞬态工况下燃烧参数的变化规律，利用燃烧分析仪在试验台上研究了恒转速变转矩瞬态工况下，油门开度变化率对燃烧参数的影响规律。

Panorama Many people are dancing in a large sitting room.

在一个大客厅里，许多人在跳舞。

We fully understand how a microwave oven cooks food, it is first necessary to talk ...

我们充分理解一个微波炉煮的食物，这是首先要谈。。。