查询词典 thickness

Variance and correlation of the data was analyzed with SPSS software. It was found that height, width, and thickness are main factors influencing paper angle bead compressive strength; moreover there are linear relations between the height, the width, and the thickness of paper angle bead and the compressive strength, and the error of equation is ±3%.

通过SPSS软件对数据进行方差及相关性分析，确定了纸护角的高度、宽度、厚度是影响纸护角抗压性能的主要因素，并且高度、宽度、厚度值与纸护角抗压强度之间呈线性相关；最后利用SPSS的线性回归分析，得到纸护角的抗压性能与高度、宽度、厚度之间的线性回归方程，对方程进行验证，其误差为±3%。

According to the method of determining the safe thickness of arch ring which is reinforced by adding a new arch ring,this paper proposes a method for determining the thickness of inner arch ring under the arch bridge.

参照拱圈上增设拱圈叠合受力加固法新设拱圈厚度的确定方法，对拱圈下内套拱圈厚度的确定提出设想，对拱圈安全厚度提出建议和确定方法。

The metal backing must be of sufficient thickness to aoid fatigue failure, and there must be a corresponding decrease in thickness of the polyethylene liner for a component of any gien outer diameter.

金属外壳须有足够厚度才能防止疲劳损坏，因而外径固定的聚乙烯内衬其厚度就需相应地减少。

Using theory of strength of track structure and vehicle-track coupling vibration dynamic model, we analyze the effects the different thickness of ballast act on relevant track structure parts and deduce the rational thickness of ballast.

本文应用轨道结构强度计算理论及车辆－轨道耦合振动动力学仿真计算模型，分析了不同道床厚度对相关轨道结构部件的影响，得出了合理道床厚度的建议值。

First according to the hydraulic pressure elevator system diagram, use the machine design and hydraulic transmission knowledge calculates the diameter of the plunger, cylinder tube wall thickness as well as cylinder bottom thickness; second, through the examination confirmation to the obtained result to complete the work of cylinder design; Simultaneously has carried on the component choice and the computation; Through to the system calorific capacity computation the and the volume of cooling water while the fuel tank cools when needs to complete the hydraulic pressure elevator fuel tank design; Based on the system oil stream condition to calculated the tube internal pressure lose, the local pressure loss as well as the all of the pressure lose to carried on the system checking calculation; Finally through the consult correlation design handbook to calculation and examines the belt, the band pulley, the axis, as well as the key, has completed the hydraulic pressure elevator pumping station transmission system design.

首先根据液压电梯系统原理图，利用机械设计与液压传动等方面的知识计算出柱塞的直径、缸筒的壁厚以及缸底厚度，并对所得结果进行校核验证完成了工作油缸的设计；同时进行了元件的选择和计算；其次，通过系统发热量的计算和油箱冷却时需要的冷却水量的计算完成了液压电梯油箱的设计；依据系统油流状态计算出管内压力损失、局部压力损失以及总压力损失进行了系统的验算；最后通过查阅相关设计手册对带、带轮、轴、以及键进行设计计算和校核，完成了液压电梯的泵站传动系统的设计。

Firstaccording to the hydraulic pressure elevator system diagram, usethe machine design and hydraulic transmission knowledge calculatesthe diameter of the plunger, cylinder tube wall thickness as wellas cylinder bottom thickness; second, through the examinationconfirmation to the obtained result to complete the work ofcylinder design; Simultaneously has carried on the component choiceand the computation; Through to the system calorific capacitycomputation the and the volume of cooling water while the fuel tankcools when needs to complete the hydraulic pressure elevator fueltank design; Based on the system oil stream condition to calculatedthe tube internal pressure lose, the local pressure loss as well asthe all ofthe pressure lose to carried on the system checking calculation;Finally through the consult correlation design handbook tocalculation and examines the belt, the band pulley, the axis, aswell as the key, has completed the hydraulic pressure elevatorpumping station transmission system design.

首先根据液压电梯系统原理图，利用机械设计与液压传动等方面的知识计算出柱塞的直径、缸筒的壁厚以及缸底厚度，并对所得结果进行校核验证完成了工作油缸的设计；同时进行了元件的选择和计算；其次，通过系统发热量的计算和油箱冷却时需要的冷却水量的计算完成了液压电梯油箱的设计；依据系统油流状态计算出管内压力损失、局部压力损失以及总压力损失进行了系统的验算；最后通过查阅相关设计手册对带、带轮、轴、以及键进行设计计算和校核，完成了液压电梯的泵站传动系统的设计。

The test results demonstrated that the peeling with incisor bar could reduce green veneer curl-up ratio over 60% compared with the smooth roller bar, and generate more even veneer thickness and less veneer thickness variation than the smooth roller bar.

结果表明：采用柔化辊旋切的单板的湿单板卷曲率比光滑压辊下降了60%，单板厚度较均匀，厚度偏差较小；柔化辊与光滑压辊的最佳旋切设置完全不同。

Spine-bulk: The thickness of the spine of a book block not including the thickness of the cover boards.

脊厚：书芯厚度，它不包括书皮纸板的厚度。

Spine-bulk: The thickness of the spine of a book block not including the thickness of the cover boards.

脊厚：书芯厚度，它不包括书皮纸板的厚度。肠壁薄，几乎是透明的，这可能是因绒毛萎缩。

Spine-bulk: The thickness of the spine of a book block not including the thickness of the cover boards.

脊厚：书芯厚度，它不包括书皮纸板的厚度。她一斧头把木块劈成两半。

It also analyzes the feature and development of semi-finish grinding and finish grinding by roller press.

同时进行了辊压机半终粉磨和终粉磨系统的特点和发展分析。

When I got there, water was dripping slowly from the ceiling and forming a pool on the floor.

当我到那里的时候，水是慢慢地从天花板滴而且形成在地板上的一个池。