查询词典 thickness

Lateral crus presented diamond-shaped or long strip,(16.21 ± 2.71) mm in length,(8.45 ± 1.72) mm in width,(1.09 ± 0.18) mm in thickness. Cephalic rim intersected lower edge of lateral nasal cartilage, and slightly covered the lower edge of the lateral nasal cartilage, so that the two were overlapped, but also only the intersection without overlapping. Lateral crus constituted the base of nasal wings. Narrow medial crus formed nasal tip and the frame of front nasal columella, showing posteroinferior curve or S shape,(13.06 ± 2.16) mm in length,(3.79 ± 0.58) mm in width,(1.02 ± 0.18) mm in thickness. The left and right medial crus in the middle were connected by connective tissue, and in the same way connected to the anterior margin of the lateral nasal cartilage.

外侧脚呈菱形或长条形，长(16.21±2.71) mm，宽(8.45±1.72 ) mm，厚(1.09±0.18) mm，头缘与侧鼻软骨下缘相交，并略覆盖侧鼻软骨下缘使二者部分重叠，也可仅相交而无重叠；外侧脚构成鼻翼大部的基础；内侧脚狭细，构成鼻尖和鼻小柱前部的支架，呈向后下的弧形弯曲或S形弯曲，长(13.06±2.16) mm，宽(3.79±0.58) mm，厚(1.02±0.18) mm；左、右内侧脚在正中线借结缔组织相连，并以相同方式连于侧鼻软骨的前下缘。

The phase and group velocities of Lamb waves in the aluminum plate related to the frequency and the thickness of the plate because of the material characters. However, for the carbon fiber composite lamina, the situation was of difference, in which the velocities were with regarded to the frequency and thickness as well as the propagational direction and the fiber orientation.

输入铝板和碳纤维板的材料参数，即可得出铝板和碳纤维材料单层板中Lamb波的频散曲线，铝板为各向同性材料，其中的Lamb波相群速度只与频率板厚的乘积相关，碳纤维板为各向异性材料，其中的Lamb波相群速度不仅与频厚积有关，还与Lamb波传播方向、碳纤维的铺层方向相关。

The other is to reduce the thickness of the rubber drum at the same time increase the thickness of plate gaskets, rubber blanket squeeze protrudent predeformation reduce, normal for the latter.

另一栽是减众橡皮滚筒厚度，同时补充印版衬垫厚度，则橡皮布挤不缩变形度减众，凡是常用后者。

The transition thickness is significantly dependent on the growth temperature and germanium content, and is always smaller than the critical thickness of pseudomorphic growth.

但是，当降低生长温度时，Ge〓Si〓在Si衬底上作二维生长的临界厚度可明显增加。

During CT scan,patients were in supine position, and the teeth in the middle of the contactposition on the jaw; and maintain a static head and body during the scanningprocess, did not swallow; measurement parameters including: soft palatelength, maximum thickness of the soft palate, pharynx lateral spacing, uvula length and base width of the free edge ofsoft palate to the throat wall spacing, velopharyngeal cross-sectional area,angina cross-sectional area,thickness of retropharyngeal wall.

随机对10例患者进行系统的腭咽CT测量，测量时间为术前、术后3个月、术后6个月；测量方法为：患者在清醒状态下进行平静呼吸时的上气道CT扫描，范围自听眶线至声门。利用CT工作站进行三维重建和测量。CT扫描时患者取仰卧位，牙齿处于正中颌的接触位上。

The mechanism of cohesion in the generation of ice rubble and ice ridging, the main factors arc demonstrated and analyzed elementarily. Considering three sea ice ridging process. the cohesion is set up as a function of initial ice thickness, total ice thickness, temperature and salinity, respectively. The theoretic expressions of sea ice cohesion were determined and to be introduced into the Mohr-Coulomb yield criterion.

考虑三种不同情况下的海冰堆积过程，将粘结力分别设为初始冰厚、当前堆积冰厚和海冰温盐的函数，分别建立了海冰粘结力的理论表达式，并将其应用到Mohr-Coulomb屈服准则中，建立了考虑粘结力影响的粘弹-塑性海冰动力学本构模型。

Infiltrates the level thickness to increase along with the temperature ascension, the time with infiltrates the level thickness the relations to throw satisfiedly.

渗层厚度随着温度的升高而增加，时间与渗层厚度的关系满足抛

Infiltrates the level thickness to increase along with the Temperature Test Instruments ascension, the time with infiltrates the level thickness the relations to throw satisfiedly.

渗层厚度随着温度的升高而增加，时间与渗层厚度的关系满足抛

A cortical pattern-matching method used 72 sulcal landmarks traced on each brain as anchors to align cortical thickness maps across subjects, construct group average maps, and identify areas with changed cortical thickness.

一种皮质层模式匹配得方法，使用了70sulcal标记物在每个大脑进行跟踪，锚着在不同受试者的系列皮质层增厚图谱上，创建组平均图谱，鉴别出皮质层厚度发生改变的区域。

Based on a computing model of floor heating residences, indoor thermal environment and heat distribution under the effect of heat charge/discharge, operation control and solar radiation has been concluded. Concept and formula of equivalent heat supply has been put forward which indicate that actual heat supply will be equal to the sum of design heat supply and equivalent heat supply. Recommend coefficient has been given taken Dalian as an example. Computed according to the new method, design heat supply can be reduced to 37% in cloudy day and 43.3% in sunny day, energy saving effect is very obvious. In Tromb wall solar house, effect of concrete wall on indoor temperature swing and attenuation of temperature wave is very obvious. While the outdoor air-temperature swing exceeds 10℃, indoor air-temperature swing belows 3℃. In the experiment, maximal difference in temperature between inner surface and outer surface of the 300mm wall exceeded 10℃. Heat storage and collector efficiency varies adversely according to solar radiation. Factors such as thickness, material, absorptance of the wall and permeation of the glass cover all have big influence on heat storage and collector efficiency. There exsisted an optimal thickness of the wall, which can make the best of heat storage and collector efficiency. Most of the heat stored in conventional Trombe wall during the daytime has been lost to the outside at night without heat preservation. Heat preservation on the outside surface of the wall has effectively improved heat release performance of the wall at night, heat supply to the room has increased too.

通过建立的地板采暖系统动态热性能分析模型，得出了在蓄放热特性、运行方式和太阳辐射等因素耦合作用下的室内热环境及热量分配比例，提出了等效供热量的概念及计算公式，指出实际所需供热量应等于设计供热量加上等效供热量，并以大连为例，给出了等效供热量的修正系数，以新方法计算，阴天可减少设计供热量37％，晴天最大可以减少设计供热量43.3％，节能效果显著；集热蓄热墙式太阳房中，混凝土蓄热墙的室温均一化效果和对温度波的削减作用非常明显，当室外温度波动最大幅度超过10℃时，室温波幅不超过3℃，实验中300mm厚墙体内外表面温差超过10℃；墙体蓄热效率与集热效率随太阳辐射照度的变化呈相反的变化趋势；墙体厚度、材料、表面吸收率以及盖板透过率等因素对集热和蓄热效率均有较大的影响，存在一个最佳的墙体厚度值，使得墙体集热和蓄热综合性能最优；传统的蓄热墙夜间没有外保温，辐射散热损失很大，研究表明墙体外保温方式明显改善了蓄热墙夜间的散热性能，增加了向室内的供热量。

So it was last week in Selma , alabama.

上星期在亚拉巴马州塞尔马市发生的事件也是这样一个转折点。

The group also spearheads various social programs in China.

该组织还带头参与中国的各种社会活动。