查询词典 thickness

Results The excellent rate of razor skin graft was 45.6% but the graft led to claw hands of different degrees, scar contracture and joint malformation; the excellent rate of flap graft was 100% with good function recovery and nice appearance; medium-thickness skin graft, full-thickness skin graft and composite skin graft showed out close results, the excellent rates were from 90% to 94%.

结果 刃厚皮片移植优良率45.6%，刃厚皮片移植术后，存在不同程度的"爪形手"、瘢痕挛缩、关节畸形等。皮瓣移植优良率100%，术后功能较好，外观优良。中厚皮片移植、全厚皮片移植及复合皮移植效果接近，优良率为90%～94%。

It was found that the resistivity of the TiO2, thin films deposited on Ti and Ti substrates increased non-linearly with the increase of the thickness of the films and varied in the range from conductor or semiconductor to nonconductor, respectively. The conducting layer thickness of the films deposited on different substarte materials is different and the films deposited on glass are nonconductors.

结果表明，沈积在Ti和Si基底上的TiO2薄膜的电阻率随著膜厚的增加而非线性增大，分别经历了导体、半导体到绝缘体或半导体到绝缘体的电阻率范围的变化过程， TiO2薄膜导电层厚度也不相同，沈积在玻璃表面TiO2薄膜为绝缘体。

1 Oven order 5.1.1 first hearth cloth Wind board laying 200mm thickness of the bed material; About Revert cloth laying Wind board thickness 200mm bed material, to prevent Ogive burn plug secondary air pipe; 5.1.2 prior to Add a small amount of flammable wood furnace and left and right back Feeder, ignition Wind Road in oven two days before ignition; 5.1.3 ignition started Ovens need to use a small amount of diesel added to the accumulation of wood, wood ignition when combustible, wood drying to around 200 ° C, according to adjust primer wind baffle and then curves of thermal insulation and heating.

5.1烘炉顺序 5.1.1先将炉床布风板上铺设厚度为200mm的床料；左右返料器布风板上铺设厚度200mm床料，防止把风帽烧坏，堵塞二次风管； 5.1.2事先将少量易燃木柴放入炉膛和左、右返料器，点火风道应在烘炉前2天进行点火； 5.1.3开始烘炉点火时需要用少量的柴油加在堆积的木柴上，点火时木柴易燃烧，木柴烘至200℃左右后，根据情况调节引风挡板，再按升温曲线保温、升温。

The results showed that exogenous substances could promote the upper leaf area increase, and accommodated the thickness of palisade tissues, spongy tissues and the cell density of palisade tissues dynamic changes, and decreased leaf thickness, loosen the tissue, and increased the potassium content, while reduced nicotine content.

结果表明，外源物质可促进上部叶面积增大，调节叶片栅栏组织、海绵组织厚度和栅栏组织细胞密度的动态变化，促使叶片厚度降低，组织变得较为疏松，促进钾素含量提高和烟碱含量降低。

The thickness of palisade tissue decreased, and that of spongy tissue had no relation with salinity, the ratio of the thickness of palisade tissue to spongy tissue decreased with increasing salinity.

扫描电镜下栅栏组织细胞中的叶绿体数量和形态未见明显的变化，但叶绿体在细胞中的位置发生了改变。

The present invention adopts polyvinyl perchloride and organosilicon modified acrylic resin as main filming material and adds cyanuramide phosphate and expanding graphite into common polytriammonium phasphate as fireproof assistant to constitute foaming material. The present invention has greatly raised foaming rate and the foamed layer has thickness of 30-50 times the original coating thickness and fireproof limit up to 90 min.

本发明采用高氯化聚乙烯和自行合成的有机硅改性丙烯酸酯树脂为主要成膜物质，并在通常所用的聚磷酸铵类防火助剂的基础上，加入三聚氰胺磷酸盐和可发性膨胀石墨作为发泡材料组成，大大提高了涂层的发泡率，发泡层厚度可达原涂层厚的30～50倍，耐火极限可达90min(涂层厚度2mm)。

Similarly, the AMR begin to increase and then decrease with increasing the thickness d of the seed layer, and has a maximum value at a critical thickness d of 5.32nm. Compared to the permalloy films deposited on Ta seed layer ,the AMR enhancement of 10%-46% is observed in the permallay films deposited on (Ni0.82Fe0.18)1-xNbx seed layer.(2) The coercivity Hc1 obtained for magnetic field H applied paralley to the easyaxis is large than Hc2 for H applied perpendicular to the in-plane easy axis, and both of coercivity are consistent with the change of x.

2沿样品易轴方向的矫顽力Hc_1比难轴方向的矫顽力Hc_2大，两者随Nb原子的百分含量x的变化是一致的，饱和磁化强度Ms随x的增大先增大后减小，在x=27.1％处，Hc_1和Hc_2都比较小，而Ms则达到最大；种子层厚度d不能明显改变坡莫合金薄膜的磁性能；与以传统材料Ta为种子层的坡莫合金薄膜相比，以Ni_(0.82Fe_(0.18)_(0.829)Nb_(0.271)为种子层的坡莫合金薄膜的矫顽力只有轻微减小，但是Msg 以w讪Fq.t）lkNk为种于层的坡莫合全薄膜的各向异性戳电阻及磁性能研究却要大，mk坡莫合金层厂度！

The thickness of the metallic layer is in positive correction with the development of phosphorite but in negative correction with the thickness of the stone coal layer.

黑色岩系的底部为厚度不等的磷块岩层，其上为金属层或石煤层，金属层的厚度与磷块岩的发育呈正相关，与石煤层的厚度呈负相关。

Distortion discipline of line heating for automatic processing is researchedThe main influence factors of shell plate forming by line heating are analyzed. Based on the analysis of measured data processed by the experiment machine of line heating, thickness of plate, length of heating line, processing speed and shrinkage are regarded as 4 dimensions, and the methods of vectors mapping, plane projection and conversion of coordinates are used to build mathematical models for local surface shrinkage of different thickness and processing parameters.

1研究了自动化加工水火弯板变形规律分析了水火弯板加工成型的主要影响参数，在对水火弯板实验机加工测量数据分析的基础上，以板厚、加热线长度、加工速度和收缩量作为4个维度，应用向量映射，平面投影、坐标转换方法建立了不同钢板厚度的局部表面收缩量和加工参数的数学模型。

Results:(1)Among 40 rats, 36 rats were successfully established and the rate of success is 90 percent;(2)All the successfully established models demonstrated polydipsia, polyuria and the body weight was not increased. 6 rats suffered cataract after 3 months, and 4 rats died in 6 months;(3)There was an approximately 61% loss of retinal ganglion cells in the central retina and the thickness of retina thinner under microscope ( P 0.01 ).(4) Electroscope changes include the thinner of retina, disorganization of the membranous disc of the rod cells and the thickness of basal membrane of vessal.(5)In normal group, 1 month dibetes mellitus and 1 month treatmen group, there was no expression of ERK1/ERK2 on the retina tissues. In 3 month diabetes mellitus group, the expression of ERK1/ERK2 was positive.

结果：①40只建模大鼠中36只建模成功，建模成功率为90%；②建模成功的大鼠都表现出多饮、多尿、消瘦、体重不增的表现，有6只大鼠在3个月后出现白内障，有4只大鼠在喂养接近至6个月时死亡；③HE染色光镜下6个月大鼠后极部视网膜节细胞层细胞数明显减少，减少约61%(P.01)，后极部视网膜明显变薄(P.01)；④电镜观察，视网膜变薄，视杆细胞膜盘紊乱，血管基底膜增厚等表现；⑤正常组、糖尿病组和治疗组1个月大鼠视网膜中未见ERK1/ERK2的表达，糖尿病组视网膜组织中3个月时可见少量表达，ERK1/ERK2表达部位为神经节细胞层和内核层；6个月时表达强阳性，部位表达不仅见于内核层、神经节细胞层，色素上皮层也见表达。

Consumer preference ; fuzzy partial ordering relation ; condorect function

消费者偏好；模糊偏序关系； condorect函数

And she doesn't have a cat, she has a Mexican hairless.

而且她不养猫，她养了一只墨西哥无毛犬。