查询词典 test bar

New Zealand white rabbits (3-4 months old, 3-4 kg weight) were the test animals, and they were divided into three groups proceeding in this study. In group A:One PLLA screw and one commercial screw were implanted in the right tibia. Two PLLA screws were implanted in the left. Furthermore, one PLLA bar was implanted in both right and left tibia respectively with onlay model in group B. Also,one PLLA plate was implanted in the left tibia and one commercial plate in the right respectively with onlay model in group C . Many tests were done on each sample in 1, 4, 8 and 12 weeks which included the observation of tissue response in group A, and the change of three-points bending, weight loss, molecular weight, crystallinity and morphology of fracture surface by scanning electronic microscopyin group B, and the change of three-points bending, weight loss and molecular weight in group C.

所使用实验动物为24只3-4个月大，体重3-4公斤的纽西兰兔，并将所使用材料及动物分为A、B、C三组进行。A组中於实验兔之右胫骨植入两支骨钉，一支为自制骨钉，一支为MacroPore市售骨钉，并钻一孔但不植入骨钉做为控制组；另於实验兔之左胫骨植入两支自制骨钉，另标示一区不钻孔不植入骨钉做为控制组。B组采用onlay1 模式於实验兔之左右胫骨各植入一自制长型片。C组也采用onlay模式於实验兔之左胫骨植入一自制骨板，於右胫骨植入一市售骨板，各於不同时间点( 1， 4及12周)将A及C组，而於( 1，4，8及12周)将B组内的植入物取出进行各种测试，包括A组的组织切片观察及B组的三点弯曲变化、质量损失、分子量变化、结晶度变化及扫描式电子显微镜观察断面型态改变及C组的三点弯曲变化、质量损失、分子量变化。

On the basis of experimental research,through compartmentalizing experimental beams into plenty of tiny cell,according to constitutive equation of each materials including steel bar,concrete,CFRP, this paper presents numerical simulation study of flexural all course of RC beams strengthened with CFRP, the theoretical results agree closely with those of the test.

在试验研究的基础上，将CFRP加固钢筋混凝土梁划分为若干个微单元，根据组成CFRP加固钢筋混凝土梁各材料的本构关系，通过数值方法，实现了对碳纤维布加固钢筋混凝土梁受弯全过程的数值模拟，其计算结果与试验所测得的结果符合较好。

The results showed that when retrogressed by electrical current heating at 200 ℃ the tensile strength in re-aged 7A04 alloy extrusion bar of 60 mm in diameter reached 620-640 MPa and a uniform elongation appeared from central part to surface layer of the sample while the fracture time in test of resistance to stress corrosion under a load stress of 375MPa in 3%NaCl+0.5%H2O2 corrosion solution was greater than 30 d.

结果表明，直径60 mm的7A04铝合金棒材在200℃电流直接加热回归后再时效，从心部到表层的拉伸强度为620-640 MPa，延伸率均匀一致；在3%NaCl+0.5%H2O2水溶液介质中和375 MPa应力下的应力腐蚀断裂时间大于30d，而辐射式加热回归的为575 MPa，延伸率从心部至表层表现极不均匀，应力腐蚀断裂时间只有19 d。

The results showed that when retrogressed by electrical current heating at 200℃the tensile strength in re-aged 7A04 alloy extrusion bar of 60 mm in diameter reached 620- 640 MPa and a uniform elongation appeared from central part to surface layer of the sample while the fracture time in test of resistance to stress corrosion under a load stress of 375MPa in 3%NaCl+0.5%H_2O_2 corrosion sol...

结果表明，直径60 mm的7A04铝合金棒材在200℃电流直接加热回归后再时效，从心部到表层的拉伸强度为620-640 MPa，延伸率均匀一致；在3%NaCl+0.5%H_2O_2水溶液介质中和375 MPa应力下的应力腐蚀断裂时间大于30 d，而辐射式加热回归的为575 MPa，延伸率从心部至表层表现极不均匀，应力腐蚀断裂时间只有19 d。

The test results showed that the prestress and position of the anchor bar as well as the applying order of the prestress were the main factor influencing the stress state in the slope.

试验结果表明，锚杆预应力的大小、位置及其施加次序是影响边坡应力状态的主要因素。

That the time to hit the designated hospitals in the BCG arm a needle bar, a bit like playing penicillin skin test to do the same.

到时候去那指定的医院在打卡介苗的那个胳膊上扎一针，有点象打青霉素做的皮试一样。

Here, a platform for the test of IPMC's characters was introduced. The movement of a bar IPMC's tip was measured via a laser displacement sensor. The information of the driving voltage, current and the displacement sensor's output, were acquisitioned by an AD board, and then input into a computer for analyses.

介绍了一种IPMC特性的测试平台，通过激光传感器实现对条形IPMC端部变形的非接触测量，同时使用一套数据采集设备对驱动电压、电流、传感器的输出进行数据实时采集。

The test results were analyzed and compared with results of other researchers. The different responses between tantalum plate and tantalum bar were analyzed. A simple discuss of plastic deformation mechanism for tantalum was given too.

最后一章利用常温下的动态、准静态应力-应变实验数据和准静态下的高低温实验数据分别确定了钽的Johnson-Cook和Zerilli-Armstrong形式的本构关系，发现拟合结果与实验值并不能得到较好的吻合。

Through model test,it analyzes damage mode of adding batten plate under vertical load,strain relation of load with flexibility、load with steel bar and carbon cloth are given,it obtains dangerous section of span beam when researched damage mechanism,which make structure can reach prospective effect.

通过模型试验，对附加缀板式这种新型结构加固后在竖向荷载作用的破坏形式进行了分析，给出了荷载与挠度、荷载与钢筋及碳纤维应变的关系，并对结构破坏机理进行了研究，得出各跨梁的危险截面，使该结构达到了预期的加固效果。

The test shows that the butt friction welding process of copper and stainless steel bar can be divided into the following stages approximately: the adhesion at the beginning of friction,friction inside the copper,the expansion of the plastic ring and the friction on the bound surface of copper-stainless steel and the friction in stainless ...

结果表明铜与不锈钢棒料的对接摩擦焊过程大致可分为初始摩擦的粘着；铜内摩擦、塑性环扩展；铜、不锈钢界面摩擦及不锈钢体内摩擦3个主要阶段。在接头形成过程中经历了两次摩擦面的转移。其内容对促进异种材料摩擦焊的接头形成机理研究有积极的作用。

I'm strongly against the death penalty — it's an eye for an eye.

我不赞成死刑——这是以牙还牙的报复行为。

And to get you the support you need, we're enlisting all elements of our national power: our diplomacy and development, our economic might and our moral suasion, so that you and the rest of our military do not bear the burden of our security alone.

并给你们所须的支援，我们正徵召国家所有各种的力量：我们的外交及发展，我们的经济力量与道德劝说，所以你们与其他军人不须要孤独地负起国家安全的责任。