查询词典 surface break

The spotted precipitates distributes in the small pits on the stoss and the front part of the top-surface; the lamilated precipitates covers on the surface of the back part of the top-surface; there is precipitates in small amount on the lee.

在迎冰面和顶冰面前部，沉淀物呈点状位于洼坑中；在顶冰面后部，沉淀物呈片状披覆于冰床上；背冰面沉淀物少。

Hypoxia-ischemia for 10 minutes group , 20 minutes group: our experiment showed that at 24 hours after cerebral hypoxia-ischemia, expression of MMP-9mRNA was maximally increased, individually, in the hypoxia-ischemia for 10 minutes group, MMP-9mRNA was greatly expressed within superolateral surface cortex of cerebrum, whereas in the hypoxia-ischemia for 20 minutes group, the labeling of hybridization for MMP-9mRNA was strongly appeared within the cortexof cerebrum both the cortex in the subsequence of medial surface at the periphery of the cerebral longigudinal fissure and the cortex in superolateral surface where also there showed a few stained fibers.

3缺氧缺血10分钟、20分钟组：缺氧缺血后24小时脑内MMP9 mRNA阳性表达至最高峰，缺氧缺血10分钟组大量表达在端脑背外侧面皮质内，缺氧缺血20分钟组在端脑内侧面后份大脑纵裂旁周围皮质及背外侧面皮质内呈强阳性表达，少数纤维呈亦阳性染色。

Surface photovoltaic behavior of titanoxophthalocyanine/N,N-bistolylperylene tetracarboxylic diimide composite films was investigated with surface photovoltaic spectroscopy and field induced surface photovoltaic spectroscopy.

用表面光电压谱和电场诱导表面光电压谱相结合的方法，研究了酞菁氧钛/N，N-二甲苯基苝酰亚胺复合薄膜的表面光伏行为，发现加入N，N-二甲苯基苝酰亚胺使复合薄膜在可见光区和近红外光区均产生负的光伏响应，可归结为光伏极性反转现象。

The rubbed surface was analyzed with XPS and EPMA, the results shown that the element S, N were as thiadiazole and imidazoline compounds in the rubbed surface film. The tribological properties of surface modified TiO〓 nanoparticles as water base lubrication additive was studied firstly.

用XPS、EPMA对摩擦后的磨斑表面进行了表面形貌，表面膜元素组成，及表面膜中的N〓、S〓电子结合能进行了考察，并与相应母体环化物的N〓、S〓进行了比较，发现摩擦后，磨斑表面膜中的S、N元素，主要是以噻二唑及咪唑啉的形式存在。

Because change of volume reflected eroding process of watershed and surface change reflected change of topography surface, this model described relationship between watershed topograph and erosion.iv As a quantitative index of wateshed topography, topograph fractal demension can represent surface shape information of watershed topography in the round. Reseach find that watershed model and actual watershed show good fractal character. Topography fractal dimension related with process of development of watershed physiognomy and represented degree of watershed development, v Sediment yield intensity of watershed model reflected erosion characteristic of watershed model in different development phase.

流域模型产沙强度的变化反映了流域模型在不同发育阶段的侵蚀特征，模拟试验研究结果表明：在整个流域模型地貌地貌的发育过程中，其产沙强度呈现由小到大，然后又逐渐减小的总体趋势，流域模型单位降雨产沙率及平均输沙率与地形分维数表现为Gaussian模型关系，其关系形式与结论3中相对体积和表面积之间关系相似，进一步说明了以地形分维数表达地形变化的合理性。

Based on a computing model of floor heating residences, indoor thermal environment and heat distribution under the effect of heat charge/discharge, operation control and solar radiation has been concluded. Concept and formula of equivalent heat supply has been put forward which indicate that actual heat supply will be equal to the sum of design heat supply and equivalent heat supply. Recommend coefficient has been given taken Dalian as an example. Computed according to the new method, design heat supply can be reduced to 37% in cloudy day and 43.3% in sunny day, energy saving effect is very obvious. In Tromb wall solar house, effect of concrete wall on indoor temperature swing and attenuation of temperature wave is very obvious. While the outdoor air-temperature swing exceeds 10℃, indoor air-temperature swing belows 3℃. In the experiment, maximal difference in temperature between inner surface and outer surface of the 300mm wall exceeded 10℃. Heat storage and collector efficiency varies adversely according to solar radiation. Factors such as thickness, material, absorptance of the wall and permeation of the glass cover all have big influence on heat storage and collector efficiency. There exsisted an optimal thickness of the wall, which can make the best of heat storage and collector efficiency. Most of the heat stored in conventional Trombe wall during the daytime has been lost to the outside at night without heat preservation. Heat preservation on the outside surface of the wall has effectively improved heat release performance of the wall at night, heat supply to the room has increased too.

通过建立的地板采暖系统动态热性能分析模型，得出了在蓄放热特性、运行方式和太阳辐射等因素耦合作用下的室内热环境及热量分配比例，提出了等效供热量的概念及计算公式，指出实际所需供热量应等于设计供热量加上等效供热量，并以大连为例，给出了等效供热量的修正系数，以新方法计算，阴天可减少设计供热量37％，晴天最大可以减少设计供热量43.3％，节能效果显著；集热蓄热墙式太阳房中，混凝土蓄热墙的室温均一化效果和对温度波的削减作用非常明显，当室外温度波动最大幅度超过10℃时，室温波幅不超过3℃，实验中300mm厚墙体内外表面温差超过10℃；墙体蓄热效率与集热效率随太阳辐射照度的变化呈相反的变化趋势；墙体厚度、材料、表面吸收率以及盖板透过率等因素对集热和蓄热效率均有较大的影响，存在一个最佳的墙体厚度值，使得墙体集热和蓄热综合性能最优；传统的蓄热墙夜间没有外保温，辐射散热损失很大，研究表明墙体外保温方式明显改善了蓄热墙夜间的散热性能，增加了向室内的供热量。

The present experiment demonstrated that the unhomogeneity of surface tension induced by gradient magnetic field near the surface of liquid could lead to surface deformation, the quantity and direction of deformation are directly related to the distribution of gradient filed, and a new way to the research of the kinetics of Buoyant-Thermcapillary Convection is proposed.

得到了结论：液体表面附近处的梯度磁场将引起表面张力的不均匀而使其发生变形，变形量及方向与磁场强度和梯度的空间分布有直接关系，为浮力-热毛细对流的相关研究提供一种新的途径。

For the effect of surface oxidation on emissivity:(1) most oxidized samples have higher emissivity than unoxidized samples, except AL 2024 and AL 7005. The exception is due to roughened surface caused by the onset of melt and the change of surface color at high heating temperature.

铝合金有氧化与无氧化对放射率的影响：(1)大部份铝合金有氧化的放射率皆大於无氧化的放射率，除了AL 2024与AL 7005，因为熔化造成表面粗糙度增加及高温加热时表面色泽的改变导致无氧化的放射率大於有氧化的放射率。

Data indicate that wetting property of self-bonding fiberboard is better than MDF, that wetting property of sanded surface of self-bonding fiberboard made with Method I is inferior to that of unsanded fiberboard, but opposite results to the comparison between sanded surface of self-bonding fiberboard made with Method II and unsanded surface, and that self-bonding fiberboard without waterproof agent has better wetting property than that with waterproof agent.

结果表明：(1)无胶木材纤维纤维板的润湿性比中密度纤维板好；(2)利用无胶纤维板工艺1制作的无胶板砂磨表面的润湿性比未砂磨表面润湿性差，但用无胶纤维板工艺2制作的无胶纤维板的砂磨表面润湿性比朱砂表面润湿性好；(3)未加防水剂的无胶纤维板的表面润湿性比加防水剂的无胶纤维板的润湿性好。

The apex rubber is formed by winding an unvulcanized rubber strip along the assembly forming surface from a starting position constituted by the radially outer peripheral surface of the bead core supported on the receiving surface so as to laminate in a tapered cross sectional shape.

通过从开始位置沿着组件形成面卷绕未硫化的橡胶条使其层叠成渐缩的横截面形状而形成三角胶芯，所述开始位置由支撑在所述接收面上的胎圈芯的径向外周面构成。

What was it that made you want to change sider ?

是什么使你临阵倒戈？

I don't know what he wants, but let's play along with him.

我不知道他要干什么，可我