查询词典 stress function

It is found that in certain water ratio and consolidation pressure, the values of initial elastic modulus and principal deviator stress increase with intermediate principal stress increasing; in certain intermediate principal stress, the values of initial elastic modulus and principal deviator stress increase with water ratio falling.

试验结果表明：在一定的含水率和固结压力下，偏差应力和初始切线模量均随中主应力比b的增大而增大；在中主应力比b确定的情况下，偏差应力和强度最大值随着含水率的增大而减小。

Experimental study of stress-strain relationship of normally consolidated intact soft clay in Hangzhou under undrained fixed shear of principal stress direction and monotonic rotation of principal stress axis had been done, which was used to reflect the soil properties response to the monotonic rotation of principal stress axis under real engineering conditions.

为反映真实工程条件下主应力轴旋转应力路径引起土体性状的变化，对杭州地区正常固结原状软黏土在固结不排水的主应力轴定向剪切和主应力轴单调旋转条件下的应力-应变关系进行试验研究。

In Late Jurassic period (159-135Ma), when the orientation of maximum principal compressive stress was NW direction, the Wuzhangshan granite intruded to upward, accompanied the formation of NW trending Sanrenchang and Huangshuian breccia pipe belts; In the Early Cretaceous period (135-120Ma), when the orientation of maximum principal compressive stress was NNW trending, the second stage of Huashan granite intruded to upward, accompanied the formation of NW trending Qiyugou breccia pipe belts; In 120-105 Ma, when the orientation of maximum principal compressive stress changed to NE direction, the gold-bearing quartz veins and gold orebodies in breccia pipes were formed along the NE trending fractures; In the Middle Cretaceous period (105-85 Ma), when the orientation of maximum principal compressive stress was NEE, the NEE trending Leimengou granite porphyry intruded to upward, accompanied the formation of NEE trending Leimengou breccia pipe belts.

在晚侏罗世(159～135Ma)，构造应力场最大压应力方向为NW向，形成了NW走向的五丈山岩体以及NW向展布三人场、黄水庵两个角砾岩带；在白垩纪早期(135～120Ma)，最大压应力为NNW向，形成了花山岩体第二期上侵，并伴有NW向的祁雨沟角砾岩带；其后(120～100Ma)，构造应力场最大压应力方向变为NE向，形成了NE向含金石英脉及角砾岩体中金矿体；最后(100～80Ma)，形成了雷门沟花岗斑岩以及NEE向展布的雷门沟-杨河沟角砾岩带(区域构造应力场的最大主压应力方向为NEE向)。

The results indicate that the flow stress of the alloy increases with increasing strain rate and decreasing deformation temperature. The flow stress increases with increasing strain until the stress reaches the peak value, then the flow stress remains constant, which indicates that dynamic recrystallization happens during deformation. The flow behaviors are described by the hyperbolic sine constitutive equation, and the activation energy calculated is 337.75 kJ/mol. The as-forged microstructure consists of refined α2/γ and γ grains, and the grains are much homogeneous than before. The B2 phase distributes uniformly at the grain boundary of α2/γ and γ grains. The B2 phase decreases with increasing deformation temperature.

结果表明：流变应力随着应变速率提高和变形温度降低而增大；在变形过程中，流变应力随着变形量增大而增大，当流变应力达到峰值后趋于平稳，表明合金在变形过程中发生了动态再结晶；热变形过程的流变应力可采用双曲正弦本构关系来描述，平均激活能为337.75 kJ/mol；从合金的组织演化过程中可以看出，合金中不均匀的原始组织得到明显均匀化，变形后的组织是由α2/γ层片晶团和γ晶粒组成的双态组织，在α2/γ层片晶团和γ晶粒的晶界交界处发现分布均匀的B2相，并且随着变形温度升高B2相数量逐渐减少。

The results of lattice beam internal force calculated method based on double parameter groundsill model are more approach the experiment measured values because of consideration of the pass of shearing force in soil, and its calculated workloads are similar with the method of winkler elastic foundation. Besides, the thesis also discusses the moment of torque affected results on node stress situation and the correction of stress value at the bottom of cross node of lattice beam. Due to the repeat calculation of node area during internal force calculation, the stress value of the bottom of beam is lower, this may lead the calculated value unsafe, but the corrected stress value will more approach to practical situation.

对格构梁的内力计算提出基于双参数地基模型的格构梁内力计算方法，其计算结果表明，双参数地基模型上的格构梁内力由于考虑土中剪力的传递更加接近于试验实测值，其计算工作量与winkler弹性地基梁法相当，此外，文中还探讨了扭矩作用对格构梁节点受力情况的影响结果以及格构梁交叉节点底部的应力值的修正，由于内力计算过程中节点处的面积被重复计算，使得梁底应力偏小，可能导致计算结果的偏于不安全，修正后的应力值更接近于实际情况。

The stress distribution and peak stress values of Maximum principle stress and shear stress were used for comparison.

选择具有代表意义的最大主应力和剪应力指标进行结果的评价。

Based on the abundant proof of the individual influence factor and the environmental influence factor of the air traffic controllers' stress, it combines the design of EAP and the influence factors of the controllers' stress, in order to relieve the controllers' stress effectively by the management of EAP and help the controllers to choose the correct coping style when facing stress. It provides strategy foundation to the creation of the harmonious working environment and the enhancement of the controllers' individual modulability.

在对空中交通管制员压力源的个人影响因素和环境影响因素的充分论证的基础上，将EAP设计与影响管制人员压力源因素有机结合起来，力求通过EAP措施帮助管制人员有效地缓解工作压力，帮助管制员面对压力时能够采取正确的应对方式；为创造和谐积极的组织工作环境和提高管制员个人自我调节能力提供决策依据。

In this paper, a dynamic photoelastic method is applied to investigating the stress wave propagation of projectile ogive under impact load, the dynamic stress state is analyzed, and the dynamic stress values are obtained by applying stress optics law.

用动光弹实验方法研究了冲击荷载作用下穿甲弹风帽模型的应力波的传播过程，对其受冲击后的动应力状态进行了分析，用应力光学定律得到了模型内的动应力值。

Of the participants perceived that they are in higher job stress. Primary stress is "inner conflict stress", and secondary is "relationship stress".

有36.6％学术主管，在工作时感受到整体工作压力大，其中以「内在冲突的压力」的感受程度较大；而「人际关系的压力」的工作压力感受较小。

Based on the former study of soils constitutive relation involving principal stress axes rotation,the influences of principal stress axes rotation on the distribution of stress and deformation of soils are provided through numerical simulation of plane strain problems of soils involving rotation of principal stress axes.

在含主应力轴旋转的土体本构关系研究的基础上，通过含主应力轴旋转的土体平面应变问题的弹塑性数值模拟结果分析，总结主应力轴旋转对土体应力分布与变形影响的规律，得出需要考虑主应力轴旋转的条件及其影响的相对大小。

I go to school at night.

我是上上学。

Clear Tip Nasal Aspirator: A soft time and gentle suction action makes removing excess mucus easy.

鼻吸明确提示：一个柔软的时间和温柔吸力行动使消除过剩的粘液容易。