查询词典 static friction

Compact pentroof combustion chambers and high-strength pistons that are resin-coated to reduce friction, low-tension piston rings and a low-friction valve train that uses roller rocker arms also are important features of this engine, as is an Acoustic Control Induction System that changes the length of the intake manifold runners based on engine speed and throttle opening.

紧凑pentroof燃烧室和高强度的活塞是树脂涂层以减少摩擦，低张力活塞环和低摩擦气门，使用滚子摇臂也是这个引擎的重要特色，是一种声学控制感应系统这改变了进气长度发动机转速和节气门开度为基础的多方面的选手。

The friction plate produces friction damping on the rope wheel under the influences of centrifugal force. The gear speed change helps the rope wheel produce balanced damping torgue when people descend.

利用离心使磨擦块在绳轮上产生磨擦阻尼，通过齿轮变速，使阻尼距与人下降时在绳轮上形成的主力距相平衡，以实现匀速下降，从而保证了被救者的安全。2。

Two pairs of chutes and holes on the cleaning base and the brushes form the double chute swing mechanisms by the connection of an axis and cause the brush to cling to the wall surface to clean by the friction feedback, thus achieving effective cleaning when walking error occurs and the pipe section changes, furthermore, the larger the friction on the wall surface is, the larger the forward pressure on the wall surface is, therefore, the dirtier the wall surface is, the higher the cleaning efficiency is.

清扫底座与刷子夹上的两对滑槽和孔通过轴的连接形成双滑槽摆动机构，并通过摩擦力反馈使得刷子能够紧贴壁面进行清洗，从而在出现行走误差和管道截面变化时都能够有效清洗，并且壁面摩擦力越大刷子作用在壁面上的正压力越大，因此壁面越脏时清扫效率越高。

A two-component mixed friction model is used to express the friction force in servo mechanisms.

伺服机构中的摩擦力是采用一种&两维混合摩擦模型&来描述的。

Determine (1)the angle acceleration of the tub wheel,(2) the tensile force of the rope,(3) the reaction forces at point O on the bearing,(4)the friction force between the cylinder and the inclined plane (neglecting the rolling friction).

在图示机构中，沿斜面向上作纯滚动的圆柱体和鼓轮O均为均质物体，各重为P和Q，半径均为R，绳子不可伸长，其质量不计，斜面倾角，如在鼓轮上作用一常力偶矩M。

Companies are the main product categories are: 1, iron-based friction material: including medium and heavy truck powder brake pads, brake-watt tank track; Engineering Machinery (such as forklifts, continuous casting rolling mill, etc.) brake pads, clutch friction films and so on.

公司现主要产品类别有： 1、铁基摩擦材料：包括中、重型载重汽车粉末冶金刹车片、坦克履带制动瓦；工程机械刹车片、离合器摩擦片等。

Internal friction in hardened low-carbon nickel steel was measured with a torsion pendulum and an internal friction peak was observed around 155℃ with a frequency of vibration of about 2 cycles per second.

用扭摆测量淬硬低碳镍合金钢中的内耗，当振动频率约为每秒2周时，在155℃附近有一个内耗峰出现。

Internal friction in hardened carbon steels was measured with a torsion pendulum and an internal friction peak was observed around 130℃when measurements were taken from room temperature upwards.

由内耗峰的出现可以认为马氏体在第一个回火阶段中的转变产物与母体具有共格性，由于共格界面的应力感生运动而引起内耗。

The internal friction in an 18-8-3-1 Cr-Ni--Mo-Ti heat-resisting steel was measuredwith a torsion pendulum, and an internal friction peak around 520℃ was observed.

用低频扭摆测量了18-8-3-1 Cr-Ni-Mo-Ti耐热钢的内耗，在520℃附近观察到一个内耗峰。

In any type of let-off motion in which the warp sheet passes over a back roller, the tension in the horizontal part of the warp sheet will be greater than that in the warp sheet between the back roller and the beam, because if the back roller rotates, force is required to overcome friction in its bearings, and if the back roller does not rotate, there will be friction at its surface.

任何类型的送经机构，经纱片均绕过后梁，处于水平位置的经纱的张力要比后梁与织轴之间的经纱张力大。这是因为，如果后梁转动，就需要力来克服轴承处的摩擦；如果后梁不转动，在后梁表面会有摩擦。

The system can be widely used in belt weighing and batching process control,etc.

介绍了基于智能模糊控制的嵌入式配料系统的设计方法，对模糊PID控制过程和系统调零作了重点的讨论，同时给出了PID控制的程序流程图和系统定长调零子程序。

"I dunno," she answered,"but if you show me aroun', I'll recognize it from the lighthouse just outside the porthole."

"我不知道，"她回答说，"如果你能带我转转，我能认出来的，因为灯塔就在舷窗外。"