查询词典 static friction coefficient

The maxima of low-temperature internal friction peaks plot a symmetrical peak-like curve at logarithmic frequency spectrum and the peak-like curve shifts toward high frequencies with the increase of heating rate, indicating that phase transition relaxation time decreases; the maxima of high-temperature internal friction peaks exhibit a linear relation to the reciprocal frequencies, and as the heating rate increases its slope rises, which implies that the heating rate drives the normal movement of phase interface further in low-frequency measurements.

低温内耗峰峰值与对数频率呈现峰形函数关系，随升温速率的增加，频率峰向高频方向移动，相变弛豫时间减小；高温内耗峰峰值与倒数频率成直线关系，随升温速率的增加，直线斜率变大，表明低频测量时升温速率对相界面法向运动的驱动作用更强。

Even Monadnock didn';t ignore the reality and produced its friction lock batons – Classical Friction Lock.

即便是Monadnock也没有忽视现实，它生产了阻力锁定甩棍-- Classical Friction Lock。

A new nonreversible friction model is presented for sliding regime to describe friction memory effect.

同时还提出了一个新的不可逆宏观滑动摩擦模型。

The Paper analyses slipping master sheets of friction hoists, Nonskid calcution on lectotypeing design and regulating the relate to factors for friction hoistis is disussed.

本文分析了摩擦式提升机滑动的原因，讨论了选型设计防滑计算及对有关参数的调整。

Starting from a barotropic model equations including large-scale orography,friction and heat factor,by means of scale analysis and small parameter method,then a barotropic quasi-geostrophic model with large-scale orography,friction and heating is obtained.

从包含大地形、摩擦及加热作用的正压模式方程组出发，通过尺度分析、小参数展开和线性化等方法，导出一个含大地形、摩擦及加热作用的准地转正压模式。

In this paper, the friction mechanism of engine piston ring / cylinder friction system was reserched.

本论文对发动机的活塞环／汽缸套这对摩擦副进行摩擦机理研究。

It is shown by the friction material behavior tests that the friction material behavior is influenced not only by its mechanical properties, such as hardness, modulus of elasticity, yielding stress and Poisson's ratio etc., but also by its chemical constitutions.

通过对摩擦材料的研究说明：摩擦材料的性能不仅受材料的力学特性，如硬度、弹性模量、屈服应力、泊松比等因素的影响，而且还受其化学组成的影响。

UHMWPE has regular molecule chain and lower shear strength, so it improved the tribological property of PA66. When the amount of the transferring layer reached a certain value, severe plastic distortion and adhesion wear occurred, and wear resistance of the blends was related to the mechanical property of the blends. Worn microstructure changes with addition of compatibilizer. Soft UHMWPE produced from friction heating has low shear strength, and it improves the tribological property of PA66 during the friction course.

结果表明：加入MAH-g-HDPE相容剂可以使共混体系的相容性得到改善，提高共混物的机械性能；具有平整分子结构的UHMWPE有利于改善PA66的摩擦磨损性能，当摩擦偶件的转移层达到饱和状态后，共混物的耐磨性与其力学性能相关；共混物在摩擦过程中表现出严重的塑性变形和粘着磨损，但在共混体系的摩擦过程中，对摩擦磨损性能起主要作用的是受热软化的UHMWPE在磨损表面形成低剪切强度的界面层，从而使得PA66的摩擦磨损性能明显改善。

The mean velocity distributions in turbulent boundary layers of smooth surface and two different riblet surfaces are measured with IFA300 constant-temperature anemometer in low-speed wind tunnel to validate the full development of turbulent boundary laye. Friction velocity and wall friction stress of turbulent boundary layer are obtained with the least-squares fitted curve of the sublayer velocity distribution based on Spalding formula, and virtual origin position of riblet surface can be acquired accurately.

在低速风洞中来流速度一定的情况下使用IFA300恒温热线风速仪测量了光滑表面和两种不同尺寸的脊状表面湍流边界层平均速度分布剖面，并验证了试验段湍流发展的充分性；通过应用Spalding壁面公式使用最小二乘法精准拟合了实验测量的边界层内层速度分布曲线，得到了湍流边界层壁面摩擦速度并进一步求得湍流壁面摩擦应力，较准确地计算出脊状表面的虚拟原点位置，并通过与对数律公式拟合结果比较分析，证实了该方法更加准确有效。

It involves a simple mechanical principle: sliding friction, rolling friction small.

它涉及一个简单的机械原理：滑动摩擦大、滚动摩擦小。

After explaining total design of automated test system for microcircuit , the thesis introduces GPIB standard .

文章在说明了微电路模块自动测试系统的总体设计后，对GPIB标准进行了介绍。

He interceded in my behalf.

他替我说情。