查询词典 solidifying

Six kinds of bio-diesels were prepared with different oil materials, and some important characteristics such as the fatty acid composition, solidifying point and pour point were determined.

以六种常见的动植物油脂为原料，制备生物柴油并测定其脂肪酸甲酯分布、凝点和冷滤点值。

And softening point, viscosity and solidifying point of the bond decide the optimal temperature according to the mechanism of warm compaction.

通过对温压机理的分析，发现最佳温压温度由粘结剂的软化点、粘度和固化点三个因素共同决定。

It is emphatically expounded the effects of vanadium,titanium,silicon and sulphur on viscosity,melting temperature and solidifying point of liquid iron.

简介了所采用的测试研究方法，着重论述了钛、钒、硅、硫单因素及其综合因素对铁水粘度、熔化性温度和凝固点的影响。

The conductivity, viscosity, diameter, stability, corrosion, density and solidifying point of microemulsion of diesel oil that be composed of water and emulsifier were studied.

对由柴油、水及乳化剂组成的微乳柴油进行了电导率、粘度、粒径、稳定性及腐蚀性、密度和凝点等性能研究。

In order to improve the level of quality control in solvent dewaxing unit,overcome the fluctuating of quality in finished oil's big tank for the delay of general analysis,and decrease unnecessary waste,SINOPEC Jinan Company was successful to put online instrument for analyzing dewaxing oil solidifying point into action for the first time.

为了提高溶剂脱蜡装置的质量控制水平，克服常规分析不及时造成的成品油大罐质量波动，减少不必要的浪费，中国石化济南分公司首次成功使用了去蜡油凝点在线分析仪。

For Golden-Brand Series synthetic compressor oil , kinematical viscosity is 7.6mm2/s(at 100℃), flash point is 258℃, solidifying point is -55℃,viscosity index is 135, which all reach the specification of ISO DAC/DAJ.

金牌合成油运动粘度7.6mm2/s(100℃)，闪点258℃，凝点-55℃，粘度指数135，均主要指标均达到了ISO DAC/DAJ 水平！

The results showed that the effect of all conditions on gel strength was very large;the holding water ability was directly proportional to gel strength and viscosity;under the condition of no sodium chloride addition,the solidifying point and melting point were directly proportional to gel strength;however,when sodium...

结果表明，凝胶强度受各条件变化的影响很大；持水性与凝胶强度、粘度成正比关系；在不添加NaCl时，融点、凝固点与凝胶强度成正比关系，但添加NaCl时，则与NaCl浓度成正比关系；凝胶体具有热可逆性

The solidifying point varied inversely as shear rate.

结果表明，凝固温度随剪切速率增大而降低。

The results show that the system belongs to Newton fluid; temperature being increased, the viscosity decreased; surfactant mass fraction being increased, the viscosity increased; the viscosity has the same trend as content of water; their diameters are about 100 nm, its corrosion, density and solidifying point can meet the national standards.

结果表明：微乳柴油体系为牛顿型流体；温度升高，体系粘度降低；表面活性剂质量分数增大，粘度也逐渐增大；粘度的变化同水量的变化规律基本一致；粒径均在100 nm左右；腐蚀性、密度和凝点均符合国家标准；室温时稳定期在6个月以上。

Heat transfer between ingot and mold is then intensified by the quickened flow velocity of Al melt. As a result, the initial solidifying point on the ingot surface in mold moves upwards to decrease the height of contact zone between the melt and mold so as to improve the surface quality of ingot.

铝熔体流动速度的加快能增强石墨环与铝熔体之间的换热，使结晶器内铸锭表面初始凝壳点位置上移，减小了铝熔体与结晶器的有效接触高度，提高了铸锭的表面质量。

I am sure after a few weeks of adaptation and familiarization I will have no difficulty in functioning on a daily basis in an English speaking society or in participating fully in graduate studies.

在大学的三年的学习生活不仅给予我自身的充实，更重要的是磨练和培养了我较强的自觉能力和严谨，踏实的作风以及不怕困难的精神，对未来充满了信心！

As the first volcanoes erupted, one of the gases that bellowed out was steam.

在第一批火山喷发时，喷出的气体之一就是水蒸汽。