查询词典 soaking

As a result, make sure the proportion of black dye is 4.2%, and the formula of the dyestuff C.I. Direct Black 19: C.I. Direct Black 168: Dyestuff I=3:1:1, and when using two surfactants, printing liquidity is better, at same time compare to printing result with national inks, and the result is that confecting inks excels national inks in soaking paper, curliness and edge definition.

最后确定黑色染料所占比例为4.2%，各染料配比为直接黑19：直接黑168：染料I=3：1：1，并且当用两种表面活性剂进行复配时，打印流畅性较佳；同时与国产品牌墨水作打印测试对比，结果自制墨水在有无洇纸和卷曲以及边缘清晰度方面优于国产品牌墨水。

The results showed that the crystals with high density form could bear long soaking time in cyclohexane.

实验表明，堆积密度高的胰蛋白酶晶体可以经受环己烷长时间的浸泡。

The result shows it can improve rice development proceed,effectively control damping-off and rice aogare occurrence,increase1000-grains weight ,reduce shrivel grains and increase yield that use seed coat agent (the proportion of seed to chemical is40to1)coat seeds after soaking by water.

为了验证水稻生物种衣剂的包衣效果，用大区试验的方法进行了两年试验，结果表明：清水浸种后用种衣剂包衣(种药比40：1)可促进水稻的生育进程，有效控制立枯病和青枯病的发生，增加千粒重，减少秕粒，增产效果显著，可以在生产中应用。

PL600 chlorine dioxide disinfectant can sterilize and deodorize by evaporating naturally (boiling point=11℃). Use chlorine dioxide by Spraying, wiping or soaking can kill all microbes, including bacteria, viruses, fungus, spore and cryptosporidium, etc.

PL600二氧化氯消毒剂所提供的二氧化氯专业技术，可以冷雾状气体或自然挥发(沸点仅为11℃)方式进行空间灭菌、除臭；此外，以液体喷洒、擦拭涂抹、浸泡方式，更能强效杀死所有的致病微生物，包括细菌、病毒、真菌、芽孢、隐孢子虫等…。。

The effect of colluviums thickness on the rainfall duration required for the initiation and the infiltration depth of soaking line is insignificant.

崩积层之厚度对浸润线形成所需之降雨延时及向下之扩散深度影响不大，但对浸润线与地下水水位线之结合有迟滞之作用。

The optimal concentration of edible alcohol for soaking was 70%.

70％的食用酒精为最佳的浸泡酒度。

In the 96 to 100 ℃ boil 1 minute in boiling water, put out the cold water in the cooling Amoy to ejecta, soaking 3 to 4 minutes.

在96～100℃沸水中煮沸1分钟，捞出放冷水中降温，淘去碎渣，浸泡3～4分钟。

They were just listening around, soaking up all the electronic traffic and ...

他们就是在那里听呢，收集所有的电子信号。。。

The simulation result of the enameling process at high temperature shows that with the increase of soaking temperature and holding time, the yield strength and tensile strength increase, and the total elongation decreases.

模拟高温搪烧时，随着温度的提高和保温时间的延长，屈服强度和抗拉强度下降，伸长率提高。

The simulation result of the enameling process at high temperature shows that with the increase of soaking temperature and holding time-the yield strength and tensile strength increase,and the total elongation decreases.

经857℃保温10 min后，钢板的屈服强度满足了不小于310 MPa的要求。预变形时的变形量对模拟高温搪烧后钢板的力学性能也会产生影响。

The system can be widely used in belt weighing and batching process control,etc.

介绍了基于智能模糊控制的嵌入式配料系统的设计方法，对模糊PID控制过程和系统调零作了重点的讨论，同时给出了PID控制的程序流程图和系统定长调零子程序。

"I dunno," she answered,"but if you show me aroun', I'll recognize it from the lighthouse just outside the porthole."

"我不知道，"她回答说，"如果你能带我转转，我能认出来的，因为灯塔就在舷窗外。"