查询词典 size up

Based on this, this paper attempts to propose a size measurement method of the union of using case and function point to measure the size software project.

基于此，本文尝试提出了用例与功能点相结合的规模度量方法来度量软件项目的规模。

In traditional typography, the size of the characters in a font is indicated by a point size.

在传统印刷中，字体中字符的大小由"点尺寸"指出。

In real-life typography, the point size of a font is not so precisely related to the actual size of the font characters.

在现实生活的印刷中，字体的点大小不是如此正好和字体字符的实际大小相关的。

Asterisk appearing is based on the size of the Central white point to determine the size of the dot gain.

星标是不梢据洋心白点的巨细，来猜测网点放不小的巨细的。

The size of the North polar ice cap in the month of September is only half the size it was a mere fifty years ago.

但是，现在的测量表明气候变化加速了。9月份的北极冰盖只有50年前的一半大小。

The size of the North Polar Ice Cap in the month of September isonly half the size it was a mere 50 years ago.

但是，现在的测量表明气候变化加速了。

The experimental results show that the content of SiC in RBSC increases with carbon content while α-SiC is chosen as a filler. However, the residual carbon would appear in specimens when the carbon content exceeds 30% by weight. Using carbon felt, the reaction-formed SiC particles are small and uniform in size and distribution. However, when carbon felt is impregnated with phenol resin, the reaction-formed SiC is nonuniform in size and distribution. X-ray diffraction shows that the fabricated RBSC is composed of α-SiC,β-SiC, and free Si. The polytype of SiC is related to the reaction-heat during sintering.

结果表明：选用α-SiC+C粉的混合物作为生坯，SiC相的体积分数随生坯中wC的增加而增加，但过大的wC将使硅化后的试样出现残碳；选用碳毡作为生坯，反应烧结碳化硅的显微组织特点是C／Si反应生成的碳化硅颗粒均匀细小，并呈线状分布在游离硅中；浸渍过树脂的碳毡硅化处理后的显微组织特点是反应生成的碳化硅颗粒粗大且呈不均匀分布。X射线衍射结果也表明，反应烧结碳化硅陶瓷由游离Si、α-SiC、β-SiC组成，试样中不同晶型碳化硅的出现与C／Si反应的放热过程有关。

The model of programmed crystallization of SPM was proposed based on the moment transformation of the population considering the agglomeration. The optimal temperature-time curves in a batch crystallizer which maximized the terminal mean size and mean weight size can be determined from the application of the Pontryagin Maximum Principle. The calculated crystallization results heating under optimal temperature were compared with ones under linear or natural heating temperature.

根据第四章所得到的螺旋霉素晶体二次成核和晶体生长和布朗扩散引起的聚集动力学，利用第六章所描述的晶体尺寸分布的各阶矩对时间的一阶导数所构成的自封闭的一阶常微分方程组，采用庞得里亚金极大值原理，以温度为控制变量，在满足某些约束条件下，以最大平均尺寸和最大晶体重量平均尺寸为性能指标，计算出了螺旋霉素间歇结晶的最优温度—时间曲线，并同线性加热和自然方式进行了比较。

In Chapter 5, the authors study the convergence properties of the gradient projection method for the constrained optimization problem. In this chapter, a new step-size rule, which avoids fulfiling the classical line search and includes choosing a constant as the step size as a special case, is presented and analyzed.

第五章研究了求解约束最优化问题的梯度投影方法，在步长的选取时采用了一种新的策略，这种策略不需要进行传统的线搜索且包含步长取常数这种特例，在较弱的条件下，证明了梯度投影方法的全局收敛性。

From thermal analysis, weight loss occurs pronouncedly at temperatures above 300 oC in air and the residual weight increases with the reaction temperature. The particle size decreases with the increasing ethanol concentration., while the BET surface area decreases when the concentration of water is increased. Pore size measured from the as-synthesized particles is about 2.7 - 4 nm and this becomes slightly smaller after calcination which is about 3 - 5 nm.

TG/DTA中温度上升至约300 oC时，重量开始明显失重，随著合成反应温度上升，最终残留量由1~3%提高为约5~7%，动态光散射粒径分析发现随著乙醇含量增加，煅烧前与煅烧后的粒径尺寸均有下降趋势，随著水含量的增加，比表面积值随著下降，煅烧后的壳层孔隙尺寸约为3~5nm，煅烧前的壳层孔隙尺寸为2.7~4 nm，煅烧后的孔隙度会略为上升。

In the chapter 2, the theoretic knowledge about the photosensitive resin and the grinding tools was firstly introduced.

第二章阐述了光固化树脂结合剂磨具的相关理论研究。

Do not use the program's indenting or margin-setting features; these will be added during typesetting.

不要使用缩排，页面边缘设置之类的选项，偶看不大懂。