查询词典 sight axis

By using the foam mats for its head fixation and standard head coils for emission and reception,the scanner begin its routine scannings in the position of the axis,sagittal,coronal SE T1WI(TR/TE=476/15ms) and axis TSE T2WI (TR/TE=3647/100ms).The matrix of the scanner is 256×256,the slick thickness of it 5mm and the spacing of it 0mm.1H-MRS is located on the side of the hippocampus by using the T2WI axis.

采用泡沫垫进行头部固定，使用标准头线圈作为发射和接收线圈，常规进行轴位、矢状位和冠状位SE T_1WI(TR/TE=476/15ms)和轴位TSET_2WI(TR/TE=3647/100ms)扫描，矩阵256×256，层厚5mm、间距0mm，1H-MRS采用T_2WI轴位定位于一侧海马选取正方体感兴趣区，体素大小为10mm×10mm×10mm，并在轴位、矢状位和冠状位上观察，使所选择的VOI尽量避开侧脑室及脑沟池内的脑脊液。

The marginal division was a flat fan-shaped structure with a volume of (0.48±0.02) mm3, a maximum rostral-caudate axis of 1.6 mm, a maximum dorsal-ventral axis of 2.158 mm, and a widest axis (the diameter at lateral-medial coronal brain section) of 0.17 mm. The marginal division also moved progressively externally from the rostral section to the caudate section, but its scope was larger than that of others. The whole marginal division changed evenly from the rostral section to the caudate one. Its flat structure widened progressively and its dorsal-ventral diameter narrowed gradually and became plate-shaped.

边缘区呈现一个片状扇形结构，体积为(0.48±0.02) mm3，最大嘴尾径为1.6 mm，最大背腹径为2.158 mm，最大内外径为0.17 mm；同尾壳核和苍白球一样从嘴侧到尾侧随着脑平面的增宽边缘区亦逐渐向外侧移位，其移位的幅度亦明显大于脑平面增宽的幅度；整个边缘区从嘴侧到尾侧呈均匀变化，其片状逐渐变宽，长度逐渐变小，从而形成一个盘状结构。

In order to decrease the weight of tracking system and make suitable use of the Lander space, the pitching-axis of Lunar optical telescope is vertical with the Lander's flank, its rotation part is fastened on the Lander's flank, the azimuth-axis adopts rotation reflecting mirror, the flat mirror is located before the telescope tube, the angle of flat mirror and the telescope ray-axis is 45°,so that the reflecting ray can enter the telescope optical system, the scan of the mirror can be accomplished by the rotation of the telescope tube.

工作过程中望远镜支架的两个轴需带动望远镜一起转动，为了减小跟踪平台的重量和合理利用着陆器空间，又能在大范围内对太空目标进行跟踪，月基天文望远镜的俯仰轴垂直于着陆器的侧面，其转动部分固联在着陆器的侧面，方位轴采用旋转反射镜方式，将平面反射镜放在望远镜的镜筒前端，并与望远镜光轴成45°安装，使反射光线能够进入望远镜光学系统，通过转动望远镜镜筒使得反射镜实现对空间的扫描。

Approach: the surface rust with sandpaper lighting, using raw materials with after winding into ring for emergency action to deal with, the best method is for-axis, or axis setting processing sets to restore the size of the original axis.

处理办法：锈蚀表面用砂纸打光，用生料带缠绕后，放入动环作应急处理，最好的方法是换轴，或轴镶套后加工恢复到原轴的尺寸。

From the simulations, we can see the distributions and transmission of strain and stress in model under different loadings, and the results explained the fractures very well. 4. Similarly, a axis FEM model was constructed to simulate the axis fracture, emphasized on the odontoid process. Three kind of odontoid process fracture were analysed on this model, which occurred respectively on the tip, the middle and the fundus. The results gave the best angle to fracture the odontoid process of the axis.

四、建立了枢椎的三维有限元模型，对枢椎齿状突骨折机理进行了理论上的研究，重点针对临床上齿突骨折的三种分类：1、齿突尖骨折；2、齿突腰部骨折；3、齿突基底部骨折，赋予齿状突在矢状面沿各种角度下受力条件，模拟衰椎前弓、襄椎横韧带以及CZ－3棘间韧带对枢椎造成的暴力破坏，确定了最可能引起齿状突暴力骨折的受力角度。

Similarly, a axis FEM model was constructed to simulate the axis fracture, emphasized on the odontoid process. Three kind of odontoid process fracture were analysed on this model, which occurred respectively on the tip, the middle and the fundus. The results gave the best angle to fracture the odontoid process of the axis.

四、建立了枢椎的三维有限元模型，对枢椎齿状突骨折机理进行了理论上的研究，重点针对临床上齿突骨折的三种分类：1、齿突尖骨折：2、齿突腰部骨折：3、齿突基底部骨折，赋予齿状突在矢状面沿各种角度下受力条件，模拟寰椎前弓、寰椎横韧带以及C2-3棘间韧带对枢椎造成的暴力破坏，确定了最可能引起齿状突暴力骨折的受力角度。

Aim and Methods\ Three methods are analysed and compared for measuring the lateral deflection of gun bore axis from firing plane and the deviation of the sight line from the barrel axis, according to the results measured in practice. Results\ The tested data show that this new method is accurate.

引 言在多次火炮总装测量检查中，我们发现用炮口瞄准仪测量&炮膛轴线偏离射面的偏离角&与&瞄准线偏移&和用经纬仪、炮口坐标尺测量这两个项目有一定的差别。

Currently in initial production, the Off-Axis Viewing Deviceis a small viewing unit that mates with a weapon′s existing receive-mounted optical sight and provides an image of the target transmitted through the scope and reflected 50°to the line-of-sight back to the firer.

目前，初期生产的离轴式观察装置是一种与装在支座上的光学瞄准具相配的小型观察器，它能将透过物镜的目标图像折射50°到视线方向，再提供给射手。

The main work and research results includes: Analyzing the virtual character of the road sight, the mental character of dynamic aesthetics Through anatomization of virtual perception and analyze of the viewing effect, sight character、sight dynamic sequence and mental effective analyze of the aesthetics, we get a conclusion.

提出了一套公路景观环境评价指标体系结合公路景观环境特点，运用层次分析法，建立公路景观环境评价指标体系，为公路景观生态建设提供一定的科学依据。

When the gunner aligned his sight onto the target, electrical impulses would be transmitted to the computer, which would control the power system of the barbette and 20 mm guns to coincide with the alignment of the sight, allowing for deflection and the angular differences of the barbette and sight.

当射手把他的瞄准具对准目标时，电子脉冲会被传送到这个计算机，计算机能够控制炮座上的动力系统和20毫米炮与瞄准具指向同一目标。计算机会自动修正瞄准具和炮座之间的位置和角度的差别。

We are forbidden from giving money to these shoeless, skinny children, as this will perpetuate begging.

向光着脚，骨瘦如柴的孩子施舍是不可以的，因为要招来无休无止的乞讨。

It would be hard not to fall victim to some sharpeyed policeman.

要想不被某个目光锐利的警察抓到，谈何容易。