查询词典 side mirror

Based on the design and fabrication principles for the high power laser reflector, an active cooling mirror was adopted to improve the beam quality by reducing the mirror thermal distortion which can control the mirror distortion less than 0.1 μm.

根据高功率激光反射镜的设计和制作原则，对反射镜的材料性能进行了分析，采用主动水冷铜镜来减小镜面热畸变使镜面变形控制在0.1 μm以内。

One- dimensional photonic crystal omnidirectional reflector is a perfect mirror without the limits of metal mirror and multi- layer dielectric mirror.

在总结金属反射镜及多层介质反射镜的优缺点的基础上研究一维光子晶体全角度反射器件。

Mirror 4 is just a flat mirror like Newtonian telescope's secondary mirror, to give convenience for eyes.

镜4只是一块平面镜，就像牛顿式望远镜的副镜一样，方便观测

Mirror 4 is just a flat mirror like Newtonian telescope's secondary mirror, to give convenience for eyes.

镜4只是一块平面镜，就象牛顿式望远镜的副镜一样，方便观测

After all of these six changes have been carried out on one side of the palate,the operated side becomes completely relaxed.It can be moved both posteriorly and medially to lengthen the side of the palate and to contact with the cleft margin of the non-operated side without tension.Obviously,there is no need to perform the same surgical maneuvers on the other side again.The cleft is then closed by layers.

手术时，在腭部的一侧作完改变的六项操作以后，手术侧的腭部即彻底松弛，可以充分后退，增加该侧腭部先天不足的长度，并随意向近中侧移动，与对侧的裂缘接触，不需要在对侧再作同样的手术操作，即可将裂隙缝合。

The head is slowly turned 90° toward the side where nystagmus is induced less intensely. Then the head is rotated 180° rapidly toward the opposite side. This article reports three cases of the ageotropic form of HC-BPPV that were cured by rapid head rotation. The three cases demonstrated that rapid head rotation was an effective maneuver to treat cupulolithiasis on the utricle side. It is recommended that rapid head rotation can be used for therapeutic diagnosis: If nystagmus subsides immediately after this maneuver, the diagnosis is cupulolithias is on utricle side. If nystagmus changes into the geotropic form, the diagnosis is cupulolithiasis on canal side or canalolithiasis in the anterior arm of horizontal semicircular canal. A repositioning maneuver for geotropic form can then be applied to treat these patients.

逆地眼振型水平半规管良性阵发位置性眩晕的3种耳石可能位置如下：水平半规管前臂的管耳石、管侧的顶帽沉石(canal side cupulo-lithias1s)与囊侧的顶帽沉石，本文报告3例以快速转头治疗逆地眼振型水平半规管良性阵发位置性眩晕成功的病例，显示快速转头法对囊侧的顶帽沉石具迅速有效的治疗效果，对於逆地眼振型水平半规管良性阵发位置性眩晕的治疗，作者建议先以快速转头作治疗性诊断，若病人马上复原，诊断为囊侧的顶帽沉石；若眼振转为向地型，则诊断为水平半规管前臂的管耳石或管侧的顶帽沉石，进一步再以向地型的耳石复位法治疗病人。

Based on 3D steady and incompressible N-S equation and k-ε turbulent model, the aerodynamic performance of three different design options of 160 km/h container flat wagon was analyzed and compared using finite volume method. The three design options are as follows: the first design option has no headwall and the side surface of side beam is flat; the second and the third both have headwall and high side beam, and the side surface of side beam of the second is obtuse, while the third is cambered.

基于三维、不可压、定常N-S方程和k-ε双方程湍流模型，采用有限体积法对3种不同设计方案在运行时速为160 km/h的集装箱专用平车在有、无横风情况下的气动性能进行分析与比较，其中：方案一的平车无端墙，侧梁侧面平直；方案二和三的平车均加有端墙，且侧梁加高、侧面形状分别为钝形和弧形。

Based on 3D steady and incompressible NS equation and kε turbulent model, the aerodynamic performance of three different design options of 160 km/h container flat wagon was analyzed and compared using finite volume method. The three design options are as follows: the first design option has no headwall and the side surface of side beam is flat; the second and the third both have headwall and high side beam, and the side surface of side beam of the second is obtuse, while the third is cambered.

摘 要：基于三维、不可压、定常 N S 方程和 k ε双方程湍流模型，采用有限体积法对3种不同设计方案在运行时速为160 km/h的集装箱专用平车在有、无横风情况下的气动性能进行分析与比较，其中：方案一的平车无端墙，侧梁侧面平直；方案二和三的平车均加有端墙，且侧梁加高、侧面形状分别为钝形和弧形。

A machine component comprising: an elongated base plate with side edges, a linear actuator assembly having two parts which can move away from and toward each other, first mounting means on said base plate, said mounting means supporting one part of said assembly, a slide plate rectangular in cross-section and having parallel straight side edges, two elongated guide members each having a rectangular slot adapted to slidingly receive the edge of the slide plate, each elongated guide member including a lowerpart and an upper part and means for securing them together, the lower part having means for attachment to the base plate, said rectangular slot having (1) a first side wall adjacent to and parallel with the base plate, said first side wall being definedby a surface of said lower part,(2) a second side wall defined by a surface of said upper part, and (3) a bottom wall defined by a surface of one of said upper and lower parts, the upper and lower parts having oblique mating surfaces such thatlongitudinal meovement of one part with respect to the other causes the parts to separate from or approach each other in a manner to change the width of said slot, and second mounting means establishing a connection between the slide plate and the other part of said assembly.

有一长条形底座与身边的边缘，一个线性驱动器装配有两个部分，可以离开，彼此之间，首批意味着在说底座、说安装方式支持之一说总成，一个矩形截面板、平行直边棱、两种细长的引导会员都有一个矩形槽适应slidingly收到边缘的细长板，每一个lowerpart引导会员包括一个上方和手段，确保他们在一起，下方附件的方式，在底座，说矩形槽有(1)第一次侧墙毗邻，平行底座，一边说：definedby墙表面说下方，(2)第二次侧墙表面的定义，并说上方(3)底壁由一个表面的上部和下部零件，说上部和下部阀部件表面的thatlongitudinal拥有斜meovement这样的一部分的原因部分可以分离或接近对方的方式来改变宽度的槽，第二次安装方式，建立连接板之间，另一部分说总成。

The crushed rock in the side abutment weakens the side restriction while the side wall and the apron strengthen the side restriction. The analysis showed a new stress distribution with automatic modification and less stress concentration when the side restriction is weakened by using crushed rock in the abutment.

结合某碾压混凝土拱坝的拱座，在减弱和加强侧约束时，即在坝体部分高程的破碎软弱岩石减弱坝体侧约束以及坝体下游边墙和护坦增强坝体侧约束的情况下，研究侧约束对于坝体应力和位移的影响。

Cable dampener cannot be rolled up but must be hung over the cable.

缆帆不能被卷起，必须保证处于展开状态

"This skylark is a present from my master," he says.

"这只云雀是我主人献上的礼物。"他说。