查询词典 shock

The static model of torsion joint is based on that of bending joint. The effects of structure parameters inside air pressure, initial angle, rube average radius, rube shell thickness on the turning angle are analyzed and the following conclusions are drawn: the relationship between the angle of torsion joint and the inside air pressure is basically linear, the angle of torsion joint increases with the initial angle and rube average radius, the angle of torsion joint decreases while the rube shell thickness increases. The kinetic equation is built for torsion joint. Simulating experiment implies that the time of inflating and deflating process is extremely shorter than that of kinetic process. So the pneumatic process can be ignored in actual system design and control. The factors that affect the dynamic features of torsion joint, such as shell thickness of rubber tube, average radius, initial angle, connector's outlet area, moment of inertia and viscous damping coefficient, are analyzed and the following conclusions are drawn: the change of rube shell thickness has no effects on the dynamic process of FPA inside air pressure while greatly affects the turning angle of torsion joint; when the rube shell thickness is small, the torsion joint has a bigger turning angle, no overshoot and long risetime, when the shell thickness is big, the turning angle of torsion joint is small, but has high response speed, overshoot and low shock; when the rube average radius increases, the turning angle of torsion joint increases and the overshoot increases too; when the initial angle of torsion joint is big, the turning joint is big, the overshoot is small and shock is low, but the risetime is big; the connector's outlet area affects the dynamic process of FPA inside air pressure greatly, but has no effects on the dynamic process of turning angle; moment of inertia and viscous damping coefficient have no effects on the dynamic process of FPA inside air pressure, but affect the dynamic process of turning angle greatly.

在弯曲关节模型推导的基础上，建立扭转关节的静态模型，并分析了扭转关节内腔压力，初始转角，橡胶管平均半径，橡胶管壁厚等参数对关节转角的影响，得出扭转关节的转动角度与充入FPA内腔的压缩气体压力之间基本呈线性关系，扭转关节的转角随初始角度和橡胶管平均半径的增大而增大，扭转关节的转角随橡胶管壁厚的增大而减小的结论；建立了扭转关节的动力学方程，仿真实验表明FPA的充放气过程与扭转关节的动力学过程相比时间极短，在实际系统设计和控制过程中可以忽略不计；分析讨论橡胶管壁厚，平均半径，初始角度，气体节流口面积，转动惯量，粘性阻尼系数等因素对扭转关节动态特性的影响，得出橡胶管初始壁厚的变化对扭转关节FPA内腔压力的动态响应几乎没有影响而对关节转角的响应曲线影响比较明显，壁厚较小时，关节可以得到较大的转角，并且转角的响应曲线没有超调，但上升时间长，壁厚较大时，关节转角变小，响应加快，但是有超调和轻微振荡现象，橡胶管平均半径越大，得到的关节转角越大，但是转角响应的超调量也随之增大，FPA的初始角度越大，关节的转角越大，并且超调量减小，振荡减弱，但是上升时间增大，管接头出口面积的大小对关节FPA内腔压力的建立过程影响较大，但对关节转角的动态响应几乎没有影响，转动惯量和粘性阻尼系数对FPA内腔压力的动态过程几乎没有影响而对扭转关节转角有较大影响等结论。

Later, scholars did sophisticated researches on SVAR, and used them to anglicize real shock and monetary shock's transition mechanism.

此后，人们对SVAR进行了深入的研究，并广泛用于分析实际冲击和货币冲击的传导机制。

The increase of excitatory amino acids in cortex may be induced by endotoxic shock and may play an important pathophysiological role in the development of shock.

内毒素休克可引起脑兴奋性氨基酸含量的持续过度增加，由此而导致的脑功能改变可能在休克发展及转归中起重要的病理生理作用。

However, the DBT temperature of notched specimen by shock waves treatment in impact toughness test is increased, which is believed to be caused by the shock induced decreasing of crack forming energy in the material.

文章还发现冲击波引起材料在脆性转变温度下缺口试样的裂纹形成功的下降是造成以缺口冲击韧性表征的脆性转变温度升高的主要原因。

It is found that the time required for the shock formation can be affected by the initial plasma temperature, which influences the energetic proton generation in the shock.

观察到不同的等离子体初始温度会影响靶前激波的产生时间，进而影响质子产额。

HSP90P can be induced by both heat shock and PHA, HSP90α can not be induced by PHA, but it is more sensitive to heat shock induction than that of the HSP90PWe have reported elsewhere that the regulatory mechanisms for the expression of hsp90a and hsp90P are different.

这两种基因的转录调控机制不同，第一内含子对hsp90β基因的基础转录必不可少，并且对该基因的热诱导表达也非常重要。

Based on the nonlinear dynamical equation of product packaging system,the shock spectra and the damage boundary curve of tangent nonlinear packaging system under the action of half-sinusoid pulse are obtained using a numerical method,and the influence of various factors on shock response is discussed.

采用数值求解单自由度产品包装系统的非线性动力学方程，得到了半正弦波冲击下正切型非线性包装系统的冲击谱曲线和边界破损曲线，讨论了相关参数对它们的影响

The main product in company has:Hand electric drill,pound at the electric drill and give or get an electric shock the,Cape face to dub out the machine and give or get an electric shock to plane,fix the side machine,The material of incises the,electricity buzz saw,molding tool electricity whets the etc.,and have passed the ISO9001 quantity system attestation,acquiring the Chinese electrician the product committee the Great Wall attestation,And common in the state of electrician product committee GS,CE,EMC attestation etc...

公司主要产品有：手电钻、冲击电钻、电锤、角向磨光机、电刨、修边机、石材切割机、电圆锯、模具电磨等，并已通ISO9001质量体系认证，获得中国电工产品委员会长城认证，及欧洲共同体电工产品委员会GS，CE，EMC认证等。本公司不断致力于新产品的开发，以满足日益增长的市场需求。竭诚欢迎国内外新老客户光临洽谈、精诚合作、共创辉煌明天。

Methods:The diagnostic accuracy for severe PPH by the measuring amount of blood loss was compared with shock index or measuring of blood loss combined with shock index in 69 cases.

结果 ：测定出血量和休克指数的符合率分别为 5 9 42 %和 6 9 5 6 %，均显著低于测定出血量结合休克指数的 89 6 8%(P 0 1)。

The several kinds of Ag-NiFe2O4 cermets with different mass percent of Ag have prepared. Microstructural changes were observed by scanning electronic microscope and composition was determined with x-ray detector. Effect of different content of Ag on the density, property of thermal shock,conductivity and corrodent rate were tested. The results showed that the thermal shock performance and conductivity have improved in company with the addition of content of Ag.

制备了不同金属Ag含量的Ag-NiFe2O4金属陶瓷，利用扫描电子显微镜观察显微组织，由X射线衍射分析化学成分，研究了Ag的添加量对其体积密度、气孔率、热震性、导电率以及腐蚀速率的影响，试验结果表明，抗热震性和导电能力随着Ag含量的增加而增强，导电率的提高和腐蚀率的增大仍是一对突出的矛盾。

He is the most remarkable man that I have ever known.

他是我知道的人中最值得注意的人。

Increased appearance of lymphocele was noticed in patients with diabetic nephropathy, congenital malformations of the urinary tract, and inflammatory diseases, including glomerulopathy and extraglomerular ones, after high-voltage radiotherapy and after removal of the renal graft.

经过高压放射疗法和切除移植肾后，在糖尿病肾病患者、泌尿系统先天性畸形患者和炎症患者身上发现淋巴囊肿有所增加，包括肾小球病和球外疾病等。