查询词典 shearing strength

These tests include colour fastness to rubbing/crocking, light, perspiration, water, chlorinated water and seawater; strength tests, namely of tensile strength, tearing strength, seam strength, slippage characteristics, bursting strength etc.; pilling resistance; oil repellence; soil release; air permeability; water vapour permeability; abrasion resistance; water repellence; zipper strength, durability and operability; velcro shearing and peeling; snap fastener security; and the corrosion of metallic finishes, etc.

这些测试包括磨擦、日晒、汗液、水、氯水和海水的色牢度；强度，即拉伸强度、撕裂强度、接缝强度、滑移特性、破裂强度等；抗起球特性；防油性；防污性；透气性；水气通透性；耐磨性；防水性；拉链的强度、耐用性和运作顺畅性；尼龙搭扣剪切力和剥离力；按扣强度；金属饰物的耐腐蚀性等。

Based on the existing 3-D mechanical equation of drill string, considering the influence of lateral shearing strength and shearing strain on flexural deflection of drill string, the universal basic equations for the shearing deformation of drill string are established according to the deformation and force characteristics of the drill string.

该公式综合描述了横向剪切变形和轴向钻压对钻柱横向振动固有频率的影响，是对现有钻柱力学基础理论的补充和完

This research shall be obtain that ocean-sand motor shall have more compressive strength early, but later strength shall descend, by means of non-standard sand mixing sample is quite obvious. By means of 50% ocean-sand substitutes for river-sand to mix fine aggregate compressive strength early shall be risen 20%~30%; Adds slag to ocean-sand or a half of river-sand and ocean-sand to make motor test sample, Compressive strength、bending strength and tensile strength shall be according to slag additament, by means of. slag add itament substitutes for cement 40%~60% is most. But slag be able to substitute for cement is too enough, 1ater strength shall be descent.

由本研究可得知海砂拌和的水泥砂浆，其早期抗压强度较高，而晚期强度则有下降的趋势，其中以非标准砂拌和效果最为明显；若以50%海砂替代河砂做为拌和细骨材，其早期抗压强度约上升20%~30%；添加炉石於海砂或河砂、海砂各半的水泥砂浆，其抗压、抗弯及抗拉强度，会随著炉石添加量增加而增加，其中以40%~60%炉石替代量为最佳，但是炉石替代量过高，晚期强度会下降；在相同水灰比状况下以海砂拌和水泥砂浆做比较，以非标准砂拌和有较高的抗压强度，其强度约比标准砂高10%左右。

The handtailor nourishes the tonic: Four team's members necessary, it is said can let the human who was already utterly exhausted become the vigor abundant medicine Sword eight: The generation seals gives the strongest god of death the title Alone blinkers eyeshade: The technical development bureau manufacture may unlimited absorb the spirit strength unceasingly the monster, the sword eight uses it to constrain own strength and to store up its spirit strength Shakes the spot: The anaesthetic, the spirit presses the low person so long as stains can remain unconscious, but does not have the function to the spirit strength excel in person Puts on/to collapse the spot: Strong effect anesthetic, even if the spirit strength excel in person also with difficulty resists The day treads gorgeously: So long as pours into the spirit strength to be able in the sky soaring, is the corpse soul unique precious stage prop Energetic body: The secret mobile most important special spirit has one above, thus can cut the soul knife the main body to force the extension to absorb obtains the embodiment Handcuff: May seal up criminal's spirit strength The secret is mobile: The explanation did not have temporarily, found said again Garrulous bee: The bee ninth generation teaches other people, in six brother younger sister's sixth human of bee tree top damask silk, after joins the punishment armed forces the given name which inherits from her great grandmother there Punishment armed forces: The secret mobile first division, is completely in five division's highest organizations.

特制滋养强壮剂：四番队的成员必备，据说能让已经疲惫不堪的人变得活力充沛的药剑八：世代封予最强死神的称号独眼罩：技术开发局制造的可以无限制不断吸收灵力的怪物，剑八用它来压抑自己的力量并将其灵力储存起来震点：麻醉药，灵压较低的人只要沾上一点就会昏迷不醒，不过对灵力高强的人没有作用穿点/崩点：强效麻醉剂，即使灵力高强之人也难以抗拒天踏绚：只要注入灵力就能在天空飞翔，是尸魂界独一无二的珍贵道具精神体：隐秘机动最重要的特殊灵具之一，能将斩魄刀的本体强制转摄其上从而得到具像化手铐：可以封住犯人的灵力隐秘机动：解释暂无，找到了再说碎蜂：蜂家第九代传人，六兄妹中的第六人蜂梢绫，加入刑军后从她曾祖母那里继承来的名号刑军：隐秘机动第一分队，是全部五分队中的最高机构。

Strength properties are commonly referred to as tensile strength, compressive strength, bending strength, torsional strength, shear strength and fatigue strength.

力量特性通常被称为抗拉的力量，压缩的力量，弯曲力量，扭转的力量，剪切强度和疲劳强度。

Strength is the ability of a metal to as tensile strength,bending strength,compressive strength,torsional strength,shear strength and fatigue strength.

强度对于金属而言的能力就可以说是拉伸强度，弯曲强度，抗压强度，扭转强度，剪切强度和抗疲劳强度。

In this project, the selection criteria of matrix and reinforcement for obtaining composites with high strength and toughness are determined. The as-cast and aged microstructures of composites reinforced with particles of different strength are observed, and their metallurgical conditions and stabilization mechanisms are analyzed. The aging precipitation behaviors and mechanisms are studied. Some characteristics of nano-materials (micro-distortion areas) are found in 150nm- Al2O3p/Al composites and their formation mechanisms are expatiated. The "flexible" restriction to the deformation of the matrix by low strength AlN particle is observed by in-situ TEM and SEM techniques, and the mechanisms of its resist on cracks propagation and its contribution to composite strength are revealed. The high temperature deformation behaviors of Al2O3p/Al composites are studied. A rare-earth coating is established on sub-micron Al2O3 particles, leading to an improvement in wettability between coated Al2O3 and liquid aluminum and a decrease in infiltration pressure. The strength and ductility of coated particles reinforced composite are also increased. The interfacial characteristics, bonding structures and their formation mechanisms are studied, and the crystal orientation relationships between reinforcement particles and aluminum matrix are investigated. Finally a lighter composite with better balance of strength and damping properties is reinforced with hollow ceramic microballoons of ultra-lower strength.

本项目发现了获得高强度和高韧性复合材料的基体、增强体选择依据；观察了各种强度质点增强复合材料的铸态和时效态微观组织，分析其微观结构形成的金属学条件及稳定性机理，研究了其时效析出规律和时效机制，发现了150nmAl2O3颗粒增强铝基复合材料基体中的纳米材料特征，并解释了其形成机理；利用TEM和SEM动态拉伸技术发现了低强度质点AlN颗粒对变形协调的&柔性强化&机制，揭示了其对裂纹扩展的阻碍作用和对复合材料高强度的贡献；研究了中强度质点的Al2O3颗粒增强铝基复合材料的高温变形行为，并对其进行了稀土界面层设计与制备，改善了颗粒与铝合金之间的界面润湿性，降低了复合材料铸造渗透压力，提高了复合材料的强、韧性；研究了多种复合材料界面结构及形成机理，确定了增强体与基体之间的界面结合机制，分析了复合材料界面处的晶体学位向关系；最后制备了含微孔的中空型陶瓷颗粒增强的特种复合材料，得到了强度和阻尼综合性能较好的轻质复合材料。

The results show that: the tensile strength, flexural strength and flexural modulus increase by about 10.4%, 62.1% and 122.3% respectively when the mass fraction of the aluminum powder increases from 0 to 50%, while elongation at break and impact strength decrease by about 65.0 and 74.4% respectively; the tensile strength, elongation at break and impact strength all increase with decreasing the particle sizes of the aluminum powders.b Nylon-12 coated metal powders for the indirect SLS process were prepared by the dissolution precipitation process. The coated powders have only 1.0 wt% nylon-12, and their SLS green parts have sufficient strength for features as small as 1.0 mm to be built and post-processed and high dimensional accuracy. The green parts were subjected to the post processing processes including binder decomposition and infiltration of epoxy resin, and then the metal/polymer composite parts with relatively high strength and accuracy were formed.At present, micron-scale inorganic fillers have been widely used to reinforce nylon SLS parts.

将该法制备的尼龙12覆膜金属粉末用于以下两个方面：a使用铝粉增强尼龙12的SLS成形件，通过溶剂沉淀法制备尼龙12覆膜铝复合粉末，研究了铝粉含量及粒径对SLS成形件性能的影响，结果表明：铝粉分散均匀，并与基体有良好的界面粘接；当铝粉含量从0增加到50wt％时，成形件的拉伸强度、弯曲强度、弯曲模量分别提高10.4％、62.1％和122.3％，冲击强度和断裂伸长率下降65.0％和74.4％，耐热性及尺寸精度也得到提高；断裂伸长率、冲击强度及拉伸强度均随着铝粉粒径的减小而增大。b使用溶剂沉淀法制备了间接法SLS用尼龙12覆膜金属粉末，该覆膜粉末中聚合物粘接剂的含量仅为1.0 wt％，其SLS初始形坯具有较高的精度以及足够满足后处理要求的强度，最小精细结构的尺寸达1.0 mm。

Through comparing the relation of APA test and shearing test, it put forward the maximal to allow shearing strain of RSCH test:?max, the maximal repetitive shearing times: Nmax and minimum to allow APA rutting dynamical stability, which is comparatively suitable to examine the high-temperature performance of the asphalt mixture.

通过比较APA 试验与剪切试验的关系，提出采用RSCH 试验最大允许剪切应变γmax、最大重复剪切次数Nmax 以及最小允许APA 车辙动稳定度，来检验沥青混合料的高温性能是较为合适的。

Through studying the working mechanism of the composing, the paper referred the bearings analyzing model and designing flow.Through shearing test of high damping rubber ,the paper analyzes the influence of shearing shape, shearing strain range and inspiriting frequence on the characteristic parameters(dynamic shear elastic module , dissipation engineering module , wasted gene ).

本论文通过对这种分离式减震支座各组成部分工作机理的研究，提出了该分离式减震支座整体的计算分析方法和设计流程；通过高阻尼橡胶剪切试验，分析了高阻尼橡胶剪切面形状、剪应变幅值、激励频率和试件高度对特征参数(动态剪切弹性模量、耗能模量、损耗因子)的影响。

We are forbidden from giving money to these shoeless, skinny children, as this will perpetuate begging.

向光着脚，骨瘦如柴的孩子施舍是不可以的，因为要招来无休无止的乞讨。

It would be hard not to fall victim to some sharpeyed policeman.

要想不被某个目光锐利的警察抓到，谈何容易。