查询词典 shearing force

Therefore, it was necessary to study the shearing test standards for different size of asphalt mixture. The test parameters, shearing stress coefficient for different nominal size were determined.

为此，对适应不同公称粒径的沥青混合料抗剪试验标准进行了探讨，并确定了适用于不同公称粒径的试验参数和剪应力系数。

The numerical simulation of two-phase flow field in the reactor is carried out in this paper. The distribution of shearing strength in the channel is systematically obtained:① The shearrates of wall, vortexcore, vorticity and non-vorticity regions are descending sort.② With Re number increasing, the average of shearing strength becomes linearly increasing tendency in the back step expand channel.

通过对涡旋波膜生物反应器中的两相流流场进行数值模拟，系统地研究了反应器内的剪应力的分布规律：①壁面、涡心、旋涡生成处及非旋涡生成区的剪切应变依次降低；②随着Re数的增大，扩张区内剪应力的平均值呈线性增加趋势。

Methods With non - surgery elderly CHD patients at the stane periods as control,the whole blood viscosity and whole blood reduction viscosity were determined under three different shearing stress conditions ( 150s-1 ,60s- 1 and 10s- 1 )by NXE - 1 weissenberg wiscosimeter, plasma viscosity was tested under middle shearing stress condition, and the hematocrit was also determined by rourine method.

方法以NXE-1型椎板粘度计在150s-1、60s-1和10s-1 3个不同切变条件下测定老年冠心病手术患者的全血粘度、全血还原粘度，在中切变条件下测定血浆粘度，以常规方法测定血球压积。

It simulation results proves that when the inner pipes in the concentric annulus pipes stand still, the turbulent flow nucleus area approaches inner pipes; and when inner pipes circumvolve, the turbulent flow nucleus area approaches outer pipes. The shearing velocity near the inner pipes is the biggest, and the shearing velocity increases with the velocity of the inner pipes increasing.

模拟结果表明：在同心环空管道中当内管静止时，紊流核心区即轴向速度最大值区域靠近内管壁；当内管旋转时，紊流核心区即轴向速度最大值区域靠近外管壁；靠近内管壁处的切向速度最大，且随着内管转速的增加切向速度增大。

The thermal depolymerization of crumb rubber–asphalt system could be controlled by using the coadjustment of shearing temperature and shearing time.

可以通过剪切温度和剪切时间的互补关系实现可控降解。

Periphery shearing with single mandrel ,was studied kinematically to reveal the mechanism of shearing deformation in metal.

介绍钢管圆周剪切的另一种方法──单芯棒圆周剪切法。

At a constant shearing rate,the influences of montmorilonite loading on the shearing stress and apparent viscosity were similar.The reduction of the viscous activation energy with the increm...

PA611/蒙脱土纳米复合材料的粘流活化能随剪切应力的增大而降低，说明在恒定剪切应力下其可在较宽的温度范围内加工、成型。

In ECAP route C, in order to accommodate the severe shear deformation the deformation form of lamellae cementite in pearlitic steel include periodical bending, periodical shearing and shearing fracture etc .

在C方式ECAP变形中，珠光体钢65Mn中的渗碳体以周期性的弯曲变形，周期性的剪切变形，剪切断裂等形式协调ECAP的强烈塑性变形。

It was considered that the control of the PRD fluid performance and the dosage of flow pattern adjusting agent PF-VIS were the key of the technique. The viscosity of PRD spudding fluid increased rapidly with the decrease of shearing rate, it indicated that it had good sand carrying ability. The spudding fluid was good capacity of high temperature stability under the low shearing rate, its viscosity was much higher than that of traditional drilling fluid, it was beneficial for cutting carrying in big deviated wells and preventing the formation of cutting bed.

认为要控制好PRD弱凝胶钻开液的性能，流型调节剂PF-VIS的加量是关键；PRD弱凝胶钻开液的粘度随着剪切速率的降低而急剧上升，显示了其优良的井壁携砂带砂性能；PRD弱凝胶钻开液体系具有较好的高温稳定性；PRD弱凝胶钻开液体系在低剪切速率的高粘度，大大高于传统聚合物钻井液，有利于在大斜度井携带岩屑以及防止岩屑床的形成。

At here, based upon designing idea of the shearing planes of left and right two shears are at ±45° with respect to main transmission plane and the combination with changeable structure, the shearing mechanism of two mutually twisted flat screw wires was designed.

在此，基于左右两把剪刀的剪切平面相对于主传动平面成±45°，以及与变结构相结合的设计理念，设计出了两根互绕扁螺旋钢丝的剪切机构。

The small blue capacitor has very high chances to go fully shorted compare to electrolytic capacitor which is very rare.

小蓝电容器具有很高的机会去充分地缩短了比较电解电容器，这是非常罕见的。

In the Italian campaigns of 1513 and 1515, when the Swiss won the victories of Novara and Marignan, he acted as army chaplain.

在意大利的运动， 1513年和1515年，当瑞士赢得了胜利，诺瓦拉和marignan ，他担任军队的牧师。