查询词典 sectional-continuous function

Since Jegadeesh and Titman (1993)and DeBondt and Thaler (1985) respectively documented the short-run cross-sectional momentum and the long-run cross-sectional reversal in stock returns, more and more anomalies had been found gradually.

自Jegadeesh和Titman(1993)与DeBondt和Thaler(1985)分别发现，股票收益率序列存在着明显的&惯性&与&长期反转(long-run reversal)&等截面市场现象后，越来越多的收益率&异象&被逐步证明。

Results of pulling test reveal that the nominal strength ratio of corroded hot-rolled steel bar over uncorroded one is approximately equal to the ratio of maximum residual sectional area over the uncorroded one.And the rupture extension ratio of corroded hot-rolled steel bar is exponentially decreased with the maximum sectional loss ratio.The effect of stress concentration caused by corrosion pits has a significant influence on the decrease of rupture extension ratio but it is ignorable on the nominal strength ratio.

实验结果表明：锈蚀钢筋与未锈钢筋的名义强度比可近似取锈后钢筋的最大残余面积率，受锈坑应力集中的影响甚微；锈蚀钢筋的断后延伸率随最大截面损失率呈指数下降，受锈坑应力集中的影响显著。

If a phototypesetter is an intermittence type, the memory of controller is used only to buffer a section and the buffer of whole page lattice is unnecessary. If a phototypesetter is an uninterruption type, a section of lattice is only generated and buffered for every time and then be converted into black-white sectional information, whose information quantity is much less, by microprogram for buffering whole printed sheet. On scanning, the black-white sectional information is real-restored into lattice to output.

当照排机是&走走停停&类时，控制器的存储器只需缓冲一段，而不必缓冲整版点阵；当照排机是&不许停顿&类时，则用分段方法每次只生成一段点阵并缓冲，然后用微程序把这一段点阵转换成信息量少得多的黑白段信息作整版缓冲，扫描时在实时下把黑白段信息复原成点阵输出。

Through analyzing the work characteristic and the work mechanism of the interface in this research paper, bonded rebar technique is applied to the bonding treatment of the interface, the reformative method of enlarging sectional areas is proposed, and the work mechanism of the anchor bar in the interface is analyzed. The work mechanism of the reformative method of enlarging sectional areas and the interface mechanical performance have be more systematical analyzed and studied with the finite element numerical simulation method, the structural testing method, and combing project practice. Based on that, the suggestion formula of shear and tension bearing capacity for the old and new concrete is put forward.

本研究论文通过分析新旧混凝土界面的工作特点及工作机理，将化学植筋技术应用于新旧混凝土界面的粘结处理，提出改进的加大截面加固法，分析了锚筋在新旧混凝土界面上的工作机理；运用有限元数值模拟方法和结构试验方法，并结合工程实践，对改进的加大截面法的工作机理及界面受力性能进行了较为系统的研究分析，提出了新旧混凝土抗剪、抗拉承载能力的建议公式；根据研究结果，提出了改进加大截面法的设计原则和施工工法，并在工程应用中取得了良好的效果。

Aiming at the problem of buckling stability capability of box section hoist boom of wheel crane, a complete section of hoist boom is taken as analysis object and buckling instability of the webs is analyzed and researched with the booms of different sectional shapes by applying finite element analysis method. Compared with crane design code (GB3811-83), one piece of plate is taken to calculate buckling stability, the method is easier and more accurate and calculation and analysis of complicated sectional shapes are easy to conduct.

针对轮式起重机箱型起重臂的抗屈曲失稳能力问题，采用有限元分析方法，取起重臂截面半波长段作为分析对象，对相同工况不同截面形状的起重臂的屈曲失稳情况进行分析研究，相对于起重机设计规范(GB3811-83)给出的取一块板进行屈曲计算要快捷、准确得多，而且也容易完成对复杂形状截面的计算分析。

Results The fibular proper plantar arteries and nerves longitudinal and transversal sectional average diameters were longer then 0.43mm and 0.65mm respectively. Those of the tibial proper plantar arteries and nerves longitudinal and transversal sectional average diameters were 0.55mm and 0.58mm respectively.

结果 趾跖腓侧固有动脉和神经纵径和横径的平均值分别大于0.43 mm和0.65 mm，趾跖胫侧固有动脉和神经纵径和横径的平均值分别为0.55 mm和0.58 mm。

A series of structural variables,including femoral neck cross-sectional area,cross-sectional moment of inertia, HAL,section modulus and FSI were assessed automatically with hip strength analysis DXA software.

其中90名女性受试者(年龄20～71岁，平均49.6岁)同时行定量超声跟骨强度测量，测量参数包括超声传播速度、宽频超声衰减值和跟骨强度指数。

Firstly, this paper investigated roundly the basic theory of the ambient vibration method, analyzed systematically the main methods of ambient vibration identification, and discussed their advantages and disadvantages. Then we established the finite element model of structural dynamics and test model and analyzed their mutual relation, improved MUSIC method and correlation function method in the harmonic identification, and gave the subspace method and correlation function method based on continuous model, which is multi-harmonic retrieve technique. And then, this paper also puts forward least-squares method to estimate directly structural physical and modal parameters; this approach replaced the derivative operator in the continuous time model with an equivalent approximation, and estimated the physical parameters of structures by the least-squares method. And then, we discussed the approximation methods of derivative and their convergence. Finally, this paper researched the modal parameters of a frame structure by the simulation and test. The results demonstrated that subspace method, correlation function method and the least-squares method are effective and stable respectively.

全面地研究环境振动识别方法的基本理论，系统地分析环境振动识别方法的主要方法，讨论它们的优点和不足；建立结(来源：6666AB44C论文网www.abclunwen.com)构动力学的有限元模型和试验模型，分析有限元模型与试验模型之间的相互关系；改进谐波识别中的MUSIC识别方法和相关函数识别方法，给出大型结构模态识别的连续型的子空间分解识别方法和相关函数识别方法，这个方法是多元谐波识别方法；提出直接识别结构的物理参数和模态参数的最小二乘方法，这个方法利用导数的近似值代替导数值，并运用最小二乘方法识别结构的物理参数，讨论导数近似值的选择方法，分析算法的收敛性；通过仿真计算和模型实验，研究高层框架结构的模态参数识别，验证子空间分解识别方法、相关函数识别方法和最小二乘识别方法的有效性，算法的稳定性；从理论和试验两个方面分析和研究噪声对识别精度的影响，影响识别精度的因素，以及部分模态成分的模态参数不能够被识别的原因。

Simple step function, discontinuous function characterized by continuous segments between points of discontinuity and continuous function, and multi--type of components in a redundancy subsystem considered, a mixed integer nonlinear planning model for redundancy and reliability optimization was presented.

考虑子系统中冗余组件的多样性以及可靠性-成本之间可能的三种函数关系，即简单的阶跃函数、连续函数以及分段连续而在分段点不连续的非连续函数，建立了可靠性冗余优化的混合整数非线性规划数学模型，并以实例进行了说明。

In (1), the nonlinear function f is a known nonlinear continuous function of x , and the control gain g is a known nonlinear continuous and locally invertible function of x .

在（1）中， f是一个关于已知的非线性连续函数 x 的非线性函数，控制增益 g是关于 x 的已知的连续非线性的函数。

The French are not suggesting a new EU treaty, but they have plenty of other wheezes.

法国人并不是在建议签署一个新的欧盟条约，但他们有许多其他的阴谋。

This letter was written by my brother.

这封信是我弟弟写的。