查询词典 scraper plane

Results show that the morphology of HNS changes from short plane-like shape to long plane-like shape when non-solvent temperature changes from 25℃ to 50℃. The morphology comes through the variety of ellipsoid, short plane-like and club-shaped with pH value of non-solvent from acidity to neutral and finally basical, with the particle size distribution in 50-300 nm, 50-500 nm, and 50-600 nm, respectively. Ellipse plane-like and long club-shaped morphology HNS were obtained using white dextrine and sodium carboxymethyl cellulose as surfactants in non-solvent, with the particle size distribution in 50-300 nm and 50-600 nm.

结果表明：非溶剂温度由25℃升高到55℃后，HNS晶体形貌由短片状变为细长片状；pH值由酸性变化到中性再到碱性时，亚微米HNS的晶体形貌经历椭球状、短片状、棒状的系列变化，粒度分布分别处于50~300 nm、50~500 nm、50~600 nm；白糊精和羧甲基纤维素钠作为晶形控制剂修饰后的亚微米HNS晶体形貌分别椭圆片状和长棒状，粒度分布分别处于50~300 nm、50~600 nm。

Introduce the cohesion-friction model of rock strength theory, and extend the model to select the strength of sliding plane, discuss the variation rules of peak strength and residual strength under different normal stress, and then present the selection model of shearing strength. After the result of cohesion-friction model is compared with Coulomb Criterion, it is found that when the results of shearing strength are many and adjacent the strength parameters can not be regressed by least square method, instead the results should be divided into some beelines at that time according to the cohesion-friction model.(4) Discuss the characters of hard structural plane and weak structural plane: The adhesive friction theory is applied to research the changing course of shear area of hard structural plane and its influence on shear stress.

3介绍了岩石强度理论中的粘接摩擦模型，运用此模型分析依附型滑动面的演化过程，并将其推广到边坡岩土体抗剪强度的选取，讨论了不同法向应力下峰值强度和残余强度随法向应力的变化规律，在此基础上给出抗剪强度的选取模式，讨论了对实际取值结果的影响，并与传统的Coulomb准则进行了比较分析，指出直剪试验的法向应力在小应力区的点较多且抗剪强度结果差异不大时，不宜直接运用最小二乘法回归抗剪强度参数，此时应结合粘接摩擦模型对结果进行线性分段。

In this paper, a cube is used to denote the data-source of the video, with the interaction of the mouse, a large infinite imagined-plane is daggled to cut the cube in any directions, then it gets a cut-plane; After calculating the discrete points of the plane, the points can then be indexed to get the RGB value of the original points in the video-cube, to show the plane in the form of 2D instead of 3D.

用一个立方体表征视频帧序列数据在空间的存在形式，通过拖曳鼠标的交互作用，拖动一个假想的无限大平面任意切割该立方体，获得一个切面片；进而求解该切面片上的离散整数点，再通过这些点去索引视频立方体中对应点的像素颜色值，把该空间切面片以平面图的形式展示给用户。

The results show that the composite compound observed is mainly composed of TiC, CaS and CeS; the nucleation sequence of the phases during the solidification of the alloy is CeS→TiC→austenite; the (100) crystal plane of CeS and the (001) plane of TiC, and (100) plane of TiC and (001) plane of austenite match perfectly; CeS can act as the heterogeneous nucleating center of TiC, and TiC can act as the nucleating center of austenite.

结果表明：试样中的复合化合物主要由CaS，CeS和TiC组成；合金凝固时的形核顺序为CeS→TiC→奥氏体；CeS及CaS的(100)晶面与TiC的(001)晶面、TiC的(100)晶面与奥氏体的(001)晶面匹配良好；CeS凝固时可作为TiC的异质形核核心，而TiC又可作为奥氏体的形核核心。

Through studying the math model and "man- plane-environment" operation system model, we analysed the usage range and virtues and defects of transmitting function model of human, optimal con- trol model and fuzzy control model;After analysing "man-plane-environment" operation system, com- puter simulation, we put forward the man- plane -enviroment operation system computer simula- tion evaluation system to determine the best match between pilot and plane.

摘 要：通过对人-飞机-环境模拟仿真技术中人操作者的数学模型及&人-飞机-环境&操纵系统的数学模型的研究，具体分析了人的传递函数模型、最佳控制模型、模糊控制模型的适用范围及优缺点，并在对&人-飞机-环境&操纵系统的数学模型、性能指标进行分析后，提出了确定驾驶员和飞机之间最佳匹配的&人-飞机-环境&操纵系统计算机模拟综合评估系统，从而使人们一开始设计飞机时就考虑驾驶员作用，减少设计盲目性，缩短设计周期。

For the former, the coprocessors take care of the data plane manipulation whose load is usually much heavier than the one of the control plane, while in the latter the core processor handles the most part of packet processing, including the control plane and data plane.

就前者而言，助理处理器负责占封包处理主要工作的资料面象部分，而后者则是由核心处理器兼顾所有的控制面象和大部分的资料面象的处理。

This mobility, reduced to the vertical plane, is unsatisfactory in a scraper chain conveyor.

这流动性，减少到垂直平面，是令人不满的在刮板链式传送机。

Was established in March 2008, mainly to sales of coal as the main equipment: Mine fan, Hair Dryers Mine, mine hoist, cars, light rail, the chute, wire rope, and rolling, LED light source Miner'slamp cold, anti-explosive coal locomotive, mining scraper plane, trailing bucket ROCK LOADER, anti-explosive switches, optical instrument seized Watts, Alarm, self-help, electronic wind table, monitoring systems, mine cable, blasting - Lines, such as bus blast.

重庆市立迅矿山设备有限公司成立于2008年3月，主要以销售煤矿设备为主体：矿用风机、矿用风筒、矿用提升绞车、矿车、轻轨、溜槽、钢绳、地滚、LED冷光源矿灯、防爆煤机车、矿用刮板机、耙斗装岩机、防爆开关、光学瓦检仪、报警仪、自救器、电子风表、监控系统、矿用电缆、爆破子线、爆破母线等。

Zhucheng Shenfeng造纸机械厂main products: water pulper equipment (low concentration of hydraulic pulper, the high concentration of hydraulic pulper, D-hydraulic pulper, to drum hydraulic pulper), Refining Relief equipment (Roll-grinding machine, single-effective fiber separator, Double-Disc refining machines, high concentration of refining, Li seminal plasma horizontal plane), filter purification equipment (dual-screen drum pulse low net sieve, flow Pressure on the screen, cylindrical screen, high-frequency vibration box sieve), deinking equipment (all closed flotation Deinking machine, the trough flotation Deinking efficient machines, exhaust-Deinking machine), washed enrichment equipment (enrichment Machine, sludge dewatering machine, washing machine, screw propeller), the paper machine and ancillary equipment (toilet paper machines, pneumatic scraper, dryer, Slitter, embossing machine, pump).

诸城市申丰造纸机械厂主要产品有：水力碎浆机设备（低浓水力碎浆机、高浓水力碎浆机、D型水力碎浆机、转鼓式水力碎浆机），磨浆疏解设备（搓磨分丝机、单效纤维分离机、双盘磨浆机、高浓磨浆机、立卧式精浆机），筛选净化设备（双筛鼓低脉冲网前筛、内流压力筛、圆筒筛、高频振框筛），，脱墨设备（全封闭浮选脱墨机、方槽式高效浮选脱墨机、抽气式脱墨机），洗涤浓缩设备（浓缩机、污泥脱水机、漂洗机、螺旋推进器），纸机及配套设备（卫生纸机、气动刮刀、烘干机、分切机、压花机、浆泵）等。

Machinery blade: Paper blade, the paper knife, the paper single-pole/double-throw, from top to bottom at cutting knives, cutting knife, cut the knife, slice lamb, knives, scissors disc roller, Slitting points of the knife, bearing knives, cutting carved round Knife, knife lap, multi-bladed knife ring, copper foil crop knives, cutting board, knives, razor blades Jianban, rolling blade, cut steel knife, smash the plastic knives, Qieli knives, Qieli hob, closure at the end of knife, Bag of knives, razor blades Chongjian plane, flying scissors films, scraper, Bodao series, Gangdao tungsten film, clipart blade, the blade three holes, Qiebu knife, knife tooth, like cloth Caidao, non-standard blade may be set System.

机械刀片有：切纸刀片，分纸刀，分纸单刀，分切上下刀，切光刀，切管刀，羊肉切片刀，圆盘滚剪刀，纵剪分条刀，轴承刀，切刻圆刀，光刀圈，多刃刀圈，铜箔裁切刀，线路板裁切刀，剪板刀片，轧钢刀片，钢筋剪断刀，塑料粉碎刀，切粒刀，切粒滚刀，底封刀，制袋机刀，冲剪机刀片，飞剪刀片，刮刀，薄刀系列，钨钢刀片，美工刀片，三孔刀片，切布刀，齿形刀，样布裁刀等，非标刀片可定制。

I was just taking her hand, to help her out of a car, and I knew it.

我只是握着她的手，扶她下车，但我知道这一切。

China and South Korea have excoriated Japan over its approval of new school books which they say whitewash the atrocities committed during Japanese occupation, and anti-Japanese protests have been held in Chinese cities. The lingering bitterness over Japan's past imperialism still threatens to mar relations between the big East Asian powers

中国和韩国强烈谴责日本通过新的中学历史教科书，他们认为这一教科书掩盖了日本在其占领期间所犯下的残酷暴行，反日抗议活动在中国数座城市发生，历史上日本帝国主义制造的痛楚无法被忘却，这有可能破坏东亚强国间的关系。