查询词典 right angle

A slim azimuth 20 independent-arm caliper logging tool;2. Design of TFY-1 universal azimuth jointer with a restrained gyroscope;3. The pit shaft parameters of the elevation angle,the azimuth angle,the tool of facial angle and so on are obtained after the computation.

陀螺测斜技术以动力调谐速率，陀螺测量地球自转角速率分量和石英加速计测量地球加速度分量为基础，经计算得出井筒的倾斜角、方位角、工具面角等参数。

A new kind of dynamic model was presented based on Lagrange theorem. The steering angle, tilting angle and the pitching angle are taken as the inputs of the model.

基于拉格朗日方法提出了以转动车把的控制量、调整后轮驱动速度的控制量和调节机器人重心的控制量作为输入量的自行车机器人的3输入3输出的非线性动力学模型。

Based on constraints to angle-of-fall for cruise missiles, the variable structure terminal guidance law was designed for limiting the angle of fall in longitudinal and lateral directions. Thus the missile can be kept in desired azimuth and angle-of-fall for attacking the target efficiently.

针对巡航导弹落角限制的要求，分别对纵向和侧向两个通道设计出了限制落角的变结构末制导律，可以使导弹在期望的方位以期望的落角打击目标。

Results:① The distance between handle of malleus and stapes head was(2.38±0.19)cm(2.00～2.70cm), the point selecting for measuring was outer margin of handle of malleus and stpes head.②The cross section form of one_third of the handle of malleus at the end, was triangle, the anteroposterior diameter of handle of malleus was(0.79±0.12)mm, the exterior and interior diameter was(0.58±0.10)mm at the crook point,the angle of line of manubrium mallei laid(83.24±8.33)°(66～98°)posteroinferior to arch of zygoma.③The long axis of prosthesis formed(27.60±1.75)°(24.6～30.2°)angle with the perpendicular of stapes.④The dependablity between the malleus_stapes distance and transverse diameter of tympanum, the location of umbo in tympanic membrane, the diameter of manubrium mallei, angle of line of manubrium mallei and arch of zygoma were not statistically significant.

结果：①锤_镫距离最短为(2.38±0.19)cm(2.00～2.70cm)，测量点为锤骨柄末端1/3处外缘和镫骨头；②锤骨柄末段1/3横断面形状接近三角形，弯曲处前、后方向直径为(0.79±0.12)mm，内、外方向直径为(0.58±0.10)mm；锤骨柄与颞线的成角为(83.24±8.33)°(66～98°)；③赝复物长轴与镫骨垂直方向成角平均为(27.60±1.75)°(24.6～30.2°)；④锤_镫距离与鼓室横径、鼓脐在鼓膜上的位置、锤骨柄直径、锤骨柄的方位的可能相关因素之间相关性检验无统计学意义。

In this paper it is given a more effective formula about the direction angle of the main plane in the plane stress state.2. To introduce the principle and method for drawing 3-D graph with the compuer and for checking up with the computer cursor,to give outline of expressions of 3-D curve,outline of cursor meterage of well depth,well deflection angle and direction angle at any section.

介绍了在实践中总结出的计算机绘制与光标检测3维图形的原理和方法，给出了3维动态图形到屏幕坐标的变换式、各测点的平滑连接方法以及描绘与检测井眼轨迹曲线的典型应用，实现了空间井眼轨迹曲线的任意旋转、投影和给出了任一井段的井深、井斜角和方位角的光标检测软件。

The functional relation between incident angle and refractive angle of energy flow is obtained. According to this relation, we can restructure the refractive angle as negative or positive readily by selecting suitable permittivity and permeability tensors.

导出了电磁波的入射角和能流折射角之间的函数关系，根据此关系可方便地选择合适的介电张量和磁导率张量，使特定入射角所对应的折射是正或是负。

The experimental results show that the friction angle becomes larger with the exit angle and oblique cutting angle.

结果表明，毛刺大小随着加工速度的增加而减小；摩擦角随着出刀角度以及斜切角度的增大而增大，从而导致毛刺尺寸增大。

objectiveto search a simple, safe and effective method for correction of prominent mandibular angle and malar under localanesthesia.methodsaccording to the patient' s condition with prominent mandibular angle and malar, abrasive osteoplasty was performed using the special designed grinding burs with protecting sheath through intraoral incisions under local anaesthsia.resultsfrom 2004 to 2008, we have performed 35 patients with prominent mandibular angle and malar using this method.

目的：探讨一种安全、简便、有效的下颌角肥大及颧骨突出矫治术。方法：根据下颌角肥大及颧骨突出的情况，在局部浸润麻醉下，由口内入路，应用颌面骨电动手术器械行下颌角、颧骨磨削术。结果：2004～2008年，我们共实施35例该手术，所有病例治疗过程顺利，未出现骨折、大出血等并发症，经过1～36个月的随访，所有患者均对术后效果满意。

The practical problem of the arbitrary plane angle (the edge of the angle is the line at arbitrary position) in space and its projective angle is analyzed and studied in this paper.

本文对空间任意平面角（角边可为任意位置的直线）及其投影角这一具有实用性的几何问题进行分析研究；用几种不同的解析方法得出在各种情况下的关系式，从而能以最少的参变量，进行准确而简便的计算。

Both the methods for measuring such optical constants as cleavage angle, interference color level, extinction angle, length sign, optical sign, optic angle, pleochroism formula, absorptivity formula and the determining program for transparent minerals will be emphasized to lecture.

重点讲授透明矿物解理夹角、消光角、延性符号、干涉色级序、光性符号、光轴角、多色性公式、吸收性公式的测定方法和透明矿物的鉴定程序。

He became prime minister in 1997 and won international acclaim for his role in the Northern Ireland peace process.

他在1997年成为总理，并且因为在北爱尔兰的和平进程中发挥的作用受到国际社会的赞许。

Mixed Page Sorting Method Using the cuttable user model, this thesis proposes a mixed page sorting method by using cutted user model in server-side and complete user model in client-side.

隐私分级利用的混合式页面排序方法针对个性化搜索中搜索结果排序的问题，本文利用隐私可控开放的用户偏好模型，提出一个在客户端和服务器端分步进行的隐私分级利用的混合式页面排序方法。