查询词典 range angle

With a dip angle between 15° and 30°, the uplift of an obducted plate during continental collision is much higher, and able to form a high mountain. The uplift is greatest with a dip angle of 15°; whereas with a dip angle between 30° and 45°, the subduction depth of a plate is much deeper, and able to form a deep basin. The subduction depth is greatest with a dip angle of 45°. When the dip angle is equal to or greater than 75°, subduction and obduction movements between two continents become undistinguishable.

当断裂带倾角在15~30°时，两个大陆板块碰撞导致的仰冲板块一侧隆升高度相对更大，利于形成高大的山脉，其中以15°倾角对应的仰冲板块一侧隆升最高；当断裂带倾角在30~45°时，两个大陆板块碰撞导致的俯冲板块的俯冲深度相对更深，利于形成深陷的盆地，其中以45°倾角对应的俯冲陆块一侧俯冲最深；当断裂带倾角≥75°时，两个大陆板块之间的相对俯冲和仰冲作用变得不明显。

Experiments exposed that the inner flow of tooth space in the micro-channels was proved to be cycled flow after fully development. For the more, low velocity vortex cavities existed in the vertex angle and inner side of bend angle of straight angle micro-channel, while back flow only appeared in the internal side of bend angle of round angle micro-channel. It's easy to take place deposition in the low velocity vortex cavities, which is the main cause of blocking.

试验发现各类微通道齿间内流充分发展后是一种重复性流动，平角微通道顶角和转角内侧存在低速涡旋区，圆角微通道只在转角内侧出现回流，颗粒在低速涡旋区易发生沉积，是造成堵塞的主要原因。

For class III malocclusion there are no significant differences in Ls-SGo,Li-SGo,upper lip length , lower lip length , Cm-Sn-Ls, upper lip angle of inclination and Li-H line . There are significant differences in lower lip angle of inclination , mentolabial sulcus angle , upper lower lip angle , H angle.

安氏Ⅰ类错合患者与安氏Ⅲ类错合患者相比，在上唇突点到SGo距离、下唇突点到SGo距离、上唇长、下唇长、鼻唇角、上唇倾角和下唇突点到H线距这些测量指标上无显著性差异；其他表示唇部形态和位置的指标，下唇倾角、颏唇沟角、H角、上下唇角都有显著性差异。

Therefore, the electronic angle measurement also has code-degree angle measuring plate, grating-degree angle measuring plate and coding degree angle measuring plate combination, as well as the form of four kinds of dynamic measuring angle.

因此，电子测角也就有编码度盘测角，光栅度盘测角和编码度盘结合测角，以及动态测角等四种形式。

Germany TOP imported pneumatic angle seat valve types: internal thread pneumatic angle seat valve, welding-type pneumatic angle seat valve, flange type pneumatic angle seat valve, clamp-type pneumatic angle seat valve.

德国TOP进口过滤器类：法兰Y型铸钢过滤器、法兰Y型不锈钢过滤器、丝口不锈钢过滤器、蒸汽过滤器、天燃气过滤器、篮式直通过滤器、T型过滤器。

Shoulder joint angle and wrist joint angle changes have nothing to do with shooting distance; shoulder joint angle speed and wrist angle joint angle speed have nothing to do with shooting distance.

四、 不同距离投篮肩关节角度、腕关节角度变化与距离远近无关；肩关节角速度、腕关节角速度变化与距离远近无关。

Through the computer simulation,analyzing the effects of pitch angle,roll angle,roll angle rate,sink rate,angle of attack and side angle on the track of ejection and save life height .

为提供弹射座椅多模态控制输入参数选择的理论依据，通过计算机仿真，比较分析了俯仰角、滚转角、滚转角速度、下沉率、迎角、侧滑角等弹射启动时飞机状态参数对弹射轨迹和安全救生高度的影响。

Optimal screw path length: The distance from the optimal entrancepoint to the optimal vent point Screw tail distance: The distance between left and right optimalentrance point Transverse section angle: Half of the included angle between left andright optimal screw Sagital section angle: The average of angle between both side optimalscrew with the upper terminal plate 1.2.2 Modify the threshold of CT value to distinguish the rear partof the lumbar, Observate the the optimal entrance point and the adjustable range.

1.2.2三维重建观察螺钉最佳进钉点的位置和各方向螺钉进钉点关系，调整CT值下限阈值使椎弓后部结构尽量显示清晰，以利观察。 1.3统计方法本实验采用SPSS13.0统计软件。对同一椎体左右两侧椎弓根螺钉相对数据行计量资料配对样本t检验，对男女组间相关数据行计量资料独立样本t检验，对男女组内不同腰椎节段间相关数据行单向方差分析及不同腰椎节段间LSD法多重比较。

By range analysis of the orthogonal designing scheme, the sequence affecting pump head and efficiency of the four main factors were obtained, the number of short-blade, the deflection angle, the bias angle in peripheral direction, the radial inlet position and the number of short-blade, the radial inlet position, the bias angle in peripheral direction, and the deflection angle, meanwhile the best design scheme of short-blade was given.

通过对正交设计方案结果的极差分析，得出各因素水平对扬程和效率影响的主次顺序分别为短叶片数、偏转角、周向偏置度、径向进口的相对位置和短叶片数、径向进口的相对位置、周向偏置度、偏转角，从而得到超低比转速高速离心泵复合式叶轮短叶片的最佳设计方案。

As the forward velocity increasing, the windrowing angle would be decreased, but the effect of forward velocity on windrowing distance was not obvious. The windrowing angle and distance of multiple sugarcane stalks would be smaller than those of single sugarcane stalk, but the maximum range of windrowing angle and distance of multiple sugarcane stalks would be greater than those of single sugarcane stalk. In order to sugarcane stalks outward windrowing, holding height must be within ±100mm of height of sugarcane mass center. As holding height increasing, the windrowing distance would be decreased, but the effect of holding height on windrowing angle was not obvious.

随着夹持输送装置输送速度的增大，甘蔗铺放角和甘蔗铺放距离也随着增大，随着机车前进速度的增大，甘蔗铺放角是减小的，而前进速度对甘蔗的铺放距离影响不大；多根甘蔗的铺放角和铺放距离要比单根甘蔗小，铺放角和铺放距离最大极差要比单根甘蔗大；入口夹持点高度应在甘蔗质心高度±100mm范围内为宜，以保证甘蔗能向机车外侧铺放，随夹持高度的增加，甘蔗质心位于夹持点下方的距离增大，甘蔗铺放距离减小，而夹持高度对甘蔗铺放角影响不大。

Don not attempt to do something which you can not to do.

不要企图做那些办不到的事情。

The expression of CTGF and TNF-αweredetected by immunochemistry and the number of Clara Cells was calculated.

光镜下观察肺组织的病理变化，采用免疫组化染色观察肺组织中结缔组织生长因子和肿瘤坏死因子-α的表达和Clara细胞的数量。