查询词典 oxidation process

According to the characteristics of waste water of lazaretto ,a process of disinfection+aerobic bio-contact oxidation+disinfection was adopted to treat the sewage of Yangquan SARS Hospital.

针对传染病医院污水所含病菌的特点，采用"消毒+好氧生物接触氧化法+消毒"二级处理工艺对阳泉市"SARS"病医院污水进行了处理。

First of all, this study will be multi-walled carbon nanotubes by chemical oxidation process purified so it can be modified to deal with than the purification of purity before the modified 5 wt%, more than 1.89 times the surface area to increase the surface potential decrease of about 10 ~ 20 mV and the surface functional base (-COOH and-OH) to increase 1.45 times, and then the control technology of electroless preparation parameters include: analysis of plating time, plating analysis of temperature, metal ions in solution than the (Fe2+/ Ni2+), bath pH and the added value of dispersion Agent and other research towards Fe-Ni particles to increase the iron content and Fe-Ni particles spread in the MWCNT upper fixed targets,the results found that when the parameters for the preparation of 50 ℃, pH10, do not add dispersant, metal ions than the solution (Fe2 +/ Ni2 +) 7, the highest iron content can be Fe = 40.55 at%(flat iron content 111.17 mg / g) of nanocomposites Fe-Ni/CNT, then for a series of the nature of its analysis, the final evaluation Fe-Ni/CNT nanocomposites were processed on the effectiveness of the application of mixed pollutants, the results showed that in 120 minutes at the same time when Adsorption of heavy metal ions lead nitrate 10 ppm, selenium heavy metal ion degradation of 1 ppm and orange azo dye AO7 50 ppm standard of effluents, and after a total Fe-Ni nano-particles to SEM / EDS analysis of more than 50% still remaining.

本研究首先将多壁奈米碳管以化学氧化法做纯化改质处理能使其纯度较纯化改质前提高5 wt％、比表面积提高1.89倍、表面电位下降约10~20 mV以及表面官能基提高1.45倍，再控制无电镀技术之制备参数包括：析镀时间、析镀温度，镀液中金属离子比(Fe2+/Ni2+)、镀液pH值及是否添加分散剂等，研究朝提高Fe-Ni粒子的含铁量与Fe-Ni粒子散布固定在MWCNT上等目标进行，研究结果发现当制备参数为50 ℃、pH10、不添加分散剂、镀液金属离子比(Fe2+/Ni2+)7时，可得到最高铁含量Fe = 40.55 at％(单位铁含量111.17 mg/g)之奈米复合材料Fe-Ni/CNT，接著对其作一系列性质分析，最后评估奈米复合材料Fe-Ni/CNT对共处理混合污染物之应用效益，结果显示其在120分钟时能够同时吸附重金属硝酸铅离子10 ppm、重金属硒酸根离子1 ppm及降解偶氮橘色染料AO7 50 ppm达放流水标准，且共处理后奈米Fe-Ni粒子以SEM/EDS分析仍剩余50 %以上。

The sulfite oxidation workshop section can be left out and the process can be simplified.

和过氧化氢和Fe-EDTA法相比，本方法脱NO的效果具有持续时间长、效率高等优点。

The results showed that main curing ingredients of Cantonese sausage retarded lipolysis and lipids oxidation during drying process.

结果发现，传统广式腊肠主要配料能够明显抑制干燥过程中脂肪的水解和氧化。

The whole experiment process was divided into three parts - reduction roasting pyrite cinder, vitriol lixiviation and catalytic-oxidation polymerization, the optimum condition was defined in every part, and the production quality and flocculation performance were tested, good results were gained.

本实验采用还原焙烧、硫酸浸取、催化氧化聚合的工艺制取聚合硫酸铁，确定了各个阶段的最佳工艺条件，并对制取的PFS进行了产品质量检验和水处理效果实验，取得了良好效果。

Lutein was also seen to decrease oxidation of lipids - the process that causes degradation - by 55 per cent.

叶黄素也被减少氧化脂质过氧化的-过程中退化的原因-由5 5 ％。

A process for the preparation of trimesic acid by the catalytic oxidation of mesitylene with air in liquid phase was presented in this paper.

介绍以均三甲苯为原料，采用液相空气氧化法制取均苯三酸的工艺方法。

During the reaction of catalytic oxidation of mesitylene by air in the gas-liquid phase to synthesize trimesic acid as well as the correlative process, with the aim of controlling the product's quality and improving its reaction yield, it's necessary to bulid a set of reliable and integral analysis methods.

在均三甲苯气液相催化空气氧化合成均苯三甲酸的反应及相关的工艺过程中，为了更好的控制产品质量和提高反应收率，建立一套可靠完善的分析方法是很有必要的。

In the gas-liquid phase reaction of catalytic oxidation of mesitylene by air to synthesize trimesic acid and the related process,an analysis method of reaction components was proposed,which includes chromatographic analysis,mass spectral analysis,IR spectrum,atomic absorption spectrophotometer and chemical titration for the purpose of analyzing reaction groups.

针对均三甲苯气液相催化空气氧化合成均苯三甲酸的反应及相关的工艺过程中，反应产物均苯三甲酸的分析问题，提出以色谱分析、质谱分析、红外光谱分析、原子吸收光谱分析及化学滴定为主要分析手段对反应组分进行分析，重点研究并建立了相关的分析方法。

As compared with the process technique and metal loss in wire rod production at home and abroad,analysis was made to study the status and cause of oxidation loss and cropping of front and back ends in wire rod production at Pangang.

通过与国内外线材生产工艺技术和金属损耗的对比，分析了攀钢线材生产中氧化烧损和成品切头切尾的现状及产生的原因，并从工艺改进和生产管理等方面提出了控制措施。

He got into race cars, while my father liked go-karts more, so I didn't really pay attention to what Diego was doing, as I was just racing karts.

叔叔开的是跑车，而我父亲更喜欢越野卡丁车，所以我并不太关注Diego在做什么，我仅仅在跑我的卡丁车而已。

She is at present gone to look for the best nectar and ambrosia to regale me this evening.

她今晚为款待我，现在又去准备美酒佳肴去了。