查询词典 output current

If the input password is correct, then from P3.0 output unblanking signal, if the input password is not correct, then from P3.1 output password rub-out signal, if continual three times inputs the password is wrong, then from P3.2 output alarm, once the output alarm, after must wait for relieves reports to the police only then unlocks.

如果输入密码正确，则从P3.0输出开锁信号，如果输入密码不正确，则从P3.1输出密码错误信号，如果连续三次输入的密码均是错的，则从P3.2输出报警信号，一旦输出报警信号，就必须等待解除报警后方可重新开锁

Three methods are adopted to improve the performance of output precision and cross regulation in the multi-output switch mode power supply,including stack wire wound of transformer,output inductance coupling and output proportional sampling.

针对多路输出 DC/DC变换器存在的输出精度与交叉调整率问题，提出了三种改善措施：变压器堆叠绕法、输出电感耦合与输出比例取样反馈，同时给出了设计实例。

Using the 294cc rotary engine, it can influence the maximum rpm and power of the engine output under the terms of using all kinds of length intake. Then it can find out the best length of intake of the rotary engine. In addition, under the terms of space limit of intake, it can influence the maximum rpm and power of the engine output when the intake is forced to limit on a certain length. To install a resonance in the intake system, according to the equation of Helmholtz, it can design the all kinds of size of the resonance. Using to change the volume and geometirc form of the resonance, it can find out the maximum rpm and horsepower of engine output in order to reduce the influence of the variation of engine intake length. Under the verification of the experimental result, this simple device can increase the rpm and horsepower of the rotary engine obviously to achieve the output performance that the engine requires to supply. Such the revisal of intake need the lower cost but it can obtain very obvious efficiency. It is a very feasible way.

藉由一具294cc的飞行器引擎，在使用各种不同长度进气道的条件下，对引擎所能输出的最大转速及马力有一定的影响，藉此找出该具引擎的最佳进气道长度；此外，在进气道因空间限制的前提下，进气道被迫只能局限某个长度以下时，在这种条件下，引擎所能输出的最大转速与马力等相关性能会随之受到影响，在进气系统加装一个共振腔，配合Helmholtz的方程式，设计出各种共振腔各部位的尺寸，利用改变共振腔的体积与几何形状，可以寻求增加引擎转速与输出马力的最大值，藉此降低进气长度变化所带来的影响，在实验结果的验证下，此一简单的装置可以明显的增加引擎转速与马力，以达到对引擎所需的输出性能要求，这样的进气系统修改所需的费用极低，但却可获得很明显的功效，是十分可行的方式。

Thirdly, proper probabilistic model is built for the bilateral stop-and-go generator and the probability properties of its output sequence are studied. It is proved that the output sequence obey strong law of large numbers and central limit theorem and that, however, the distributions of 0 and 1 in the output sequence are imbalanced, which implies that this generator cannot be used as keystream generator directly. The rate of coincidence between the output sequence and corresponding LFSR sequences, together with their first derivatives are obtained, which reveal the existence of correlation between these sequences.

最后，建立了双侧停走生成器的概率模型，研究了双侧停走生成器输出序列的概率分布性质和大数性质，证明了生成器输出序列服从强大数定律和中心极限定理，得到了生成器输出序列中0，1分布是不平衡的结论，由此指出不能将这种生成器直接作为密钥流生成器；给出了双侧停走生成器输出序列和相应的线性移位寄存器序列之间的符合率以及一阶差分序列之间的符合率，得到了符合率的表达式，揭示了这些序列的对应比特和对应序列段之间存在相关性。

Our results show that the rate of correlation among the random variables of those output sequences are low although they are not independent; in addition, the output sequences of those combined generators are homogeneous Markov chains which are strictly stationary processes with ergodicity; the output sequences of those combined generators are also proved to summit to the strong law of large numbers and the central limit theorem; finally the computation formula of the rate of the accordance between the output sequences and input sequences of those combined generators is given.

我们的研究结论表明：虽然这些序列中随机变量之间不具有相互独立性，但它们的相关程度却比较低；证明了"停走"生成器，KM_1M_2型组合生成器和加法型组合生成器的概率模型输出序列都是强平稳的和遍历的齐次马氏链；讨论了这些序列的概率极限性质，证明了它们均服从强大数定律和中心极限定理；还分别给出了各类生成器的输出序列与输入序列之间的符合率的计算公式。

A transmission for vehicles is provided with a plurality of drive gears, an input shaft connected to the drive shaft of an engine, an output shaft disposed parallel to the input shaft, a driven gear which meshes with each drive gear and is rotatably disposed on the output shaft, a synchromesh mechanism which has a sleeve movable in the axial direction of the output shaft, is engageable with a side portion of the driven gear, and couples the driven gear to the output shaft, and a parking gear formed integrally with the sleeve of the synchromesh mechanism.

用于车辆的传动装置配备多个驱动齿轮；连接到发动机的驱动轴的输入轴；与输入轴平行设置的输出轴；与每个驱动齿轮啮合并且可转动地设置在输出轴上的被驱动齿轮；具有可沿输出轴的轴向移动的套筒，可与被驱动齿轮的侧部啮合并且将被驱动齿轮连接到输出轴的同步啮合机构；和与同步啮合机构的套筒一体形成的泊车齿轮。

Accurate analog power is to provide power, digital chip, amplifiers, microcontroller is the voltage required by A/D sampling data output voltage, and comparison, if there is A deviation is the limit, adjust output signal output and closure, alarm, The working process of the working status, manostat by SCM outputs drive LED display, Display circuit used to display the size of the output voltage of power.

准确说就是模拟电源提供各个芯片电源、数码管、放大器所需电压，单片机则通过A/D采样输出电压，与设定值进行比较，若有偏差则调整输出，越限则输出报警信号并截流；工作过程中，稳压电源的工作状态均由单片机输出驱动LED显示；显示电路用于显示电源输出电压的大小。

Its main products and capacity are: Ammonium Paratungstate annual output 6000 tons; Tungsten Oxide annual output 5000 tons; Tungsten Powder annual output 2000 tons; Tungsten Carbide Powder annual output 2000 tons.

主要产品及能力：仲钨酸铵6000吨/年；氧化钨5000吨/年；金属钨粉2000吨/年；碳化钨粉2000吨/年。

Based on this principle, the mathematical model of an exothermic reactor is established to caculate Exothermic reator length L corresponding to reation temperature T, reation temperature T corresponding to ammonia mole fraction y and the average internal reactor wall temperature Tave corresponding to exergy output Enet and thermal power output Q. The curves of L-T, T-y, Q/Enet –Tave are drawn with the caculated date which can directly reflect the influence of reactor inlet gas temperature and reactant flow rate on ammonia synthesis reaction for the reactor under the conditions of definite design pressure and hydrogen/nitrogen ratio. Furthermore, the design parameters to realize maximum exergy output and thermal output are presented.

文章分析了储能体系的选择，介绍了氨基热化学储能的基本原理，在此基础上建立了放热反应器的数学模型，计算和绘制出了L-T、T-y以及热量和佣输出与反应器内壁平均温度之间的关系曲线，直观地反映了在一定的设计压力和氢氮比条件下，进气温度和进气流率对放热反应的影响，给出了实现佣最优化和热能最优化的操作参数。

LT3468ES5-1 Pinout: 8-bit Resolution 1 Gsps Sampling Rate ADC Gain Adjust 2 GHz Full Power Input Bandwidth Fs = 1 Gsps, Fin = 20 MHz: C SINAD = 45 dB (7.4 Effective Bits) SFDR = 58 dBc Fs = 1 Gsps, Fin = 500 MHz: C SINAD = 44 dB (7.2 Effective Bits) SFDR = 56 dBc Fs = 1 Gsps, Fin = 1000 MHz (-3 dB Fs): C SINAD = 42 dB (7.0 Effective Bits) SFDR = 52 dBc 2 Tone IMD:-53 dBc (489 MHz and 490 MHz) at 1 Gsps DNL = 0.3 LSB INL = 0.7 LSB Low Bit Error Rate (10-13) at 1 Gsps Very Low Input Capacitance: 0.4 pF 500 mVpp Differential or Single-ended Analog Inputs Differential or Single-ended 50 ECL Compatible Clock Inputs ECL or LVDS/HSTL Output Compatibility Data Ready Output with Asynchronous Reset Gray or Binary Selectable Output Data; NRZ Output Mode Power Consumption: 3.4 W at TJ = 90 C Dual Power Supply: 5 V Radiation Tolerance Oriented Design 150 Krad (Si Measured

LT3468ES5-1引脚说明： 8位分辨率1 GSPS的采样速率ADC的增益调整2 GHz的全功率输入带宽= 1 GSPS的二恶英，翅= 20兆赫中：C的SINAD = 45分贝（7.4有效位）的SFDR = 58 dBc的二恶英= 1 GSP的，财务= 500兆赫中：C的SINAD = 44分贝（7.2有效位）的SFDR = 56 = 1 GSPS的dBc的外勤人员，财务= 1000兆赫（-3分贝财经事务）中：C的SINAD = 42分贝（7.0有效位）的SFDR = 52 dBc的2声调发展学院：-53 dBc的（489兆赫和1 GSPS的的DNL = 0.3的LSB的INL = 0.7 LSB的低误码率（10-13）在1 GSPS的非常低输入电容：0.4 pF的490兆赫）500 mVpp的差分或单端模拟输入差分或单端50Ω的ECL兼容的时钟输入的ECL或LVDS / HSTL输出兼容性数据与异步复位灰色或二进制可选的输出数据就绪输出； NRZ码输出模式下的功耗：3.4 W于温度Tj = 90 C双电源：5伏辐射性导向设计

The system can be widely used in belt weighing and batching process control,etc.

介绍了基于智能模糊控制的嵌入式配料系统的设计方法，对模糊PID控制过程和系统调零作了重点的讨论，同时给出了PID控制的程序流程图和系统定长调零子程序。

"I dunno," she answered,"but if you show me aroun', I'll recognize it from the lighthouse just outside the porthole."

"我不知道，"她回答说，"如果你能带我转转，我能认出来的，因为灯塔就在舷窗外。"