查询词典 optimum control

With a view to establishing a complete CAD system, the relation and the rational division of the function between the optimum design as a subsystem and other subsystems are discussed. The optimum design model is described.

从建立一个完整专业CAD系统的角度，讨论了优化设计作为其中的一个子系统与其他子系统之间的关系及合理的任务分工，提出了优化设计模型。

In this paper,on the basis of theoretically describing mathematics model of the optimum sample plots in certain monitoring area,systematic research and analysis had been carried out through realitic instances and sampling problem of the optimum sample plots had been solved effectively.

该文在理论描述特定监测区域最优样地数学模型的基础上，通过实例进行了系统研究与分析，有效解决了最优样地的抽样问题，所得结果可用于指导生产实践。

In this paper, the author sets up the dynamic model of the vibratory extracting-driving piling machine, and carries out the dynamic analysis, parameter calculation and Matlab's simulation for this model. Using the equation reciprocity law to carry out the calculation of soil parameter and simulation, and using the genetic algorithm to make optimization of the machine on the basis of the simulation, the author gets the optimum self-induced vibration frequencies of the machine changing with the depth of the pile and the optimization result of other parameters, thus reaching the conclusion that along with the increase of pile sinking depth, the optimum self-induced vibration frequency becomes bigger, and the vibration mass becomes smaller, hence deepening the knowledge of the dynamic performance of this system.

本文建立了振动沉拔桩机的动力学模型并对这一模型进行了动力学分析、参数计算和Matlab仿真，并利用方程对等法进行土壤参数的计算和仿真，又在仿真的基础上使用遗传算法对桩机进行了优化，从而得出了路基加固振动沉拔桩机随沉桩深度变化而改变的最佳激振频率以及其它参数的优化结果，并得出了随沉桩深度的增加，桩机的最佳激振频率由小变大，最佳参振质量由大变小的结论，深化了对该系统动力学性能规律的认识。

In this paper, the author sets up the dynamic model of the vibratory extracting-driving piling machine, and carries out the dynamic analysis, parameter calculation and Matlabs simulation for this model. Using the equation reciprocity law to carry out the calculation of soil parameter and simulation, and using the genetic algorithm to make optimization of the machine on the basis of the simulation, the author gets the optimum self-induced vibration frequencies of the machine changing with the depth of the pile and the optimization result of other parameters, thus reaching the conclusion that along with the increase of pile sinking depth, the optimum self-induced vibration frequency becomes bigger, and the vibration mass becomes smaller, hence deepening the knowledge of the dynamic performance of this system.

本文建立了振动沉拔桩机的动力学模型并对这一模型进行了动力学分析、参数计算和Matlab仿真，并利用方程对等法进行土壤参数的计算和仿真，又在仿真的基础上使用遗传算法对桩机进行了优化，从而得出了路基加固振动沉拔桩机随沉桩深度变化而改变的最佳激振频率以及其它参数的优化结果，并得出了随沉桩深度的增加，桩机的最佳激振频率由小变大，最佳参振质量由大变小的结论，深化了对该系统动力学性能规律的认识。

Theequivalence percolation resistance law is accurate enough to be used in productivitycalculation of horizontal well pattern.(3) Productivity of mixed well pattern of horizontalwell or multilateral horizontal well and vertical well is constructed and formulae are simpleenough to be used in the oilfield. The patterns include 5-spot pattern,7-spot pattern and9-spot pattern.(4) Productivity formula of united rectangular well pattern of horizontaland vertical wells is constructed. By this formula, the calculation results show that fora horizontal well length, there is a shape factor at which the productivity of the patternis biggest. So optimum method of the well pattern is proposed.(5) A new concept ofdimensionless length of horizontal well is advanced and the relationship of optimum shapefactor of the rectangular well pattern against dimensionless length of horizontal well ispresented. The influences of length of the horizontal well, area of the well pattern unitand the thickness of reservior are concerned.

利用该公式计算表明：当水平井长度一定时，存在一个最优井网形状，使得水平井的产能最大，在此基础上提出了水平井井网的优化方法；(5)提出了水平井无因次长度的概念，给出了联合井网最优井网形状因子与水平井无因次长度的关系式，并对水平井长度、油层厚度及井网面积对产能的影响进行了分析；(6)推导出了一无限水平井井排在XY 平面内势的解析解，为不同水平井整体开发井网或水平井和直井井网整体开发渗流理论的研究奠定了理论基础；(7)建立了交错式水平井与直井整体开发渗流理论，给出了拟三维条件下井网产能的精确解析解及该井网最优井网形状因子与水平井无因次长度的关系，并对产能的影响因素进行了分析；(8)建立了水平井与水平井正排列井网、交错排列井网条件下渗流理论及井网产能在拟三维条件下的精确解析解，给出了交错井网条件下最优井网形状因子与水平井无因次长度的关系，通过与正方形井网对比，说明优化井网可大幅度提高开采效果；(9)建立了分支水平井和直井面积井网水油两相非活塞驱替条件下渗流问题的解析解，给出了见水前后无因次产量与无因次时间的关系式以及见水时间等。

On the basis of the previous results and according to the central composite experimental design principles,the method of response surface method with 3 factors and 3 levels was adopted.then the factors influencing the technological parameters were determined by means of regression analysis.response surface and contour were finally graphed with the extraction rate as the response value.resultsthe optimum conditions of lycium barbarum polysaccharides extraction were as follows:the ratio of material to solvent of 1∶32,extraction temperature of 84℃ and extraction time of 2.3 h,one time extraction.conclusionthe yield of lycium barbarum polysaccharides is 11.10% under the optimum conditions.

方法在单因素实验基础上选取实验因素与水平，根据中心组合（box-benhnken）实验设计原理采用3因素水平的响应面分析法，依据回归分析确定各工艺条件的影响因子，以多糖提取率为响应值作响应面和等高线。结果在分析各个因素的显著性和交互作用后，得出枸杞多糖水浸提的最佳工艺条件为：料液比1∶32；浸提温度84℃；浸提时间2.3h；浸提1次。结论在最佳工艺条件下，枸杞多糖的实际提取率可达11.10%。

By solving the optimum -- diameter equations for the case of critical Reynold number, it has been found possible to decide whether any given flow will be turbulent or viscous in a pipe of optimum diameter. At these equations and ...

本 文所推导的公式及算图都是以我国目前的价格指标为依据，因此应用它来选取经济管径应当是适合于我国情况的。

By solving the optimum -- diameter equations for the case of critical Reynold number, it has been found possible to decide whether any given flow will be turbulent or viscous in a pipe of optimum diameter. At these equation...

本 文所推导的公式及算图都是以我国目前的价格指标为依据，因此应用它来选取经济管径应当是适合于我国情况的。

For the moment, the optimum scan line length is usually determined by statistical properties of joint space, while, the authors research result indicates that the optimum scan line length does not only rely on statistical properties of joint space, but also on statistical properties of joint trace length and other joint geometry parameters.

当前研究人员一般通过结构面间距的概率特征确定最佳测线长度，研究成果表明，仅依据间距的概率特征确定的最佳测线长度往往偏小，在确定最佳测线长度时还需要考虑迹长等其它结构面几何参数的概率特征。

This paper introduced the fuzzy optimum design process of the twin_universal coupling ,that is the key mobile part of the four_spiral cover vacuum bottle seamer;and inquired into the methods and ways about the fuzzy optimum design.

本文详细介绍了四旋盖真空封瓶机中关键运动件———双万向联轴器的模糊优化设计过程，并探讨了有关模糊优化设计的方法和途

I want to be a big fish in a small pond.

我要做一条在小池塘里的大鱼。

While the software functioned well, we did not feel the same about their customer support!

虽然该软件运行良好，我们没有同样的感觉他们的客户支持！