查询词典 optimized

Firstly, the average line of the acceleration is fitted by cubic polynomial. Then, the long period baseline waving problem, which is still existed in the integral velocity and displacement after the first optimization, is secondly optimized by the recursive method of SDOF system.

首先以3次多项式来拟合加速度的均值线；再对一次优化后的积分速度、位移时程仍存在的长周期基线波动问题，运用单自由度地震动力反应递归法进行二次优化。

On the basis of the avidity of lesional macrophages for polysaccharide-containing supramolecular structures such as nanoparticles, we have developed a new positron emission tomography agent with optimized pharmacokinetics to allow in vivo imaging at tracer concentrations.

基于病变巨噬细胞和含多糖的超分子结构，如纳米颗粒的亲和性，我门研发出一种新的PET显像剂，该显像剂具有最优化的药代动力学，在示踪浓度时可在体显像。

For the convenience of study,the optimized design method is discussed and the azimuthal displacement design is made by taking the double-build section most in use for example in this paper.

为讨论方便，文中以常用的双增型剖面为例，讨论其最优化的设计方法，并进行了方位漂移设计。

Wastewater containing titanium pigment was treated by microfiltration membrane, Nanometer titanium can be purified and concentrated by use of microfiltration. Operational conditions were optimized and the model was built. Finally, the amount of wash water was reduced. Based on the above research, the whole set equipment was designed, which can meet the needs in a titanium industry with a capability of 500 ton per year. Backflush and automatic control were used in the equipment, which has been steadily run two years, has been widely adopted in titanium industry. The technology has been widely adopted in titanium industry.In the recent years, whole set equipment of ceramic membrane was increasingly used in the recovery of desired production from fermentation broth in China. A new membrane process integrated with pretreatment of flocculation or coagulation was exploited to recover Inosine. ZrO2 ceramic membrane was used in the work, and the average permeation flux could reach 150L/m2.h under pH value of 3, transmembrane pressure 0.1MPa, CFV 3m/s, and temperature higher than 70C. The recovery ratio of inosine is higher than traditional recovery method, although inosine degraded under acidic and high temperature condition.

实验表明，ZrO_2膜处理肌苷发酵液的合适条件为pH=3、操作压力为0.1MPa、膜面流速3m／s、温度大于70度，此时可以获得平均渗透通量150L／m~2h，但由于酸性条件、高温下肌苷降解，导致肌苷收率有所降低，但仍高于传统肌苷提取方法得到的收率；为进一步提高肌苷得率，缩短提取工序，实验研究了絮凝剂预处理发酵液，解决碱性条件下由于蛋白析出导致膜污染加重的问题，研究表明采用CaCl_2絮凝并调节pH=11，可以获得平均渗透通量为180L／m~2h，肌苷得率大于95％；比较了三种肌苷提取工艺得到的产品质量，采用预处理与陶瓷南京工业大学博士学位论文膜分离结合的除杂工艺得到的粗昔质量与陶瓷膜分离、离子交换及活性炭吸附工艺生产的粗普质量相当，均优于传统的提取工艺；设计了每小时处理12一巧吨肌普发酵液的陶瓷膜成套装置，采用部分内循环的方式降低设备的能耗，简化了肌昔提取方式，提高了产品的收率和得率，由于减少离子交换和活性炭吸附，使得工厂废水排放量降低30一40%，降低酸、碱用量，有利于环境保护。

In this paper, the dynamic compressing experiments for the matrix material of the tungsten alloys which have been three different deforming(0%、 32.6%、 44.6%) processed have been performed by the experimental technology of separated Hopkinson pressure bar and many accurate datum have been obtained. Also the three materials have been compared with each other and analyzed. The results show that the optimized values are in a certain range to optimize the materials by changing their deforming technology. The parameters of constitutive model of Johnson-Cook have been fitted based on the datum. Then proceed to the next step, adiabatic shear band of these three matrix materials has been analyzed with finite element method. The result shows that the relations between stress and strain are different because of the differences of technical process of the three materials, but they are in great commonness in the material experiment and in great coherence in the distribution of time and space, which can been seen from the space distributing figures of plastic strain.

利用分离式Hopkinson压杆实验技术对三种不同变形量(0%、32.6%、44.6%)钨合金基体材料进行动态压缩实验，取得大量精确的数据，对比分析三种材料，结果表明通过改变变形量对材料进行优化，其变形量的优化值是有一定范围的；本论文拟合、确定了钨合金基体材料Johnson-Cook本构模型参数并对三种基体材料绝热剪切带进行有限元分析，结果表明三种材料由于工艺流程的不同，应力应变关系也不尽相同，但从塑性应变的空间分布图上体现了材料很大的共性和时间以及空间分布的一致性。

In this thesis the solid-state reaction at room temperature was applied to prepare nanometer barium carbonate. The feasibility of this method was studied and an optimized procedure for the preparation of nanometer barium carbonate was set up.

本文采用室温固相化学反应的方法，研究了在该条件下制备纳米BaCO_3的可行性，建立了制备纳米BaCO_3的方法体系，制备了平均粒经约为100nm，形貌近似为球形的纳米BaCO_3。

Results The strain grows well in malt wort agar medium,optimized growing temperature is from18to20℃,basid-iospore,pseudohypha and basidium are its characteristic.The results of carbon source assimilation and sugar fermentation are signifi-cantly distinctive,and in accordance with those described in references.

结果 该菌种在麦芽汁-琼脂培养基上生长良好，适宜温度为（20±2）℃，其生长特性为具有担孢子及假菌丝并有芽孢台；碳源同化试验及糖发酵试验均具有特异性，与参考文献所描述的红发夫酵母形态和生化试验结果基本相吻合。

Activityof enzyme ARS was analyzed, bating technology of rabbits skin was optimized subsequently in this article.

对软化酶ARS的活力分析及兔皮软化工艺试验的优化，可知酶ARS的活力大小约为1000μ/g，最佳pH为3.0左右，酶活力最适温度为50℃，其应用于兔皮的最佳软化工艺为软化pH为3.0，温度为35℃，酶用量为4.5 g/L，软化作用时间5 h。

Chemistry classroom was implements the education for all-around development the battle position, optimized classroom return real life especially important, chemistry discipline may say that was closely linked with the life.

化学课堂是实施素质教育的主阵地，优化课堂回归现实生活尤为重要，化学学科可以说是与生活息息相关。

The Zn-Ti distances are 0.369 nm and 0.335 nm for the single-corner adsorption mode and double-corner adsorption mode, respectively. Therefore, the EXAFS fitting data, R1=0.371 nm, R2=0.332 nm, can be well distinguished for SC and DC mode respectively. The calculation results also showed that the optimized Zn-O average distance of Zn-O tetrahedron is about 0.200 nm, which agree with the EXAFS results.

用DFT方法对四配位水合Zn离子在簇Ti2O11H14上进行优化后发现，四配位的Zn-O平均距离为0.200nm；外层Zn-Ti结合存在两种稳定的吸附模式：单角吸附模式和更加稳定的双角吸附模式，其Zn-Ti距离分别为0.369和0.335nm。

Now he worked in ajoint venture.

现在他在一家合资企业工作。

More troops in Afghanistan won't change any of the foregoing.

更多的在阿富汗的军队也不会改变之前的状况。