查询词典 offset

Input offset voltage, input bias current, and even CMR may be quite GOOD over PART of the common-mode range , but much worse in the region where operation shifts between the NPN and PNP devices.

在各自的共模范围内，输入失调电压、输入偏置电流甚至共模抑制CMR也许都十分的好，但在NPN元件和PNP元件间的工作交替的区域却更坏。

The input bias currents CAN now flow freely to ground and do not build up a large input offset as before.

此时，输入偏置电流可以顺畅地流入地线而不象以前一样会产生大的输入失调电压。

Input offset current can be determined by capping the input connector and selecting the lowest current range.

输入偏置电流可以通过盖上输入连接器并选择最低的电流量程来决定。

The ammeter's voltage burden and input offset current may also affect measurement accuracy.

安培计的输入端压降和输入偏置电流也可能影响测量的准确度。

This current is known as the input offset current, and it is caused by bias currents of active devices as well as by leakage currents through insulators within the INSTRUMENT .

这个电流就是输入失调电流，它可能是由有源设备的偏置电流引起的，也可能是由仪器内的绝缘体泄漏电流引起的。

Because of the high input resistance and low offset current, the electrometer voltmeter has minimal effect on the circuit being measured.

由于具有高输入电阻和低偏置电流，静电计电压表对被测电路的影响极小。

Currents can be internally generated, as in the case of instrument input offset current, or they can come from external sources such as insulators and cables.

这种电流可以在内部产生，如仪器的输入偏置电流；也可以从外部而来，如来自绝缘子和电缆。

This current is known as the input offset current, and it's caused by bias currents of active devices as well as by leakage currents through insulators within the instrument.

这种电流称为输入偏置电流，是由有源器件的偏置电流以及流过仪器内部的绝缘子的泄漏电流所引起的。

Currents can be internally generated, as in the case of INSTRUMENT input offset current, or they can come from external sources such as insulators and CABLES .

附加电流既可以从内部产生，如仪器输入失调电流的情况下；也可从外部产生，如来自诸如绝缘体和电缆的外部"源"。

As shown in Figure 2-15, the input offset current adds to the measured current so that the meter measures the sum of the two currents

如图2-15所示，因输入失调电流叠加到测量电流，故此表测量的是两个电流的和

In the chapter 2, the theoretic knowledge about the photosensitive resin and the grinding tools was firstly introduced.

第二章阐述了光固化树脂结合剂磨具的相关理论研究。

Do not use the program's indenting or margin-setting features; these will be added during typesetting.

不要使用缩排，页面边缘设置之类的选项，偶看不大懂。