查询词典 morphology

Change of cell morphology and function after RNA interference4.1 Change of cells morphology after RNA interferenceUnder the detection of phase contrast microscope,comparison to blank group,the cell number of group siRNA1、siRNA2、siRNA3 decreased,but there was no change on cell morphology.

RNAi后IEC-6细胞形态功能的改变4.1 RNAi后IEC-6细胞形态的变化相差显微镜下观察，与空白组比较，siRNA1组、siRNA2组、siRNA3组三组干扰序列细胞数都有所减少，但细胞形态并没有明显改变。

Morphology is divided into two sub-branches: inflectional morphology and lexical or derivational morphology.

形态学可分为两个分支科学：屈折形态学和词汇或派生形态学。

Due to its good effect in the reservation of information of signal abrupt change, mathematical morphology is often applied in the detection and location of short-term power quality disturbance, however, there is still a defect of invalid detection existing in partial detection methods based on mathematical morphology while some zero-crossing disturbances are detected. In this paper three mathematical morphology based disturbance detection and location methods, i.e., the method based on first-order derivation and morphological gradient, the method based on morphological gradient and soft threshold processing and the method based on dq decomposition and top-hat transform, are analyzed, that is, by means of simulation the adaptability of these methods in the analysis on the signals of voltage sag, voltage swell and electromagnetic transient oscillation is compared.

数学形态学因其在保留信号突变点信息方面有很好的效果，因此常用于短时电能质量扰动的检测和定位，但基于数学形态学的部分方法仍存在对某些过零点扰动检测失效的缺点，文章分析了3种基于数学形态学的扰动检测和定位方法，即基于1阶求导和形态梯度的方法、基于形态梯度和软阈值处理的方法、基于dq分解和高帽变换的方法，通过仿真比较了3种方法在分析电压暂降、电压暂升、电磁暂态振荡等信号方面的适应性，结果发现基于dq分解和高帽变换的方法在检测过零点扰动时具有很好的效果，因此选取这种方法对实测扰动数据进行了检测和定位分析。

According to these experimental results, the total energy and electronic structure of SiO32 located on gibbsite (001) and (100) face with some different modes were calculated by using Dmol3 program based on DFT, and the equilibrium and growth morphology of systems were analyzed by using crystal growth habit program morphology.

根据实验结果用基于密度泛函的Dmol3程序计算SiO32以各种不同方式位于氢氧化铝(001)和(100)面时的总能量和电子结构等，用晶体生长习性计算程序Morphology分析各体系的平衡形态及生长习性。

Firstly, the important faces of the process of precipitation of sodium aluminate were calculated preparatory using Bravais-Friedel Donnay Harker method. Secondly, the equilibrium morphology calculations were processed on gibbsite 3×4×2 super cell and its (001),(100),(010),(011),(110),(101) and (112) slab models.

首先，用BFDH法说明了生长过程中最重要的面；其次，采用晶体平衡形态法，用Morphology程序对氢氧化铝3×4×2超晶胞及其(001)，(100)，(010)，(011)，(110)，(101)和(112)面真空slab模型进行平衡形态计算，计算结果与实验结果吻合，很好地预测了各显露面族(001)，(100)，(010)，(011)，(110)，(101)和(112)面族。

School of Chemistry and Chemical Engineering, Central South University, Changsha 410083, China）Abstract: By analyzing the crystal growth habit of gibbsite theoretically using Morphology program, the morphology character of crystal grain and the theoretic habit of gibbsite were studied.

摘 要：对氢氧化铝晶体生长习性进行Morphology理论研究，明确氢氧化铝晶粒长大后的晶粒形态特征及氢氧化铝的理论晶体生长习性。

When n/n=0, the product is the mixture of h-WO3 (hexagonal system WO3) and WO3.1/3H2O, and have a morphology of nanorods; when n/n=0.5 or n/n=l, the product is γ-WO3, and have a morphology of rectangular flakes; when n/n=2, the product is β-WO3, with the same morphology of rectangular flakes.

当n/n=0时，产物为h-WO3和WO31/3H2O组成的混合物，形貌为纳米棒；当飞n/n=0.5和n/n=1时，产物为γ-WO3形貌为矩形片；当n/n=2时，产物为β-WO3，形貌同样为矩形片。

In the investigation of Cu-Zn-Al SMA, the influence of quenching speed, shape memory thermal treatment on SME, microstructure and morphologies was discussed. The changes in morphology and interfaces were in situ metallographic observed during thermal cyclings in order to control the degradation of two way shape memory effect . The stabilization of stress induced martensite variants method and the accordingly changes in microstructure were studied in detail. The mechanism was also compared between SSIM and TWME training method. From the above in situ observation results, the interface structure and especially the twin related A: B type variant pair were examined by HREM to clarify the role of movability of interfaces and the changes in variants orientation in inducing the degradation of the TWME. During developing the Ni-Ti-Hf SMA melt spinning ribbon, it was found the morphology and structure embodied the SME and was directly effected by chemical composition and technique factors, such as the different content of Hf, the speed of copper roller rotation and etc. Therefore, the morphology and structure were extensively examined.

在对Cu-Zn-Al形状记忆合金研究中，研究了提高记忆效应的热处理淬火速度、记忆热处理方式对Cu-Zn-Al形状记忆合金组织结构的影响；为了弄清双程记忆效应衰减的原因，原位动态观察了热循环过程中，合金组织形貌及界面的变化；因形状记忆合金必须经记忆训练才能具有双程记忆效应，系统地研究了应力诱发马氏体稳定化训练方法和这种方法引起的双程记忆合金组织结构的变化，比较了它与双程记忆效应训练方法诱发TWME机制的异同；因在原位动态观察中发现界面可动性及两侧变体取向的变化，伴随着记忆效应的衰减，用HREM详细研究了变体的界面结构，特别是A：B型变体界面结构及变体内部结构。

Materials and Methods Thirty SD rats, feeding in clearing grade standard, were classified into five groups at random. Application of transmission electron microscopy, scanning electron microscopy, light microscopy and immunohistological staining meth- ods, normal morphology of outflow pathways was observed and component of extra cel- lular matrix was defined. The effects of 50 IU of TNF-α given intracamerally on the morphology of outflow pathways and other tissues of anterior segments, expression of trabecular stromelysin and the change of components of trabecular extra cellular matrix were observed in 24h, 3days, 7days and 14days after injection.

中文题名TNFα对鼠眼房水外流影响的形态学观察副题名外文题名 The effect of TNFα on morphology of outflow pathways in rat eyes 论文作者王大博导师王竫华教授学科专业眼科学研究领域\研究方向学位级别博士学位授予单位青岛大学学位授予日期2002 论文页码总数90页关键词青光眼房水外流通道肿瘤坏死因子-α馆藏号BSLW /2003 /R775 /1 目的在观察SD大鼠眼房水外流通道形态及确定其房水外流通道细胞外基质成份的基础上，探讨房水中肿瘤坏死因子α浓度的增加是否能诱导小梁细胞基质溶解素的表达和分泌，进而启动小梁细胞外基质的重塑过程。

The effects of such parameters as temperature, pH, feeding rate,concentration, [NH_3]_T/_T molar ratio, surfactants and agitation, on the morphology and size of the particles, were studied and conclusions obtained are as follows:(1) The morphology and size of the particles are mainly decided by the species of nickel oxalates present.(2) Speeding up dissolution-recrystallization process benefits the preparation of the particles of being composed of a single species with uniform morphology and high aspect ratio.(3) The variations of nucleation and growth supersaturation under different conditions have definite effects on the morphology and size of the particles.(4) Adding PVP25 at a proper amount is beneficial to the preparation of fibrous nickel oxalate particles with high aspect ratio. 3 The formation mechanism as well as the morphology and size control of fibrous cobalt oxalate particlesThe cobalt oxalate particles with fibre morphology were prepared using CoCl_2 solution and mixed(NH_4)_2C_2O_4, NH_3·H_2O solution by a double jet process.

研究了温度、pH值、加料速度、浓度、[NH_3]_T/_T摩尔比、表面活性剂及其添加量、搅拌等对颗粒形貌与粒度的影响，主要结论为：(1)草酸镍化合物种类是决定颗粒形貌与粒度的最主要因素；(2)提高陈化中溶解—再结晶速度，有利于得到物相单一，形貌规整，轴向比大的粉末；(3)不同条件下，颗粒形核与生长过饱和度改变，也会对粉末形貌与粒度产生一定影响；(4)适量添加PVP25有利于大轴向比纤维状草酸镍的制备。3纤维状草酸钴的形成机理及其形貌与粒度控制采用CoCl_2溶液与(NH_4)_2C_2O_4和NH_3·H_2O混合溶液并流加料合成的方法，研究了纤维状草酸钴的制备。

It is also known as one of the most poisonous naturally occurring substances.

它也被称为一个最自然发生的有毒物质。

The greatest stress is found at the location on the cross section where V is the largest.

最大应力出现在横截面上V为最大的地方。