查询词典 molar

Methods: Fifty-fix adolescents were chosen and divided into first premolar extraction and nonextraction groups, with 30 and 26 patients respectively. The pretreatment and posttreatment panoramic radiographs were taken. The indexes of third molar eruption space, distance from third molar to occlusal plane and the length of mandible were measured and analyzed.

选择56例上下颌第三磨牙均存在的患者进行方丝弓正畸治疗，按照第一前磨牙拔除与否分为拔牙组（30例）和非拔牙组（26例），利用术前术后曲面断层片对患者上下颌第三磨牙萌出间隙、第三磨牙与胎平面的距离以及下颌长度进行测量分析。

Objective: To elucidate the role HSP27 during amelogenesis and odontogenesis in the teeth of limited growth by analyzing its expression in enamel organ of developing rat molar teeth and rat molar.

目的：通过分析大鼠磨牙及其发育过程中，Hsp27 在成釉器中的表达，阐明Hsp27 在牙釉质、牙本质形成中的作用。

Densities of glycine and L-serine in aqueous LiNO3, NaNO3 and KNO3 solutions have been measured at 298.15 K with an Anton Paar Model 55 densimeter. Apparent molar volumes, limiting partial molar volumes and transfer volumes have been calculated. Hydration numbers and volumetric interaction coefficients for amino acids were evaluated.

用Anton Paar DMA 55精密数字密度计测定了甘氨酸和L-丝氨酸在LiNO3， NaNO3和KNO3水溶液中的密度，计算了氨基酸的表观摩尔体积、极限偏摩尔体积、迁移偏摩尔体积、理论水化数和体积作用系数。

The experiment results indicate that the best preparation condition is the sodium silicate concentration of 0.97 mol/L, the molar ratio of Al/Fe of 2:1~4:1, and the molar ratio of SiO2/ of 2:(2+1) at 30~40℃ for 20~30 min with activation pH of 5.0~6.0. At pH of 6~11, polysilicate aluminum ferrite chloride has the best flocculation performance.

研究结果表明：当硅酸钠浓度为0.97mol/L，Si/为2：(2+1)、Al/Fe为2：1~4：1时，熟化温度30~40℃、pH为5~6、熟化时间20~30min的条件下，制备的聚硅酸氯化铝铁对于pH为6~11的生活污水的混凝处理效果最佳。

Polysilicate aluminum chloride flocculants of various molar ratio of Al to Si are prepared. The influence of ingredient molar ratio, pH value of waste water and the adding amount of flocculant is investigated in treating simulant rolling emulsion.

制备了不同Al/Si摩尔比的聚硅氯化铝，实验考察了成分摩尔比、废水pH值、药剂投加量对除油效果的影响。

A new polysilicate ferric aluminum was prepared by using water glass,ferric sulfate and aluminum sulfate as raw materials.The conditions of preparing PSFA were optimized: the polymerization degree of silicic acid is 0.5; the molar ratio of Fe3+ and Al3+ to SiO2 is 1: 1; the molar ratio of Fe3+ to Al3+ is 1: 1;and the degree of hydrolysis is 0.5;while the influence of the aging time on the coagulation property of PSFA is not obvious.

用水玻璃、硫酸铁和硫酸铝制取聚硅酸铁铝混凝剂，确定了制备PSFA混凝剂的优化条件：硅酸聚合度η为0.5，Fe3+及Al3+与SiO2的摩尔比为1： 1， Fe3+与Al3+的摩尔比为1： 1，水解度B*为0.5，而熟化时间对PSFA混凝剂的混凝性能影响不明显。

Investigating the influences of processing parameters on the C/Si molar ratio of resulted nanosized SiC powders indicated that there was a direct pyrolytic reaction from DMS to SiC as well as the previous proposed two-step reaction. Under the optimized processing conditions, the silicon carbide powders of homogeneous particle size distribution, spherical shape and stoichiometrical C/Si molar ratio are obtained. The silicon carbide particle consists of β-SiC crystallite arranged randomly.

论文系统研究了工艺条件对产物粉体C／Si摩尔比、粉体颗粒尺寸和组成粉体的SiC微晶尺寸的影响；研究了粉体制备过程中可能发生的化学反应，提出了反应过程中除了分步进行的生成SiC的反应外，同时在高温区还存在一步完成的生成SiC的化学反应的观点；通过调整工艺参数，制备得到了粉体尺寸分布均匀、呈均匀球状、C／Si摩尔比符合化学计量比的颗粒尺寸为40nm的纳米SiC粉体。

Molar-tooth structures refer to the aggregations of equal-axised or polygonal microspar calcite with a crystal size of 0.01mm and a clear boundary, which are mainly developed in the Precambrian fine-grained carbonate rocks. The morphology of Molar-tooth can be divided into ribboned, nodular and clastic forms.

臼齿构造是特指那些发育在前寒武纪细粒碳酸盐岩中有清晰边界、粒度在0.01mm左右的由等轴或多边形的微亮晶方解石组成的集合体，其形态可分为条带状构造、瘤状构造及棱角碎块状构造。

Results The SiO2-ZrO2 composites were calcined at 200℃ prior to sulfating, the concentration of sulfuric acid was 1.0 mol/L ,the molar ratio of Si and Zr was 15, the calcination temperature was 500℃, the molar ratio of ethynol and lactic acid is 3/1, the yield of the ester could reach 92.7%.

结果SO4^2-／SiO2-ZrO2固体超强酸催化乳酸乙酯的合成反应适宜的反应条件为：预焙烧温度为200℃，浸泡硫酸浓度为1.0mol／L，硅锆摩尔比为15，焙烧温度为500℃，醇酸比为3时，酯化率可达92.79／6。

Methods One band with a lingual button was bonded on the crown of lingual inclined lower second molar, then a removable, uprighter was put on, the tipping molar was uprighted by using buccal traction force produced by the latex elastics between the button and the hook of removable uprighter.

先在患牙上装戴一焊有舌侧扣的带环，再将预先制作好的带颊侧牵引钩的下颌可摘式磨牙颊向竖直器装戴就位，然后在舌侧扣与矫正器的牵引钩之间使用乳胶弹力圈对患牙进行颊向牵引。待患牙扶正后再使用固定矫正器进行精细调整。

Objective To investigate the effects of interleukin-1 β converting enzyme gene on the biologic characteristics of ovarian cancer cells.

目的 探讨白细胞介素-1 β转换酶的表达，对卵巢癌细胞生物学特性的影响。

Campylobacter: This illness is the most commonly identified cause of diarrheal illness in the world.

弯曲：这种病是最常见的原因查明腹泻病，在世界上。