查询词典 minimum limit

In a method for retrieving sequences having a minimum PAPR in an OFDM (orthogonal frequency division multiplexing) system, by using characteristics in which all sequences of the OFDM system are classified into cosets having the same PAPR, PAPRs of sequences in which early two elements are fixed as '0' are calculated. A sequence having a minimum PAPR is selected from among the calculated PAPRs, and sequences allocated to the coset in which the selected sequence is included are retrieved as sequences having the minimum PAPR.

在一种用于在OFDM通信系统中恢复具有最低PAPR的序列的方法中，通过利用在其中将OFDM系统的所有序列分成具有相同PAPR的同余类序列的特性，计算两个开始项被固定为&0&的序列的PAPR，在所计算的PAPR中选择具有最小PAPR的序列，并且恢复分配至在其中包含所选同余类序列的序列作为具有最小PAPR的序列。

The reason of low system efficiency of the mechanical lifting is: unavailable match between transformer and asynchronous motor with large capacity of equipment and large self-consumption; large average no load less of Y series electrical machinery (31.4% of the total oilfield electrical machinery) with 2.86kw; limited adjustable extent of stroke of the electrical machinery in low-liquid produced wells with minimum value of 4 times per minute for limitation of minimum rotation of the electrical machinery and minimum arc of contact of pulley. Energy consumption will be waste for 1 to 1.5 times per minute is enough.

分析显示，造成抽油机系统效率低的原因主要是：变压器与异步电动机之间匹配方式不合理，设备容量大，自身损耗大；占油田电机总量31.4%的Y系列电机的平均空载损耗大，为2.86kW；低产液井电机的冲次可调范围有限，受电机最低转度和皮带轮最小包角限制，其最小冲次仅可调到4次／min，但1~1.5次／min的冲次即可满足生产需要，造成能耗浪费。

The analytic results obtained from the PCT evaluations revealed that the most limiting accident was the case with a break at the Main Steamline Outside Containment. Its PCT was 1289.15 ℉, which is much below the upper temperature limit of 2200℉ set by the nuclear regulatory authority. The most limiting accident for the minimum water level measured outside the core shroud is the case with a break at the High Pressure Core Flooder Line, the minimum water level drops to 18.4 ft. For this case, even though the water level has dropped to 11.6 ft below the top of the active fuel, the reactor core was still completely covered by the two-phase water.

分析结果显示，对燃料护套最高温度而言，最严重之事故为围阻体外主蒸汽管路破口，其燃料护套最高温度为1289.15 ℉，此温度远在法规10CFR50.46所定之限值 2200 ℉以下；对反应炉最低水位而言，则最严重之事故为高压注水系统管路破口，反应炉降水区最低水位降至18.4 ft，约在有效燃料顶部以下11.6 ft，然而炉心内部仍为双相饱和流体所完全覆盖。

Strip limit minimum rollable gauge and minimum rollable gauge considering productivity are analyzed and derived using new rolling pressure model, work roll surface temperature rise formulae is derived on the basis of mill stand thermal balance. The affecting factors of work roll surface temperature and the influences on the choice of roll size are discussed.

本文从轧机结构设计、力能参数计算、强度设计计算等方面综合论述了辊系参数设计计算的基本理论，在理论上提出了采用考虑粘着摩擦的混合摩擦模型和考虑轧件的弹性变形计算冷轧薄板轧制压力的方法，推导并以冷轧机实测轧制压力验证了轧制压力新模型；应用新的轧制压力模型分析并推导了轧件极限最小可轧厚度和考虑生产率的最小可轧厚度公式；根据工作机座热量平衡原理推导了工作辊温升公式，分析了工作辊温度的影响因素，研究了工作辊温升对轧辊参数选择的影响。

Thread Snap Gages—Minimum Material: Pitch Diameter Cone Type and Vee and Thread Groove Diameter Type for inspecting the minimum-material limit pitch diameter.

螺纹卡规—最小材料：中径为锥形及V形及螺纹为凹槽形的直径，是用于检查最小材料极限的中径。

The lift course of hanging device on wheat no-tillage planter was simulated by using the software of ADAMS. Some important parameters were obtained such as height of the working part relative to ground, the distance between the working part and the rear wheel of tractor, the angle of road pass and the force of hanging point, etc. The key parameters of the hanging device and its best working parameter of hanging device were found out through optimization simulation. Simulation results showed that suspension point had minimum force when variable DV_1 and DV_2 gained corresponding maximum and minimum at scope of structure limit.

应用ADAMS软件对小麦免耕播种机悬挂机构提升过程进行了动态仿真，得到了工作部件的位置高度、工作部件与拖拉机后轮之间的间距、路面通过角以及悬挂点的受力等参数，找到了悬挂机构的关键参数，通过优化仿真，得到了悬挂机构的最佳工作参数，仿真结果表明，设计变量DV_2、DV_3在结构受限范围内分别取其最大值和最小值，悬挂机构悬挂点受力最小。

At the same time, the ballistic limit curves of the Whipple shield in a velocity range from 0.5 km/s to 5.5 km/s was obtained. Comparing to the predicted curve from Christiansen ballistic limit equation, the experimental minimum critical projectile diameter is slightly greater than the prediction.

通过固定弹丸直径，改变弹丸撞击速度，寻找临界撞击速度的方法获得了铝合金Whipple防护结构在0.5～5.5 km/s撞击速度区间内的撞击极限曲线，并与由Christiansen撞击极限方程得到的撞击极限曲线进行了比较，结果表明，实验最小临界弹丸直径略大于预测值。

In determining the volume of the upper limit, the same property should make the minimum threshold limit density to control the construction of high-end villa.

在确定容积率的上限时，同样应对房产密度做出最低下限限制，从而控制高端别墅的建设量。

If one reaches the limit of elasticity in the felt, wood, and metal, and employs the minimum effort to achieve this limit, one gets the crashing fortissimos that may be the real climactic moments of a performance.

如果人们能使毡子、木材、金属的弹性发挥到极致，并且用最小的努力能达到最大的功效，可能真的就在那演奏的一瞬间，人们获得的是绝对的最强音。

Article 29 If the offeree dispatched the acceptance within the time limit specified for acceptance, and under normal circumstances the acceptance would have reached the offeror in due time, but due to other reasons the acceptance reaches the offeror after the time limit for acceptance has expired, such acceptance shall be effective, unless the offeror notifies the offeree in a timely manner that it does not accept the acceptance due to the failure of the acceptance to arrive within the time limit.

第二十九条受要约人在承诺期限内发出承诺，按照通常情形能够及时到达要约人，但因其他原因承诺到达要约人时超过承诺期限的，除要约人及时通知受要约人因承诺超过期限不接受该承诺的以外，该承诺有效。

Core, self psychology is psychoanalytic, but there are crucial differences in how the patient-therapist relationship is viewed.

自体心理学的核心是精神分析，但在如何看待患者-治疗师关系方面，自体心理学和精神分析有着根本性的不同。

High-performance cars brake drum production costs increase less than 10%.

高性能汽车刹车鼓的生产成本增加小于10％。