查询词典 minimum density

When establishing such procedures and in fixing minimum wages, due regard should be given to international labour standards concerning minimum wage fixing, as well as the following principles

在建立此类程序和确定最低工资时，应充分考虑有关确定最低工资的国际劳工标准以及以下原则

Our investigation confirmed that all workers earn at least the local minimum wage, and our sample audit of payroll records showed that more than half were earning above minimum wage.

薪酬 调查小组证实，所有工人的工资均达到当地最低工资标准，调查组查阅的工资记录显示，至少一半工人的收入超过了最低标准。

Our investigation confirmed that all workers earn at least the local minimum wage, and our sample audit of payroll records showed that more than half were earning above minimum wage.

薪酬 调查小组证实，所有工人的工资均达到当地最低工资标准，调查组查阅的工资记录显示，超过一半工人的收入甚至超过最低标准。

Five signals: Shares hit "major" minimum valuation, without taking into account the hidden costs of financing the bank under the premise that the current dynamics of PE in Shanghai and Shenzhen 300 with the valuation of industrial capital into the basic minimum.

五信号：打击不考虑资金的前提下，银行的隐性成本&主要&最低估价，股份认为目前的动态体育在上海和深圳300的工业资本流入基本最低估价。

METHODS:The minimum inhibitory concentration and the minimum bactericidal concentration of tinidazole lotion were m easured using tube culture test in vitro.In vivo effect of tinidazole lotion on trichomonas vaginalis were studied with the model of trichomonas vaginalis in ra bbits.

采用肉汤试管稀释法测定抗厌氧菌的MIC及MBC；采用家兔阴道感染人阴道滴虫的模型，观察其抗阴道毛滴虫的作用。

At last, the efficiency of method is illustrated with fuzzy optimal design of a three-bar truss for minimum weight and minimum deflection.

最后用一个三杆桁架的最小重量与变形的模糊多目标优化设计问题证明了该方法的正确性。

The lift course of hanging device on wheat no-tillage planter was simulated by using the software of ADAMS. Some important parameters were obtained such as height of the working part relative to ground, the distance between the working part and the rear wheel of tractor, the angle of road pass and the force of hanging point, etc. The key parameters of the hanging device and its best working parameter of hanging device were found out through optimization simulation. Simulation results showed that suspension point had minimum force when variable DV_1 and DV_2 gained corresponding maximum and minimum at scope of structure limit.

应用ADAMS软件对小麦免耕播种机悬挂机构提升过程进行了动态仿真，得到了工作部件的位置高度、工作部件与拖拉机后轮之间的间距、路面通过角以及悬挂点的受力等参数，找到了悬挂机构的关键参数，通过优化仿真，得到了悬挂机构的最佳工作参数，仿真结果表明，设计变量DV_2、DV_3在结构受限范围内分别取其最大值和最小值，悬挂机构悬挂点受力最小。

The experiment shows that:(1) In certain light intensity and electric field ranges (145～305V/cm) the material Si∶ with a resistivity of 1E4Ω·cm exhibits a current oscillation phenomenon at liquid nitrogen temperature;(2) At a certain electric field,the waveform of the current oscillation is stable and does not change with time;(3) The dependence relation between the oscillation frequency and light-intensity can be expressed by f=f0(L/L0)α where L0 is the minimum light-intensity needed to stimulate oscillation,f0 is the frequency under L0,L is the intensity of the light,and α is a coefficient that increase with electric field;(4) The modulating coefficient K K=(Imax-Imin/Imax decreases as the light increases;(5) The maximum value of the oscillation Imax decreases with the increase of the light-intensity while the minimum value of oscillation Imin increases slowly.

结果表明：在一定光照和电场范围内（276～305V/cm ，电阻率为10.4Ω·cm的材料在液氮温度下显示出电流振荡特性；在一定的电场下，电流振荡波形是固定的，不随时间变化；振荡频率随光照强度的增大而线性增大；调制系数随着光强的增强而减弱；振荡的最大值随着光照强度增大而减小，最小值随着光强增大而缓慢增大。

The opening of the valve body in a leading role in the orientation of any reciprocating parts, in the active pieces into fixed at the minimum radial clearance of not less than 0.7mm, valves should be in a spy state, the activities of parts and fixed parts Minimum radial clearance of A42C Type Pound-Grade Low Lift Spring Loaded Safety Valve not less than 0.125mm.

阀体中对阀的开启起主导作用的任何往复运动的导向零件，在活动件进人固定处的最小径向间隙不应小于0.7mm，阀处于伺应状态时，活动件与固定件的最小径向间隙不应小于0.125mm。

The opening of the valve body in a leading role in the orientation of any reciprocating parts in the active pieces into fixed at the minimum radial clearance of not less than 0.7mm valves should be in a spy state the activities of parts and fixed parts Minimum radial clearance ofA42C Type Pound-Grade Low Lift Spring Loaded Safety Valve not less than 0.125mm.

阀体中对阀的开启起主导作用的任何往复运动的导向零件，在活动件进人固定处的最小径向间隙不应小于0.7mm阀处于伺应状态时，活动件与固定件的最小径向间隙不应小于0.125mm。

"The operators will suffer a temporary decrease in the number of consumers and short message services as people may not like having to provide their ID cards for a phone number," Xu Junqi, vice-dean with the Policy-Making Institute of the Telecommunications Research Centre under MII, said yesterday.

信息产业部下属的通信决策研究院副主任徐俊其昨天说：&实行手机实名制后，人们可能不太情愿用身份证注册手机号，所以通信运营商会暂时面临用户减少和短信用户减少的问题。&

I don't believe in make-believe!

我不相信这些虚构的故事。