查询词典 material control

In every group, rabbits were subdivided into experimental and control subgroups. 2 Rabbits were bullets injected followed by continuous injected with 13C labeled leucine, glucose, and lactic acid; 3 Blood were drewed before and 150, 160, 170, and 180 min after the initiation of isotopes injection for material analysis; 4 Exhale gas were collected every 5 min in the first 30 min followed by every 30 min there after for material analysis; 5 After centrifuge in low temp the supernatant of the blood samples were collected and went through axon and anon exchange column treatment; 6 Treated blood sample was used for 13C labeled leucine, glucose lactic acid examination through mass spectrograph; 7 The exhale gas was collected for 13CO2 exam through gas-phase mass spectrograph; 8 CO2 total production rate (V13CO2), body various substances production, oxidation speed, and substances metabolic percentage all can be calculated through equations provided by references below; 9 Data was processed through student t test.

分亮氨酸、葡萄糖和乳酸三组各取健康新西兰兔16只，每组再分为高代谢脓毒症组和对照组两部分，建模方法同第一部分；2）三组分别先静脉弹丸式推注再持续灌注13C标记的亮氨酸、葡萄糖和乳酸；3）灌注前抽取动脉血作为背景值，灌注达150，160，170和180min分别抽取动脉血2ml用于质谱分析；4）实验开始后前30min中每5min收集呼出气一次，随后每30min收集呼出气一次，用于气相质谱分析；5）血样经过低温离心取上清液，过阳离子及阴离子交换树脂，再经衍生化处理；6）处理过的血样进入气相色谱－质谱仪，测量其13C标记的亮氨酸、葡萄糖和乳酸丰度；7）实验兔的呼出气通过13CO2气相质谱分析仪测定其中的13CO2丰度（E13CO2）；8）利用文献提供的公式算出CO2总生成率（V13CO2）以及机体各物质的通量、氧化速率以及物质代谢百分比等；9）数据分析处理采用t检验。

Based on the analysis of material factor in crack control, combined with fundamental research, experimental research and enormous engineering practice, the material selection and mixing ratio of mass concrete is studied.

在对控制裂缝材料因素进行系统分析的基础上，结合基础理论研究、试验研究及大量工程实践，对大体积混凝土的选材和配合比设计进行了研究。

By means of solid isotropic material with penalization model and perimeter control method, macro material layout and RVE are optimized.

结合SIMP材料模型和周长控制方法，实现了宏观结构和细观表征体胞的优化设计，获得清晰的材料分布。

By means of the model of solid isotropic material with penalization and the perimeter control method, the macro material layout and RVE are optimized.

结合SIMP材料模型和周长控制方法，实现了宏观结构和细观表征体胞的优化设计，获得清晰的材料分布。

Then the optimal conditions were decided as follows: the ratio of wall-material to core-material should be 8.0 to 2.0, with ployacrylic sodium as dispersing emulsifier, NH4Cl as acid catalyst, and with the time of pouring catalyst being 2 h, the pH value at end point 2.0, the temperature of condensation reaction under control about 70℃, the reaction time 3 h, the stirring speed 1000 r/min.

研究了壁材与芯材的比例、分散乳化剂、催化剂、反应温度和搅拌速度5因素对微胶囊产品的影响，得出最优化的工艺为：壁材与芯材的比例为m：m=8.0：2.0，以聚丙烯酸钠为分散乳化剂，氯化铵为酸性催化剂，加入速度以2 h加完，终点pH值为2.0，缩聚反应温度控制在70℃左右，反应时间为3 h，搅拌速度为1000 r/min。

A method of assessing the functional properties of multi-scale surface was presented based on material probability curve and material ratio curve,and manufacturing control to meet the functional requirements for surface was investigated.

基于概率曲线和支承率曲线，提出一种多尺度表面形貌的功能评定方法，并研究了表面形貌的加工控制问题。

Based on the introduction of the working principles and characteristics of the material blending and pulverization system in the raw material workshop in cement plants, the schematic layout of the control system is proposed.

文中首先介绍了水泥厂生料车间配料及粉磨系统的工作原理和工作特点，在此基础上提出了水泥厂微机配料与负荷控制系统的设计方案。

A blue print was put forward According to the working principles and characteristics of the material blending and pulverization system in the raw material workshop in cement plants, knowledge-based expert systems is applied to the mixture ratio and load control.

在深入分析系统特性的基础上，提出了相应的解决方案：将基于知识的专家系统应用于生料配比控制当中，通过专家系统的规则控制，自动调整原料的配比，使出磨生料的率值控制在要求的范围之内。

Based on the cultivar comparative test carried out in 1998—2003,"Chanong NO.1" sprouted very early in spring and the sprouting values were 0.39~0.96 higher than the control cultivar Wannong95, and 0.35~0.57 higher than Fuding -dabaicha .The content of tea chemic material was abundant in fresh leaves and the contents of tea polyphenols, caffeine, amino acids, polysaccharides and resoluble material were 28.22%, 4.81%, 1.51%, 1.55% and 44.82%. Moreover, their ratios were harmonious, resulted in its excellent quality of the made green tea especially in the aspects of aroma and taste."Chanong NO.1" was strong in cold resistance, especially during the spring frost season.

经1998—2003年品种比较实验，结果表明：该品系春季萌发期特早，与对照皖农95相比，同期萌展值大0.39~0.96，与福鼎大白茶相比，同期萌展值大0.35~0.57；鲜叶中生化成分含量丰富，其中多酚含量28.22%、氨基酸含量1.51%，咖啡碱含量4.81%，水浸出物含量44.82%，茶多糖含量1.55%；各成分比例协调，绿茶品质佳，尤以香气和滋味表现突出；抗寒性强，对倒春寒的抗性也强。

The teacher included to curricular understanding the communication with curricular architect and communicate, wait for tripartite face to the control of curricular standard and the assurance to teaching material, the teacher can blend in his knowledge and opinion in schoolteaching process among them, ability makes teaching material develops the biggest effectiveness.

教师对课程的理解包括了和课程设计者的交流和沟通，对课程标准的把握以及对教材的把握等三方面，教师在授课过程中能将自己的知识和见解融入其中，才能使教材发挥最大效用。

Chrysanthemum of 10 thousand birthday is lax to edaphic requirement, with the arenaceous qualitative loam with fecund, good drainage had better.

万寿菊对土壤要求不严，以肥沃。排水良好的砂质壤土为好。

He unstepped the mast and furled the sail and tied it.

他拔下桅杆，把帆卷起，系住。