查询词典 loading area

Article 9 Existing factories and warehouses and specialized depots and wharves for production, storage, loading and unloading of inflammable and explosive dangerous goods, shall be established at urban border area or ''.

第九条 生产、储存和装卸易燃易爆危险物品的工厂、仓库和专用车站、码头，必须设置在城市的边缘或者相对''。

Extension of 0.86 meters before the fuselage, a wingspan of 1.31 meters widening, machine warily surface increased 9.29 square meters, therefore reducing the wing loading; horizontal stabilizer has also been increased, sweep angle decreases; edge of the wing leading edge of an area of increasing big 34%; wing and fuselage in order to improve aerodynamic performance has greatly improved.

前机身延长0.86米，翼展加宽1.31米，机翼翼面增大9.29平方米，因此翼载减小；水平尾翼也有所增大，后掠角减小；机翼前缘边条面积增大了34%；机翼及机身的改进令空气动力性能有极大改善。

Excellent adiabatic design reduces heat loss and temperature recovering time greatly, ensures no pollution in loading area, and staff can be far away from metaphosphoric acid harm.

良好的隔热设计减少了热量的损失并减少了温度恢复时间，保证装载区无污染，使操作人员远离偏磷酸的危害

This research designed and captured 18 indexes,including length,width,circumference of foot, height of first metatarsophalangeal articulations,height of the arch of foot,height of instep,length of instep,height of internal malleolus, height of external malleolus,area of heel,etc.After statistics analysis of these indexes in different loading situation,foot morphological characteristics at different work loads were collected, which could provide both data and experiment practices supp..ort to the database establishment of foot morphological indexes of Chinese track man.

本研究设计并提取了足长、足宽、足围、足趾高、足弓高、足背高、足面长、内踝高、外踝高和足跟面积等18个指标，对青年田径运动员在四种不同载荷下的足部外形进行统计分析，得到了一套青年田径运动员在不同载荷下的足部外形特征数据，此套数据可以为我国青年田径运动员足部外形指标数据库的建立提供实验操作经验及数据支持。

In this paper TiO2/minerals have been prepared using natural minerals as carrier and the industrial metatitanic acid and the industrial sulfate titanium liquid as the raw material based on the effects such as loading capacity of TiO2, specific surface area of minerals, different mineral source and preparation cost.

本研究以天然矿物对TiO_2的负载能力、比表面积、矿物来源、材料成本等因素为依据，通过对天然矿石载体的活化工艺研究和工业偏钛酸、工业硫酸钛液为原料制取TiO_2／天然矿物复合材料的制备工艺研究，以及样品光催化降解有机物的研究，最终制得了具有光催化活性的TiO_2／天然矿物复合材料。

However, during borehole grouting pile construction of the present, round section piles are used universally. Generally speaking, the boreholes are drilled by a large diameter round piling bit. Because of the restriction of factors of the mud pumps, and drilling equipments, and drilling technique, it would result in such problems as fol lowing: a bigger cutting area and overlarge cuttings volume, and more hole bottom sediments, difficult cuttings discharging, and serverely repeat cuttings breaking, and using more concret grouting amount, and lower drilling speed, faster bit wearing, and longer working period, bigger material and labor ex haust, and higher engineering cost, unreasonable ratio of loading capacity to volume of pile foundation, and lower comprehensive economic benefits, and so forth.

然而，钻孔灌注桩施工中，目前最为普遍采用的是圆形断面桩基，一般采用大口径圆形基桩工程钻头，由于国内生产的泥浆泵、钻具及钻进方法等因素的限制，从而使钻孔破岩面积和体积过大，造成孔底沉渣过多，排渣困难且排浆量大，重复破碎问题突出，混凝土灌注量大，直接反映为钻进效率低、钻头磨损快、施工工期长、材料能耗和劳动消耗大、工程成本较高、桩基荷载能力与体积比不合理、综合经济效益不理想等，这些问题严重影响和制约着钻孔灌注桩施工技术的发展和进步。

On the basis of summering of dividing principle for packing problems,theconstrained pallet loading problem is discussed and a three-area packingalgorithm for the problem is developed.

其后在总结分区布局法的分区原则基础上，研究了约束底盘装载问题并设计了一个三区布局算法来解决它。

Nickel oxide supported silica-pillared zirconium phosphates with high surface area have been prepared successfully by directly loading Ni〓 to uncalcined APS intercalate of α-ZrP followed by calcination.

1采用将金属盐直接负载到未焙烧的α-ZrP的胺丙基硅脂嵌入物上，然后再焙烧的方法，制备了大比表面负载氧化镍的硅柱磷酸锆。

A fine of 10 yuan for each square meter of area contaminated with goods or garbage leaked or dropped from driving-vehicles, or for leaving the sites uncleaned after cargo loading and unloading, or

车辆在行驶中，流漏或者散落货物、垃圾，或者装卸货物后未做到场地整洁的，按污损面积每平方米10元处以罚款

By using ergonomic checklists and analyses, the risk factors were identified as high and low working level, restricted working area, inadequate working posture, overweighted loading, and high repetition. Therefore, countermeasures such as redesigning the workstation, using carts or other supplementary equipments, and tranining the operators were proposed.

而经由人因工程检核表与现场人因分析方法之调查，归纳出现场的危害因子包括过高或过低的作业面、局限的作业空间、不正确的姿势、过重的负荷、以及重复性的作业，针对这些问题，应透过作业环境的重新设计、推车等辅具的使用、与教育训练与以改善。

The statistical analysis of this large set of mutations has led us to propose a diagnostic strategy that should help with the molecular work-up of optic neuropathies.

这一大系列基因突变的统计学分析引导我们提出一个诊断策略，可以帮助我们对视神经病变进行分子学的诊断检查。

The results show that the pipe grouting changes the mechanical parameters of surrounding rocks to achieve the security of engineering objectives by reinforcing surrounding rocks and bolcking the water.

研究表明：小导管注浆一方面改变了围岩的力学参数，另一方面利用浆液的固结特性可以实现堵水和加固围岩的工程目标，使隧道在开挖过程中的安全得到保障。