查询词典 load draft

The Engineer shall measure the RPM of the Main Engine, draft, compression pressure in the cylinder, maximum pressure in the cylinder, load indicator, exhaust temperature, scavenging pressure and temperature, rpm of the supercharger, etc. to grasp the operating condition of the Main Engine, and also calculate

轮机员须测取主机转速、汽缸内的压缩压力、最大爆发压力、负荷指示、排烟温度、扫气压力和温度、透平转速等，获得主机操作工况，同时计算主机输出功率、燃油消耗率、汽缸油消耗率等，根据计算准备&主机输出功率报告&，这些必须经过大管轮的检查和验证，并递交轮机长。

The result clearly reappearances vortex movement at the part load condition and flow field and pressure distribution in the draft tube under different conditions,which were much more rational and similar to practical experiment results,and which assure that the inlet velocity model is very close to the authenticity.

计算结果后处理清晰再现了小流量工况尾水管涡带的运动形式和三种工况下尾水管内部的流场和压力分布，情况和实际符合较好，验证了所建立的进口速度模型的逼近真实性。

With the rapid development of electronic technology, a large amount of non-linear load has appeared in the power system, while absorbing the power of the principal wave , these non-linear load will produce a large number of harmonic wave and pour them into the power system.

随着电力电子技术的迅速发展，电力系统中出现了大量的非线性负荷，它们在吸收基波功率的同时，产生大量的谐波注入电力系统。

Big power load mainly is used for absorbing the power of radio frequency and microwave system .lt can also used as a dummy load of antenna and terminator of microwave transmitter.

大功率同轴负载主要用于吸收射频或微波系统的功率，可作为天线的假假负载，发射机的终端。

Uses the biggest strength training method (80%～100% biggest strength) adding the unarmed quickest speed training method and the biggest strength training method (80%～100% biggest strength) adding 60% biggest strength load training method; two kind of different training load combination makes the acclivity to lie pushes the barbell training, to upper limb shot fast strength development two groups of not obvious differences.

用"最大力量训练(80％～100％最大力量)+徒手最快速度训练法"与"最大力量训练(80％～100％最大力量)+60％最大力量负荷最快速度训练法"两种不同训练负荷组合做上斜卧推杠铃训练，对推铅球上肢快速力量的发展两组没有明显的区别。③

Predecessor regarding this domain research relative weaker, but in view of the fact that this domain affected area is broad, myself ability and the energy are also limited, therefore this article only take plays to the shot result the vital role upper limb fast strength as a breakthrough point, S elects the acclivity barbell to lie pushes is the training method, through uses the different load combination to three experimental groups to carry on separately two month-long trainings, obtains by the time when uses the acclivity lies pushes the barbell training method training the best training load method combination.

前人对此领域的研究相对较为薄弱，但鉴于此领域涉及面较广，本人能力及精力有限，所以本文只以对铅球成绩起重要作用的上肢快速力量为切入点，选用上斜杠铃卧推为训练手段，通过对三个实验组分别采用不同的负荷组合进行为期两个月的训练，以期得出在用上斜卧推杠铃训练手段训练时最佳的训练负荷方法组合。

The situation with the machine physics function of every Slave and different configuration, the load that reuse random takes no account of function is balanced, it is very unscientific, the machine that can give machine function difference so brings needless high load, bring the risk of delay machine even, at the same time high-powered database server also cannot develop its physics property adequately.

每个Slave的机器物理性能和配置不一样的情况，再使用随机的不考虑性能的负载均衡，是非常不科学的，这样一来会给机器性能差的机器带来不必要的高负载，甚至带来宕机的危险，同时高性能的数据库服务器也不能充分发挥其物理性能。

The study results showed that the static interferes between heat and electrical load can be eliminated because of the integral action of the PID governor of DEH control system, dynamic interferes between heat and electrical load are decreased.

结果表明，由于DEH控制系统中PID调节器积分控制作用的存在，能够消除热电荷之间的相互静态干扰。新汽压力扰动时，调节级压力控制回路具有较好的瞬态响应特性；而负荷扰动时，功率控制回路具有较好的动态响应特性。

Author regards topography's effect on underlying horizon rock formation as distributed load, thus obtains expression of subsidiary stress induced by distributed load by integral action.

山体对其下伏岩层可作为分布载荷，对集中力作用下水平岩层中各应力分量积分，便求得山体对下伏水平岩层的附加应力。

In order to calculate the crack expansion life in the action of variable amplitude load for the metal bar with V-shaped notch, the formula of bar fracture frequency was obtained theoretically by setting a size of bar fracture region applied in the engineering. Based on it, the mathematic expression of crack expansion life of bar V-shapednotch tip in the action of variable amplitude load was built.

针对金属棒料在变幅载荷作用下需要较精确地获取其V形槽尖端裂纹扩展寿命的问题，通过给定一个工程上能接受的瞬断区尺寸，获得了棒料断裂频率的计算公式，在此基础上，建立了变幅载荷作用下棒料V形槽尖端裂纹扩展寿命的数学表达式。

Don not attempt to do something which you can not to do.

不要企图做那些办不到的事情。

The expression of CTGF and TNF-αweredetected by immunochemistry and the number of Clara Cells was calculated.

光镜下观察肺组织的病理变化，采用免疫组化染色观察肺组织中结缔组织生长因子和肿瘤坏死因子-α的表达和Clara细胞的数量。