查询词典 latch locking

Panpan doors are installed 3-preventing locks, linking locks and double locking lumps, linking the doors to the doorframes, two loking oints are designed on the part of hinges, the most advanced locking device are installed on the doors, the door locks can be operated from in and out the room, four lumps on the doors insert into the holes on the doorframes, make the doors and the doorframes an integral part.

盼盼牌高级防撬门，配有三防锁、连锁、双锁舌使门扇与门框锁紧，暗藏铰连一侧设两个锁点，在门中间装有国内先进锁具，门锁可在室内室外操作，上下四锁舌可通过导向杆驱动同时插入上下门框方孔内，与门框牢固结合一体，从而达到防撬保安作用。

The first direct measurement with micrometer piston skirt and the outside diameter Do micrometer stop screw to the locking plate position, and then dial indicator card installed and well well inserted under the initial installation of the amount of cards, directly into the cylinder corresponding cylinder kit, adjust the volume of the cylinder rod out in table inserted length, so that small hands dial indicator cell has about 1 volume of pre-press and lock locking rod inserted mother, at the same time, large dial indicator dial to adjust zero, the last cylinder to adjust the volume of good form under test card inserted rods and do at Anvil micrometer and measured the rod between the big hands dial indicator at this time than the "zero" high value is the piston and cylinder liner with the space.

3先直接用千分尺测量活塞裙部的外径并将干分尺止动螺钉扳转到锁紧位置，再将卡装好百分表和初步安装好插杆的量缸表直接卡入对应气缸套内，调整量缸表插杆的伸出长度，使百分表的小表针有1格左右的预压量并锁紧插杆锁母，同时将百分表的大表盘调整到零，最后将调整好的量缸表的测杆和插杆卡在干分尺的砧座和测杆之间，此时百分表大表针比&零&高的数值即为活塞和气缸套的配合间隙。

Locking or non-locking karabiners be used.

使用。打结的绳环或扁带环是禁止使用的。

Under no circumstances shall a chain of normal length quickdraws (connected to each other by either Maillon Rapides, or locking or non-locking karabiners) be used.

在任何情形下不可以将快扣组相连（用锁环、有锁或一般勾环相连）使用。

Construction characteristics - Standard contact and housing dimensions - RAL 7035 grey grip - Cable sleeve for IP44 - Cable gland for IP67 - Plug with key and socket with keyway to ensure perfect coupling - Sockets with spring-locking cover and retaining catch when the plug is inserted, for both IP44 and IP67 - Sockets with locking ring lids and plugs with inclined surfaces and bayonet fitting for IP67 - Fold-back cable clamp for IP67 types - Only factory-preset earth contact position depending on end use - High protection against indirect contacts since the earth contact is the first to established and the last to be broken - Colour-coded to identify the different rated voltages - Perfect interchangeability with EUREKA Series plugs and sockets and with other makers.详情请登入:http://factory.shsap.com/list.asp?id=289

结构特征-触点和外壳标准尺寸-手柄颜色为灰色RAL7035 -堆形过线装置，用于IP44防护等级-填料函，用于IP67防护等级-插头带凸出物，插座带导槽用来保证完好的连接- IP44和IP67 的插座带有弹簧罩，在有插头插入后可以起到止动作用-插座带紧锁罩，插头带有倾斜面用于IP67防护等级的插销式连接-可活动的电缆固定装置用于IP67的防护-在工厂中预设的接地触点位置取决于最终使用-接地触点最先连接，最后短开，所以对防止间接接触具有很高的保护指数-不同的额定电压用不同的颜色来表示，便于识别-与EUREKA系列和其他制造商的插头和插座有极好的互换性

It is provided with rapid opening and closing, and convenient and safe usage, which comprises a lock body with handle (1) and a lock head (2), characterized in that at one side of the lock body (1) there is a shaft pore (7), which is combined with the rotary shaft on the lock seat to form the rotary mechanism; at the other side there is a lock port (8) with hump surface (9), which is mated with the lock tongue (16) on the lock head (2) to form the locking mechanism; at the oblique upside of shaft pore (7) on the lock body there is a hollow cavity with lock core, in which there is a lock strip (6) fixed on the lock seat which is combined with the hollow cavity with lock core to form the locking and limiting mechanism.

提供一种开启关闭轻快，使用安全方便的超低温冷冻柜的柜锁。包括带手柄的锁体(1)、锁头(2)，其特征是锁体(1)一侧有一个轴孔(7)，与固定在柜门上的锁座的转轴构成转动机构；锁体(1)另一侧有一个带有驼峰(9)曲面的锁口(8)与锁头(2)上的锁舌(16)啮合，构成锁紧机构；锁体(1)的轴孔(7)斜上方有一个装有锁芯的空腔，空腔内装有一个固定在锁座上的锁挡片(6)与装有锁芯的空腔组成锁体锁止和限位机构。

Its, introduce one kind phase locking of adopting ring frequency synthesizer and 89C51 frequency modulation transmitter where one-chip computer control, have recommended the phase locking to surround performance of the integrated circuit (BU2618FV ) and typical application.

其之，介绍一种采用锁相环频率合成器(BU2618FV)和89C51单片机控制的调频发射机，并介绍介绍了锁相环集成电路（BU2618FV）的性能和典型应用。

The locking ring also carries an indicator arrow and it is only when the indicator arrow is aligned, by turning the locking ring, with the indicator arrows and that the closure can be opened by lifting or flipping the projecting edge of the closure.

锁环也带有指示箭头，只有在通过旋动锁环使指示箭头与指示箭头对准时，才可通过抬起或翻转罩盖的突出边缘来开启罩盖。

Contents: 32-oz formula mixing pitcher, locking lid, adjustable locking ring, spiral post, mixing blade, mixing handle, instructions.

内容： 32盎司配方混合投手，锁盖，可调锁紧环，螺旋后，搅拌叶片，搅拌处理，指示。

Locking wheel locking device, the frame legs foot frame outreach rotary power with no less than 78.4 N.

滚轮锁止器锁紧时，腿框脚框外展回转起动力不小于78.4N。

They have quite a lot of work to do.

他们有许多工作要做。

Let us give you a more elaborate example of this process.

让我们给你这个过程的更多的详细例子。