查询词典 laser beam printer

This study used the pick-up head from the commercial DVD-ROM as the basis for optical path, and drilled a 2mm hole on the focusing object lens. After combined with the design of a beams plitter, the laser beam source of the two DVD formed two in-line laser beams. One laser beam passed through the undrilled part, and focused on the surface of the object to be tested, in order to measure the displacement variance of the surface.

於三自由光学测探头的研制上，则将DVD 探头之聚焦物镜做一2mm 的穿孔，於搭配一分光镜的设计后，使个DVD 的光源形成同轴光束，将其中ㄧ光束经由聚焦物镜未穿孔部分，聚焦於待测物表面，用以测待测物表面的位移变化，另一光束则穿透过聚焦物镜穿孔部分，直接将光束投射至待测物表面，作为待测物表面之个角的变化测。

In the high accuracy diffraction measurement of laser for a tiny wire,polarization direction of laser,laser beam property,and deviation of the beam center from the wire center have an effect on the measuring result.

在丝径的激光高精度衍射测量中，激光的偏振方向、光束的几何属性和光束中心对衍射体对称中心的偏离都会影响测量的结果。

To suppress the noise which caused by the fuzzy character of XLPE sample, the size of the photodetector was determined based on the analysis of the light intensity distribution in the spatial frequency plane when the laser beam passing through the sample was collected by lens. A series of detectors were designed to eliminate the time response decreasing effect caused by the increasing of the detector size. The developed laser system could resolve defects of 40 um diameter in XLPE tape with the 120um diameter and 400Hz scanning laser beam. after above results was used.

为了消除由于XLPE材料光弥散效应引起的信号噪声对信号幅度测量的影响和提高测试速度，研制了阵列组合式光电探测器，理论分析和实验验证都证明了该探测器有较好的频响特性和较低的噪声水平，应用这两项成果组成的信号系统及微机数据采集电路可在400Hz扫描频率下，扫描宽度所限制的120μm光束直径下获得40μm的测量分辨率。

On the base of the single-diameter laser-scanned measuring technology, a double direction laser-scanned measuring system is presented. Which combinate the laser-scanned measuring technology with special optical system. In the system, the collimation semiconductor laser-scanned beam scanning two perpendiculars direct of one plane of the measured workpiece at the same time is made. The beams with the dimension information of two perpendiculars direct are processed by the scanning receive system, the high-speed photoelectric transition and electronic data process. Two measured results of the diametric directs and ellipse tolerance,etc, parameter, of the turning workpiece on the same plane are obtained by non-contact automatic measurement. The problem of non-contact measurement of two perpendiculars direct of one plane of turning workpiece is settled. It processes many peculiarities, such as high speed, high accuracy and non-contact automatic measurement, etc.

在单向激光扫描检测技术的基础之上，提出了一种双向激光扫描检测系统，其采用激光扫描检测技术与特殊光学系统相结合，用准直半导体激光扫描光束对被测工件径向某一截面的两个相互垂直方向同时扫描，经扫描接收光学系统、高速光电变换、电子学系统和微机数据处理系统，对将携带有垂直方向被测量信息的光束进行处理，实现了回转体工件同一截面两个垂直方向的径向尺寸和椭圆度等参数的非接触自动测量，解决了同时非接触测量回转体零件同一截面两个径向尺寸的难题，它具有高速，高精度和非接触自动测量等特点。

A general Godunov finite difference schemes-WENO schemes which had fifth-order accuracy was used to make a numerical calculation for 2-dimensional axis symmetrical laser-supported plasma flow field under laser ablated solid target and laser ablated propulsion efficiency parameters(mechanical coupling coefficient etc.) was obtained by the simulation.The models of the calculation of ionization degree of plasma and the interaction between laser beam and plasma and the simplified eos of plasma were considered in the simulation.

采用针对高温气体电离度的一种近似计算方法，以及具有五阶精度的广义Godunov差分格式-加权本质无振荡格式WENO(weighted essentially non-oscillatory schemes)，给出了高温气体状态方程的简便描述，并考虑激光与等离子体的相互作用，模拟了强激光与固体靶相互作用时激光支持靶面等离子体流场的动态物理过程，并给出了不同参数条件下激光烧蚀固体靶的推进效应参数。

BSpatial characterization of laser induced Cu plasma in air with different laser focusing distancesThe plasma spectra induced by pulsed laser ablation of copper target are measured. By adjusting the distance of the len-sample, the spectrum of air spark plasma、 Cu plasma and the reciprocity of both plasmas are analysed. From the result, it has been shown that the focusing of the laser beam has an important infunence to analyse the properties of the sample.

b 不同的激光焦点位置产生的等离子体光谱的空间特性研究激光烧蚀置于空气中的Cu靶产生等离子体，通过调节透镜与Cu靶的距离，本文观测了激光烧蚀空气产生的空气火花等离子体、激光直接烧蚀铜靶产生Cu等离子体以及空气火花等离子体与Cu等离子体相互作用等不同情况下的激光诱导击穿发射光谱，激光束焦点的位置在分析材料性质的过程中有着重要的影响。

The results are introduced in this paper. Backscattered light energy is 7.8% of laser energy when laser is focused on Au disk target; when laser beam is smoothed, it is 6.2%. The comparison shows that laser smoothing can restrain backscattered light efficiency.

结果表明：激光辐照Au盘靶时，在聚焦条件下背向散射能量约占打靶激光能量的7.8%；在束匀滑条件下背向散射能量份额下降到6.2%左右，证明了束匀滑可有效抑制背向散射。

Backscattered light energy is 7.8% of laser energy when laser is focused on Au disk target; when laser beam is smoothed, it is 6.2%. The comparison shows that laser smoothing can restrain backscattered light efficiency.

在聚焦条件下背向散射能量约占打靶激光能量的7.8％；在束匀滑条件下背向散射能量份额下降到6.2％左右，证明了束匀滑可有效抑制背向散射。

The author has accomplished the following tasks:1. presented the general scheme of the profile measuring system;2. presented four methods of laser collimation, realized 3 of them with the software of ZEMAX, and meted the requirement of the system design;3. realized the laser beam expanding from point-laser to line-laser wide enough to cover the flange trackside;4. after image grabbing and processing, picked up the profile of the train wheel.

作者独立完成的工作包括： 1、提出了曲面测量的光学系统的整体方案； 2、提出了四种激光扩束的方案，用光学设计软件ZEMAX完成了其中三种的设计；经过像差分析和追迹，达到了准直扩束的要求； 3、点光源到线光源的单方向扩展，达到了覆盖轮缘踏面的要求； 4、通过实验采集图像和图像处理，提取出被测轮缘的轮廓。

In this thesis, Based on the advantages of diode-pumped solid-state laser in Chapter 1, the development of diode-pumped solid-state laser is introduced. The trends of DPSSL are pointed out, the wide application fields ,as well as the bright market future of high power DPSSL are also summarized. In the Chapter 2 , all kinds of solid-state laser gain materials are introduced in detail. In the Chapter 3 , the theory on the mode-matching of the pump beam and the cavity mode is analyzed in detail based on the basic theory and work principle of LD-pumped all-solid-state laser.

本论文第一章从二极管泵浦固体激光器的优势出发，介绍了二极管泵浦固体激光器的发展，指出了DPSSL的发展方向，概括介绍了大功率DPSSL的诸多应用领域和广阔的市场前景；第二章对固体激光增益材料作了详细的介绍；第三章基于LD泵浦固体激光器的基本理论和工作原理，从理论上详细分析了LD端面泵浦激光器中泵浦光与腔模的匹配问题。

The small blue capacitor has very high chances to go fully shorted compare to electrolytic capacitor which is very rare.

小蓝电容器具有很高的机会去充分地缩短了比较电解电容器，这是非常罕见的。

In the Italian campaigns of 1513 and 1515, when the Swiss won the victories of Novara and Marignan, he acted as army chaplain.

在意大利的运动， 1513年和1515年，当瑞士赢得了胜利，诺瓦拉和marignan ，他担任军队的牧师。