查询词典 jointing plane

The Φ(subscript PSⅡ), Fv/Fm and qP were increased but qN was decreased with increasing of chlorophyll a, the rate of heat dissipation was increased with the increasing of chlorophyll b, and the carotinoid increasing enhanced the rate of heat dissipation of dryland and carbon assimilation of irrigated cultivar The Φ(subscript PSⅡ) and qN of dryland cultivar treated by control were higher than that of irrigated cultivar in jointing stage significant, indicating that the characteristics of drought-resistantce of winter wheat could be displayed in the jointing stage, and the drought-resistant capability could be increased by enhancing the practical photochemistry efficiency and heat dissipation in jointing stage.

拔节期对照处理的旱地品种的Φ和qN显著高于水地品种，在该时期品种抗旱性差异表现较为明显，能够通过提高光合机构实际光化学效率和热耗散来增强光合机构对干旱的适应能力。

In the whole growth period of spring wheat, the response was different in yield and phase growing on climate change, such as the appearing time of sprouting, jointing, tasselling and maturity being ahead but milking being postponed. That is to say, it shortened the spring wheat's nutrition growth stage of seeding-sprouting, elongated the sprouting-jointing stage, cut down the generative growth in the jointing-tasselling phase, prolonged the tasselling-milking stage, and shortened the milking-maturity stage. These finally resulted in the shortening of whole growth period.

在春小麦整个生长发育过程中，其阶段生长和产量对气候变化的响应不完全一致：气候变化使该地区春小麦出苗期、拔节期、抽穗期和成熟期的出现时间均提前，而乳熟期出现时间推迟，导致播种－出苗期的营养生长阶段缩短、出苗－拔节期的营养生长阶段延长、拔节－抽穗期的生殖生长阶段缩短，抽穗－乳熟期的生殖生长阶段延长，乳熟－成熟期的生殖生长阶段缩短，最终造成全生长期缩短。

In this paper, an iterative approach to potential field continuation from curved surface to plane is proposed. The continuation of potential field data from a curved surface to a plane can be viewed as an inverse problem of upward continuation of plane potential field data, getting a linear integral equation. Through viewing the potential field data on the curved surface as the data on the average elevation plane of the curved surface, then using the wavenumber domain generalized inverse algorithm to downward continue the data from the average elevation plane to a given plane, and a topography correction based on the change of curved surface relative to its average elevation is implemented to the downward continued data on the given plane, finally the downward continued data plane is upward continued to the curved surface.

本文提出一种位场数据曲化平的迭代方法，即通过把位场数据曲化平视为平面位场数据向上延拓的反问题，得到曲化平的线性积分方程，再把曲面上位场数据视为曲面平均高程面上的位场数据，利用向下延拓的波数域广义逆算法把平均高程面上的位场数据向下延拓到设定平面上，再根据曲面和其平均高程面的相对起伏对设定平面上的向下延拓数据进行起伏校正，最后再把所得平面上的位场数据向上延拓得到曲面上的位场数据，并进行迭代。

3Ensemble character of structural planes as follows: In left dam abutment, meta basalt schistosity is main, and the structure is clockwise. Low dip angle jointing didnt develop in rock mass; In right dam abutment, rupture and jointing structural plane is main, and the structure is reversed. The structure was of obvious macroscopical slaty character. Constructional soft rock mass belt with some thickness developed.

3通过对上述结构面的分析，得出其总体特征为：左坝肩以变玄武岩片理为主体，呈顺向结构，岩体内缓倾角节理极不发育；右坝肩主要为断裂及节理型结构面，呈反向结构，且具有明显的宏观板状结构特征，并发育有一定厚度的构造软岩带。

Analyze the failure models of rock slope, and then classify the sliding plane, the sliding plane can be divided into self-born sliding plane, appendiculate sliding plane and mixed sliding plane, furtherly summarize the selection method of mechanics parameters to each types. Based on the classification, the author establishes the mechanics model of each sliding plane.

论文主要研究内容和结论如下：(1)阐明了边坡滑动面力学参数取值的研究对象、重点及其研究意义，简要回顾了滑动面分类、结构面强度取值、滑动面试验强度取值和力学参数反算的研究现状，针对目前研究中存在的一些问题，提出了本文的主要研究内容。

Analyze the failure models of rock slope, and then classify the sliding plane, the sliding plane can be divided into self-born sliding plane, appendiculate sliding plane and mixed sliding plane, furtherly summarize the selection method of mechanics parameters to each types. Based on the classification, the author establishes the mechanics model of each sliding plane. Discuss the influence of water and weathering and sedimentation conditions on rock slope, and then specify the geological cause of rock bedding slope, counter-tilt rock slope and cracked rock slope.

2分析了岩质边坡的几种主要破坏模式，在此基础上对岩质边坡滑动带进行分类研究，从大的方面主要分为自生型滑动面、依附型滑动面和混合型滑动面三类，总结与各类滑动面相适应的力学参数取值方法，从而建立岩质边坡滑动面的力学分析模型，讨论水、风化和沉积环境对岩质边坡的影响，归纳了顺层岩质边坡、反倾岩质边坡和破碎岩质边坡滑动面的成因。

At the clock point to 1:20 minutes for,"E11" step on plane door's counter first , it give service to the figure appear Le,I at the moment take out our step on plane board stand up on front, thank let she check up and affirm for, she received out step on plane board after, at the moment at the it above writing same words after and pass on go back for I, I'm one look meane feeling big thing don't be good: she already take our step on plane broad on the "E11" step on plane door use red pencil for draw out,at it's side write on "C8A"three words.at once, I'm all body the spirit be encourage call into actior up: I'm at once for first response's consciousness to,we're wall unable to catch up with this one's regular plane Le.

当时钟指向1：20分时，&E11&登机口柜台前，其服务员的身影出现了，我立即拿出我们的登机牌起身上前，想让其检查并确认一下。她接过我们的登机牌后，立即在其上面写了几个字后又递还了给我，我一看就觉得大事不好：她已把我们登机牌上的&E11&登机口用红笔划掉，在其旁边写上&C8A&三个字。顿时，我全身的神经被激淩发动了起来：我当时的第一个反应是意识到，我们将赶不上这趟班机了。

A movable plane is built that is perpendicular to the projection of sightline in xz plane; a radial from camera position to mouse point is built and the mouse wheel is used to control the forward and backward movement of the movable plane along the sightline direction; the intersection point of the mouse radial and the movable plane can be moved to any position in 3D space by moving the moveable plane; the coordinate of the intersection point of the radial and the moving plane is calculated, taken as the new coordinate of the object to be moved which is added into the romance pipeline, and the object movement can be implemented.

论文摘要：为优化虚拟三维管理领域的物体移动操作，实现利用鼠标完成物体在三维空间中任意点的移动过程，引入可移动平面的概念，在三维空间建立垂直于视线在xz平面投影的可移动平面；建立1条从摄像机位置到鼠标位置的射线，由鼠标滚轮控制可移动平面在视线方向上的前后移动；通过移动可移动平面，使鼠标射线与可移动平面的交点可以到达三维空间中的任意位置；计算射线与可移动平面的交点坐标，将其作为待移动物体新坐标放入渲染流水线，从而完成物体移动。

The Cretaceous sedimentary rocks were baked by the basaltic lava flow erupted in the Early Miocene, contracting in volume owing to loss of water contained mainly in the clays of the clastic rocks, and thus forming the columnar jointing. According to the occurrences of jointing and the sedimentary strata the authors calculated the two different rotations of the Mellit block: the block tilted toward 338° for 18° from Late Cretaceous to the beginning of Miocene, and tilted toward 138° for 18° since Miocene.

可以合理地假定柱状节理在形成时是垂直于大地基准面的，根据柱状节理和沉积岩层的产状，笔者计算出Mellit地块的两期旋转事件：自晚白垩世初期到中新世初期该地块向338°方向倾斜了18°，而自中新世以来又向138°方向倾斜了18°。

The experiment with 9 treatments including 3 growth stages: from wheat seedling to jointing, from wheat jointing to flowering and from wheat flowering to maturity and 3 water gradients: the capacity of water in field from 30% to 40%, from 50% to 60% and from 70% to 80% was designed and the content of protein and nucleic acid and the osmotic potential of winter wheat leaf were measured for the research on drought stress affecting them.

方法］将小麦生育期划分为出苗至拔节、拔节至开花、开花至成熟3个阶段，同时设3个水分梯度，即田间持水量的30%~40%、50%~60%、70%~80%，共9个处理，测定冬小麦叶片的蛋白质、核酸含量和叶片渗透势，分析干旱胁迫对不同生育期冬小麦叶片蛋白质和核酸含量的影响。

In the chapter 2, the theoretic knowledge about the photosensitive resin and the grinding tools was firstly introduced.

第二章阐述了光固化树脂结合剂磨具的相关理论研究。

Do not use the program's indenting or margin-setting features; these will be added during typesetting.

不要使用缩排，页面边缘设置之类的选项，偶看不大懂。