查询词典 interference fit

In this paper,the static and dynamic formulas are derived for the calculation of interference fit and analysis of the stress.

本文根据材料力学和弹性力学理论，对电主轴的配合特性进行了分析，分别推导出电主轴在静态和高速运转条件下，主轴过盈量和应力分布的理论公式。

It is indicated that this method of treating interference fit and temperature load has a positive effect on the similar structural strength analysis.

利用温度变化处理过盈配合，通过计算在进出口温度下的温度场分布后计算温差应力，这种分析方法对其他需要考虑装配应力和温差应力的结构强度分析有一定的借鉴意义。

These prostheses were implanted in shoulders demonstrating a suboptimal interference fit of the humeral component.

这些植入的骨质均位于适当的肩周部位对肩关节功能干扰不明显。

The existing of centrifugal force may cause the variation of the interference fit very greatly.

离心力的存在，使得过盈配合特性发生了很大的变化，尤其当主轴高速旋转时，其影响更加明显，成为影响过盈配合特性的主要因素。

A detailed analysis on interference fit of hub was carried out by means of elastic mechanics and finite element method, in view of the above, the shortcomings of elastic mechanics method and the advantages of finite element method have been pointed out.

用弹性力学和有限元方法对轴毂过盈联接进行了详细的分析，据此指出了弹性力学方法的弊端和有限元方法的优势。

The deformation of journal bearings produced by interference fit ting,oil film temperature and pressure was simulated by ANSYS.

利用ANSYS软件对滑动轴承在过盈装配和油膜压力与温度的作用下轴承套产生的几何变形进行了模拟仿真。

The equivalent stress plot of interference fit is acquired by running the program.

由此得到其静/动态过盈配合的等效应力云图。

Spindle is a key unit of the high-speed machine tool,while the interference fit between spindle and motor rotor is one of the most important factors influencing the performance of the spindle unit.

主轴是高速机床的核心部件，机床主轴与电机转子间过盈配合特性是影响主轴性能的重要因素。

The simulation verification to the clutch housing and the sleeve assembly was implemented by using finite element method. Analysis shows that the leaking reason is due to the interference fit of the assembly.

利用有限元方法对离合器壳体和套筒的装配进行模拟验证表明，泄漏的原因是在装配时两者过盈配合导致的。

A three-dimensional finite element model corresponding to the animal model was established. The initial stress distribution was simulated by the Interference Fit Options in the finite element software.

另外，建立与动物实验相对应的有限元模型，利用有限元分析软件中的过盈配合方法计算骨-种植体界面的初始应力分布。

Connectors are lines that can be anchored to particular places, called glue points , on the graphic object.

连接符，可固定在图形对象的特定的地方的线条。

Another way of putting it, too many agents have a say in each other's work, and bureaucratic rigor mortis sets in.

另一种表达是，太多的作用物在彼此的工作里都有话语权，官僚的僵尸开始抬头。