查询词典 infrared controller

B/S Construction is used in this system, in which the application and management are separated by the proscenium and the greenroom. The controller can carry out the first usage through the proscenium and the greenroom to arbitrarily add, delete and revise the self-defined function and look through something about the registered information and ordered goods through the controller at backstage.

该系统采用B/S结构，通过前台后台将对该系统的应用与管理分开，管理员通过后台可对前台页面相关模块数据进行初始化，可实现任意的添加、删除、修改等自定义功能，通过后台管理员还可随时查看用户的注册消息及订货情况。

The performance of the controller was tested by computer simulations in MATLAB/Simulink. Results show that the controller can adapt to different level hemiplegic patients, and has better dynamic performance and stronger robustness.

控制系统在MATLAB/Simulink的环境下仿真，结果表明所设计的鲁棒控制器能适应不同程度的偏瘫患者，具有较佳的动态特性和很强的鲁棒性能。

Integrated 10BASE-T/100BASE-TX/1000BASE-T transceivers · 10/100/1000 tri-speed MAC · Host interfaces - PCI v2.2, 32/64-bit, 33/66-MHz - PCI-X v1.0, 64-bit, 133-MHz · MII/GMII/TBI interfaces for external transceivers · Ultra-deep, 96-KB on-chip packet buffer · Dual high-speed RISC cores with 16-KB caches - Programmable, in-line packet classification · SMBus controller · On-chip power circuit controller and Wake on LAN power switching circuit

集成号10Base-T/100Base-TX/1000Base-T收发器·10/100/1000三速陆委会·主机接口- 2.2版的PCI，32/64，33/66-MHz -的PCI - X的1.0版，64位，外部收发器133兆赫·信息产业部/的GMII / TBI的接口·超深，96 KB的片上分组缓冲·具有16 KB的缓存双高速的RISC核心-可编程，在线数据包分类·SMBus控制器·片上电源电路控制器和网络唤醒电源开关电路

Firstly, the conception of networked control systems, introduction and content of networked control systems theory are introduced. Secondly, the network induced time delays of different topology structure are analyzed and then the corresponding plants are modeled. Based on the above, a compensation scheme for the transmitting time delay from controller to actuator is developed. And also a sliding mode controller that makes the system robust is designed.

首先，介绍了网络控制系统的概念和网络控制系统理论的发展概况、研究内容及现状；其次，对不同拓扑结构的网络控制系统的延时进行分析并引入了相应的系统模型：在此基础上，针对网络传输产生的控制器到执行器的延时问题，对不确定输入延时系统提出了一种补偿策略，设计了滑模控制器，使系统具有强鲁棒性。

A novel method for design of controller enforcing the constraints is presented. First the constraints involving the marking and Parikh vectors are transformed into the constraints involving Parikh vector only using Petri net state equality, and then the controller is constructed based on the viewpoint that a place can be seen as a linear inequality constraint on the Parikh vector.

该方法首先利用Petri网的状态方程把关于标识向量和Parikh向量的不等式约束转变成关于Parikh向量的不等式约束，然后基于Petri网库所是关于Parikh向量的不等式约束的观点构造控制器。

In order to reduce the influence caused by the controller parameter variations and the plant parameter perturbation, and assurance the tracking performance and the restraint disturbance performance, the improved robust two degree-of-freedom control structure and the linear matrix inequation design method are adopted to design the robust two DOF controller of the servo system in this thesis.

为了降低控制器参数及被控对象参数摄动对系统性能造成的影响，同时，保证系统的跟踪性能和抗扰性能不变。

Our work on the problem of robust controller design for linear time-delay systems with nonlinear uncertain parameters are mainly concerned about thefollowing three aspects:Firstly, based on Lyapunov theory and using linear matrix inequation method, we put forward a plan to design the state feedback controller of the system with high structured uncertainty and matrix polytope structured uncertainty.

第三，在非结构不确定性假设下，基于系统的解和Bellman-Gronwall不等式，得出这类系统鲁棒稳定的充分条件。

Mechanical inertia identification method was deduced from the current model and the mechanical model of the PM motor.The gain of the speed controller was obtained through the mechanical inertia,a group of controller gains obtained through several turns of identification.

首先通过电机电流和电压方程以及运动方程推导出转动惯量的计算方法，再根据系统的转动惯量计算出速度控制器参数，在进行多次辨识和计算后，可以得到一组速度控制器参数。

The Detector of Infra-red remote Controller is mainly used to test the function of controller.

论文叙述了一种比较通用、兼容和具有良好人机界面的红外遥控器检测仪的开发过程。

It is due to PID controller parameters are not designed well. The design method of inverter instantaneous voltage PID controller based on pole-assignment is proposed for the first time in this paper.

针对逆变器电压单环PID控制系统性能不很理想的原因进行了分析，指出其原因是PID控制器参数设计方法欠佳。

Continuously improve the production mechanism, to provide customers with better quality products and services.

不断的完善生产机制，给客户提供更优质的产品及服务。

B:Yes, he was the very prize-winner in the court tennis ten years ago?

是的，他是十年前的世界网球冠军。