查询词典 incomplete dislocation

To describe the properties of the interphase,we presentthe generalized interlayer model,based on which the various crack problemsare reduced to correspondent Cauchy singular integral equations by virtue ofboundary conditions and dislocation density functions.

适应这一点，我们给出广义界面层模型以描述界面相物质的性质。

In the numerical calculations,the unknown density of dislocation is approximated with the product of fundamental function and Chebyshev polynomials.The calculations show the present method yields rapidly converging and high accurate numerical results.

在数值求解这组奇异积分方程中未知位错分布密度近似为基本密度函数与Chebyshev多项式之积，计算表明，本文方法的数值结果不但收效快而且精度高。

The results showed that chemisorption of Hg atoms could facilitate dislocation emission and motion.

结果表明：加载裂纹吸附Hg原子后能促进位错的发射、增殖和运动；当吸附促进位错发射和运动达到临界状态时，脆性微裂纹就在原裂纹顶端或在无位错区中形核并解理扩展。

The results showed that chemisorption of liquid metal atoms could facilitate dislocation emission ,multiplication and motioll.

结果表明：液体金属吸附后能促进位错的发射、增殖和运动；当吸附促进位错发射和运动达到临界状态时，脆性微裂纹就在原裂纹顶端或在无位错区中形核并解理扩展。

Objective To discuss the clinical treatment of unstable dislocation of the sternoclavicular joint with clavicle hook plates.

目的 探讨锁骨钩钢板切开复位治疗不稳定性胸锁关节脱位的临床意义及疗效。

Objective: To evaluate therapeutic effect of Acromioclavicular hook plate on Fracture of the Distal Clavicle and Dislocation of Acromioclavicular joint.

目的：评价锁骨钩钢板治疗锁骨外端骨折和肩锁关节脱位的疗效。

Objective To analyze and explore outcome with AO/ASIF clavicle hook plate for dislocation of acromio-clavicular joint.

目的：分析和探讨锁骨钩钛板对肩锁关节脱位进行切开复位内固定手术的临床效果。

Objective To investigate the treatment effect of Wolter crook plate on distal clavicle fracture and acromioclavicular dislocation.

目的 研究Wolter钢板治疗锁骨远端骨折及肩锁关节脱位的疗效。

Furthermore, NiAl precipitates coarsen in the Cr phase and dislocation appears in the Cr phase.

此外，Cr相中的NiAl微粒粗化，在Cr相中出现了位错线。

The results show that the flow stress decreases with increasing deforming temperature and increases with increasing strain rate. The flow stress of the alloy during hot compression deformation can be described by constitutive equation in hyperbolic sine function with a hot deformation activation energy of 196.27 kJ/mol. Partial recystallization takes place in the alloys deformed at a high temperature or at a low strain rate, and large number of dislocations and subgrains are observed in the alloy. The elongated grains observed in the samples coarsen with increasing temperature and decreasing strain rate. Correspondingly, the subgrain size increases and the dislocation density decreases. The main soften mechanism of the alloy transforms from dynamic recovery to dynamic recrystallization.

结果表明：Al-Cu-Mg-Ag耐热铝合金在热压缩变形中的流变应力随着温度的升高而减小，随着应变速率的增大而增大；该合金的热压缩变形流变应力行为可用双曲正弦形式的本构方程来描述，其变形激活能为196.27kJ/mol；在变形温度较高或应变速率较低的合金中发生部分再结晶，并且在合金组织中存在大量的位错和亚晶；随着温度的升高和应变速率的降低，合金中拉长的晶粒发生粗化，亚晶尺寸增大，位错密度减小，合金的主要软化机制逐步由动态回复转变为动态再结晶。

That snake Alaric named Archbishop...

庇护。。。那个毒如蛇蝎的Alaric被命名为大教主。。。

You have done lots of magical things to be amazed at.

你做了很多神奇的事物感到惊讶。