查询词典 in alignment

At the same time of theory research, the fabrication: photoengraving, sputtering, diffusion scraping and polishing surface, light testing and alignment of electrodes is studied by experiment deeply.

型电极结构来调制2×2光波导开关；在进行理论研究的同时，本文对光开关的工艺制作：光刻，溅射，扩散，抛磨端面，套刻电极等每一步工艺都进行了深入详细的实验研究。

In this paper,an optical alignment system is introduced using gratings with different constant for the step projection photoetching machine.

介绍一种在分步投影光刻机中，采用不等栅距光栅进行对准的系统。

When manufacturing the resistor memory, the metal upper layer is formed by self-alignment with no requirement of adding masking and photoetching steps, so as to reduce process complexity, improve reliability of storage performance, and reduce process cost.

在制作所述的电阻存储器时，以自对准形成的金属上电极层，无需为制作上电极图形增加掩膜和光刻步骤，减少工艺复杂度，可提高存储性能的可靠性和降低工艺成本。

The pipet graduation-alignment system is a fast, simple, and more aseptic way to bring graduations to your line of sight.

移液管刻度校准系统是一种将刻度对准视线的快速/简便/无菌的方法。

The added length adds superior alignment and support of the piston rod as well as provides maximum load bearing support.

增加的长度增加了优越的准及活塞杆的支持，并提供了最大的承重支持。

A pitman fractured at the position of abrupt change of cross-section in alignment after assembly.

某连杆在装配后的校直过程中在截面突变处发生断裂。

This paper analyzed the randomness of the relative position relation between the common vertical line of the two axes of a coupling and two centers of a coupling during installing machines,and the randomness of the position of the support plane on which a machine is installed.It pointed out the errors formed by the two randomness and illustrated the faults of the four parameters system which is used in describing the shaft alignment error of a coupling by abroad technician.

分析了机器安装过程中联轴器两轴线的公垂线与联轴器中心的相对位置关系的随机性及机器地脚支承面方位的随机性，指出了两种随机性所产生的误差，说明了国外工程界在描述联轴器对中误差时所用的4参数体系存在的不足。

And then interchange linear combination of the basic design data and theoretical requirements, detailed design of horizontal alignment and longitudinal linear design of the contents of requirements and attention to matters described in this premise, the cloverleaf interchange for the exchange-type linear design, including the main line, cross line, linear ramp of the plane and the design of linear vertical section at the same time, the use of the CAD design and data synchronization software drawings, the design process to ensure the accuracy of planar graph.

然后结合互通式立交线形设计的基础性数据以及理论要求，详细对平面线形设计和纵断面线形设计内容、要求以及注意事项进行了阐述，在这前提下，对该苜蓿叶型互通立交进行了线形设计，包括对主线、交叉线、匝道的平面线形和纵断面线形进行设计，同时，采用了CAD软件与数据设计同步绘图，确保了设计过程平面图形的准确性。

"If the rider is able to sit in balance with his seat bones well underneath him and his upper body in correct alignment over his hips, the pliancy of the spine in the loin area will allow him to remain as though glued to the saddle."

如果骑士能够与他的坐骨取得坐姿平衡并且让他的下半部和上半部身体与臀部正确的成一直线的话，那麼，在腰部区域的龙骨变曲处，就会让身体像蜜糖一样黏在马鞍上。

I very lightly attach the trunk box with tape while checking alignment of the pocket level and plumb line.

我很轻易的重视主干框与磁带的同时，检查路线的口袋水平和铅垂线。

The second is to cut a mere 100 calories from your diet , which is the equivalent of a tablespoon of butter.

第二个就是从你的饮食中减少一百卡路里，只是相当于一大汤匙的黄油。

This is where the Rorschach test comes in.

现在，罗氏测试就出现了。