查询词典 hot rod

In hot weather the rod expands; So the bottom of the rod is lower.

热天金属杆膨胀，摆的底部变低，容器的底部也降低，而容器的水银膨胀后顶部升高。

The results show that the synthetic properties of geological drill rod by friction welding are better than that of the hot upset forged drill rod.

结果表明，与热镦粗的钻杆相比，摩擦焊接的地质钻杆具有良好的综合性能。

It has mainly actions as follows: accumulating steel wire; sending steel wire; drawing steel wire; clipping; tighten; squeezing flat; regulating position of strapper, etc; using annealed rod of φ6.5,φ6.0 or hot-finished rod ofφ6.0 directly as strapping steel wire; it straps and tightens for 720°,and then squeezing flat to make sure that it straps firm and not easily loose.

它具有如下主要动作：蓄丝、送丝、抽丝、剪断、拧紧、挤平、打捆机位置调节等；使用φ6.5，φ6.0的退火盘条或直接采用φ6.0的热轧盘条作捆丝；其捆结拧紧720°，然后挤平，保证了捆结牢固，不易松脱。

The polypropylene CPP film is characterized by excellent appearance, high transparency, shine, high water vapor proofness characteristics, air tightness the film "breathes",damage resistance, excellent heat sealability on devices of "hot rod" type, as this secures high strength of the weld joint as an inner layer of the laminate.

此膜的特点是：外观品质卓越、高度闪亮透明、高度防水防气、高阻隔性能好，抗破损。因为内里复合了高强度的粘结层，采用&加热棒&热封效果良好。

The polypropylene CPP film is characterized by excellent appearance, high transparency, shine, high water vapor proofness characteristics, air tightness (the film "breathes"), and damage resistance, excellent heat sealability on devices of "hot rod" type, as this secures high strength of the weld joint as an inner layer of the laminate.

此膜的特点是：外观品质卓越、高度闪亮透明、高度防水防气、高阻隔性能好，抗破损。因为内里复合了高强度的粘结层，采用&加热棒&热封效果良好。

Although he is not an actor, he has produced 19 movies, many of which were SNL spin-off's (Wayne's World, A Night at the Roxbury, and Superstar) as well as recent movies like Mean Girls, and Hot Rod.

尽管他本人不是演员，但他却拍摄出19部电影，包括最近的电影《贱女孩》和《热棒》以及《周六晚间直播》的很多续集（《韦恩的世界》，《舞场双雄》，《超级明星》）。

Butt Weld and docking and corner combinations Weld, in Weld ends located arc plate and extraction plate in igniting board then leads to the welding seam, joint halfway shall weld joints in front of 2.0 mm Department Firing arc, welding pieces after preheating rod will return to weld the origin, pool filled to the required thickness, before forward welding; Welding speed : Isokinetic welding requirements to ensure weld thickness, width uniform, which masks to look for hot metal and slag bath equidistance (2-3 mm)%; Arc welding rod length : different models and determined that the general requirements of arc length is stable, acid electrode generally 3-4 mm, 2-3 mm normally alkaline electrode%; Welding perspective : According to determine the thickness of two pieces of welding, welding angle has two aspects : First, the angle between the direction of the rod and welding of 60-75 ; The second is the angle between two electrodes and welding around, the same thickness as welding, welding and welding pieces incident angle of 45 ; When the thickness ranging from welding, welding electrode and thick and thin pieces of welding electrode side angle greater than the angle between the side pieces; Arc : admission to the end of each weld should be filled crater, in the direction opposite to the direction of the back-arc welding, arc welding unchanged inside pit in 1974, to prevent the crater bite of meat.

对接焊缝及对接和角接组合焊缝，在焊缝两端设引弧板和引出板，必须在引弧板上引出后再焊到焊缝区，中途接头则应在焊缝接头前方15～20㎜处打火引弧，将焊件预热后再将焊条退回到焊缝起始处，把熔池填满到要求的厚度后，方可向前施焊；焊接速度：要求等速焊接，保证焊缝厚度、宽度均匀一致，从面罩内看熔池中铁水与熔渣保持等距离（2～3㎜）为宜；焊接电弧长度：根据焊条型号不同而确定，一般要求电弧长度稳定不变，酸性焊条一般为3～4㎜，碱性焊条一般为2～3㎜为宜；焊接角度：根据两焊件的厚度确定，焊接角度有两个方面，一是焊条与焊接前进方向的夹角为60～75 ；二是焊条与焊接左右夹角有两种情况，当焊件厚度相等时，焊件与焊件夹角为45 ；当焊件厚度不等时，焊条与较厚焊件一侧夹角应大于焊条与薄焊件一侧夹角；收弧：每条焊缝焊到末尾，应将弧坑填满后，往焊接方向相反的方向带弧，使弧坑甩在焊道貌岸然里边，以防弧坑咬肉。

Air /Pop Loc remote Lockout Rebound adjustable/100mm travelFront Derailleur:Shimano SLX FD-M660/34.9mmRear Derailleur:Shimano XT RD-M772 SGSShifters:Shimano SLX SL-M660 Rapid-fire plus/2 way releaseChain set:Shimano XT FC-M770 HOLLOWTECH 2Chain rings: 44/32/22 TeethBottom Bracket:Shimano Cartridge/68mm shellCassette:SRAM PG-980 11-32 Teeth/alloy spiderChain:Shimano CN-HG53Pedals:Shimano PD-M505Front Brake:Avid Elixir5Scott HOT Rod OS 31.8mm Flat /620mm/9 degrees bendStem:Scott Comp 4 Bolt/OS31.8mmGrips:Scott lock-on gripsRims:DT Swiss 445d 32Hole /blackFront Hub:Scott disc pro disc itrear hub:shimano fh-m525 sl disc itspokes:dt swiss champion black 1.8mmfront tyre:schwalbe rocket ron 26*2.1/50epi bead performance seriesseat post:scott comp/31.6mmweight:2.35 Lbs

空气/流行禄远程锁定反弹adjustable/100mm旅行前避震器：禧玛诺SLX FD-M660/34.9mm 后变速器：禧玛诺xT配对的RD - M772信贷保证计划转换器：禧玛诺SLX可溶性L - M660速射加/ 2的方式释放套链：禧玛诺xT配对的FC - M770 HOLLOWTECH 2 链环：44/32/22牙中轴：禧玛诺Cartridge/68mm壳盒式：SRAM的指引980 11-32齿/合金蜘蛛连锁：禧玛诺架CN - HG53 踏板：禧玛诺钯M505 前刹车：Avid公司Elixir5 斯科特热棒操作系统三十一点八毫米平/六百二十零毫米/ 9度弯曲干：斯科特Comp 4 Bolt/OS31.8mm 握把：斯科特锁定在握把轮圈：胸苷瑞士445d 32Hole /黑色接待中心：斯科特这盘光盘亲后轮：禧玛诺跳频- m525可溶性它盘辐条：胸苷瑞士冠军1.8毫米黑色前轮胎：燕子火箭罗恩26 * 2.1/50epi珠性能系列座邮编：斯科特comp/31.6mm 重量：2.35磅

We can provide product name:Cooling wall of BF、Furnace throat Steel Brick、Double chain roller fixed pig machine、65T Hot iron tank car、65 ton hot iron tank、Fire bar of blast furnace hot blast stove、charging wagon、trial rod and so on.

主要产品：高炉冷却壁、炉喉钢砖、双链滚轮固定式铸铁机、65T铁水罐车、65吨铁水罐、热风炉炉箅子、料车及卷扬、探尺及卷扬、进风系统、除尘系统、炉顶设备、高炉炉体及热风炉炉体制作等。

Multi-function string which combines hollow rod electric heating, adding hot waste water above pump, adding hot waste water below pump, hot water circulation below pump, using sinker bar below pump, and borehole chemical viscosity reduction has been used selectively according to different production requirement and reservoir conditions.

采用能实现空心杆电加热、泵上掺热污水、泵下掺热污水、泵下热水循环泵上掺入、泵下配置加重杆、井筒化学降粘等多功能综合管柱，适应各种不同生产要求，根据油层条件，选取一种或多种组合、配套。

Results showed that 0.01g/mL extract of Oxalis corniculata L. had obvious antimicrobial effect on S. aureus, but all extract of Oxalis corniculata L has not any antimicrobial effect on E.

结果表明，0.01g/ml的提取物对摇床培养的金黄色葡萄球菌生长具有明显的抑制作用；但各种浓度的提取物对摇床培养的大肠杆菌生长均无抑制作用。

This will be totally different from Zaro's texture mod, it will be desaturated, dirty etc.

这会和Zaro的那个材质补丁有很大不同，这边是更多的不饱和色，整个都灰扑扑的。