查询词典 high temperature sensor

Simulation experiments make sure that the dilatometer is able to detect the expansion changes in low temperature. The high temperature reheating process with dilatometer analysis indicate that the firing temperature are little higher than 900℃ for one sample and lower than 900℃ for other five samples with firing temperature ranges of 550~650℃, 650~750℃ and 750~900℃. The results from mineral composition analysis of the samples by X-ray diffraction provide further evidence of the reliability of the thermal expansion measurement.

模拟实验表明，所采用的热膨胀仪能适应低温法测温实验；用热膨胀高温法测出早期陶片中有一块样品原始烧成温度略高于900℃，其余5块样品皆低于900℃；通过热膨胀低温法较为准确地测出这五块样品原始烧成温度是分别介于550~650℃、650~750℃、750~900℃三个范围，而X射线衍射分析结果从物相成分的角度证明了测温结果的可靠性。

To improve temperature uniformity,trolley electric furnace heated by three districts, in accordance with temperature arrangement method arrange heating elements, compensation for loss of furnace heat mouth, I District II District III district heating elements layout of the different, but the car high-precision temperature furnace heating and insulation in the process of maintaining three districts temperature consistent.

可为用户定做各种规格尺寸高精度高温台车电炉。为提高炉温均匀性，台车电炉采用三区加热，并按均温布丝法布置加热元件，为补偿炉口热损失，I区II区III区加热元件布置范围各不相同，但使高精度高温台车电炉在升温及保温过程中保持三区均温一致。

The oil-quenching tank uses the steel plate structure, has the square shape, the rectangle, the circular, in the fuel tank the installment has the electric heating tube, outside the trough the installment has the oil pump, the stainless steel disc heat interchanger, the automatic oil constant temperature controls the warm cabinet, its principle of work: When the work piece enters fuel tank quenching to cause frequently the oil temperature elevates, the oil pump starts to work, sucks in the stainless steel disc heat interchanger fuel tank's in high temperature oil, this time cools the circulating water to put through automatically, carries on the heat transfer through disc heat interchanger's multi-layer stainless steel plate trough, causes the quenching oil which the process cools to return to the oil-quenching tank again, so moves back and forth the circulation, achieves the fuel tank to decrease temperature the goal.

淬火油槽采用钢板结构，有方形、长方形、圆形，油槽内安装有电加热管，槽外安装有抽油泵、不锈钢板式换热器，自动油恒温控温柜，其工作原理：当工件频繁进入油槽淬火引起油温升高时，油泵开始工作，将油槽内的高温油抽入不锈钢板式换热器，此时冷却循环水自动接通，通过板式换热器的多层不锈钢板槽进行换热，使经过冷却的淬火油再返回淬火油槽，如此往复循环，达到油槽降温目的。

It can make slow changes of soil temperature. It decreased the quick changes of soil temperature caused by the sudden changes of air temperature, and maintain the normal growth of the trees, in addition, it increased air humidity in plum orchard. It eased the drought status during period of high temperature. Sown grass in plum orchard can increase soil organic substance, total N, available N, available F, and available K.

果园生草可以使土壤温度变化缓慢，缓解气温的骤变造成地温的急剧变化，维持树体的正常生长；提高果园空气湿度，缓解了旱期由于高温干旱造成的生长停滞；提高土壤有机质、全氮、速效氮、磷、钾的含量。

The temperature of the fuel plates and pectinate localizers is high, and the temperature of the side panels is close to the temperature of the flows between fuel plates, and the temperature of the flow outside of the side panels is low.

燃料板和定位梳的温度最高，侧板温度与板间流体温度相近，侧板外侧的流体温度较低。

In the vegetation of subalpine meadow zone, temperature is relative higher and there is local high temperature center in middle slope. Temperature is lower in slope foot, and the change of temperature grads is big.

在亚高山草甸带植被中，坡面中偏下部温度相对较高，往往会出现局部的高温中心；而坡面的底部普遍温度较低，且温度的梯度变化大。

The calculative results show that the efficient thermal conductivity rises as temperature rises under a constant fiber volume fraction, and it is proportional to the third power of absolute temperature; it decreases as fiber volume fraction increases under high temperature; it increases as fiber volume fraction increases under low temperature, and it is in agreement with that is described in the literature.

此式计算结果表明：在纤维体积分率一定时，其有效导热系数随温度的升高而升高，且它是绝对温度的三次方关系；在高温条件下，其有效导热系数随纤维体积分率的升高而四川大学硕土学位论文有减少趋势；在低温条件下，其有效导热系数随纤维体积分率的增大而增大，与所查文献描述规律一致。

These advantages of EBW make its use expanding in the welding of titanium and its alloys.The microstructure and properties of TC4 alloy joints welded by the electron beam were investigated in this paper with room-temperature impact test, room-temperature tensile test, room-temperature notch tensile test, high-temperature tensile test, endurant tensile test, microhardness test and metallographic analysis.

本课题通过室温冲击、室温拉伸、室温缺口拉伸、高温拉伸、持久拉伸及显微硬度等力学性能试验和金相显微组织分析、断口扫描分析等，对TC4钛合金电子束焊接接头的组织和力学性能进行了分析和研究。

The method is as follows: n-butyl titanate, absolute ethyl alcohol, surfactant and concentrated hydrochloric acid are fully mixed and stirred for 4 to 6 hours under room temperature to obtain precursor solution, then the precursor solution is spinningly coated on a clean conductive glass substrate of an indium oxide tin coating, and then the conductive glass spinningly coated with the precursor solution is preserved for 25 to 72 hours at the temperature of between 20 and 30 DEG C and the relative humidity of between 50 and 75 percent below, and finally undergoes a high-temperature calcination at the temperature of between 350 and 700 DEG C.

将钛酸正丁酯，无水乙醇，表面活性剂和浓盐酸充分混合，在室温下搅拌4小时-6小时得到前驱剂，然后将前驱剂旋涂在清洁的氧化铟锡镀层的导电玻璃基底上，接着在20℃-30℃，相对湿度在50％-75％下，将旋涂有前驱剂的导电玻璃保存24小时-72小时，最后经过350℃-700℃高温煅烧。

The first split of microspore mother cell is observed after one week after beginning of temperature arised under high temperature but the split of secondary sporogenous cell doesn't be found. The split of secondary sporogenous cell is still found after one week but the first split of microspore mother cell is observed after 12d under low temperature. Formating speed of male gametophyte is affected by temperature.

在高温条件下，开始加温1周后即看到小孢子母细胞进行第一次分裂，未观察到次生造孢细胞的分裂；在低温条件下，1周后仍能看到次生造孢细胞的分裂，12d后才看到小孢子母细胞进行第一次分裂。

I go to school at night.

我是上上学。

Clear Tip Nasal Aspirator: A soft time and gentle suction action makes removing excess mucus easy.

鼻吸明确提示：一个柔软的时间和温柔吸力行动使消除过剩的粘液容易。