英语人>网络例句>flanges 相关的网络例句
flanges相关的网络例句

查询词典 flanges

与 flanges 相关的网络例句 [注:此内容来源于网络,仅供参考]

But if they are supported on the top flanges of the floorbeams. it is desirable that the stringers be continuous over two or more panels.

但是,如果它们支撑在横梁顶缘,则纵梁最好要连续跨越两个跨度以上的桥面板。

Now that all the faces and flanges are defined, create bends to join the two offset faces to your sheet metal part.

既然所有面和凸缘都已定义,请建立折弯,以将两个偏移面和板金零件接合起来。

And also many 90° elbows, T-fittings, flanges, reducers and caps.

也有许多和90 °弯头, T 型接头,法兰,减速机和帽子。

The units can also be specified with bore diameters of between 30 and 60mm and can be supplied as a plummer block assembly or with square or oval flanges, making them an extremely versatile solution.

这些单位也可以指定承担直径为30至60毫米,可提供作为座组装或方形或椭圆形凸缘,使他们一个极其灵活的解决方案。

The units can also be specified with bore diameters of between 30 and 60mm and can be supplied as a Plummer block assembly or with square or oval flanges, making them an extremely versatile solution.

这些单位也可以指定承担直径为30至60毫米,可提供作为立式装配或方形或椭圆形凸缘,使他们一个极其灵活的解决方案。

The large flanges of the KM6 vacuum vessel are divided into eight or six pieces and welded insitu.

容器的法兰面要求密封以保证容器的真空度,由于尺寸过大只能在现场组装焊接并用简易机床作少量加工。

No angle member shall have the two leg flanges brought together by closing the angle.

任何角度成员应具备两个腿法兰关闭带来的角度在一起。

The tightening torques stated on table 1 are calculated for a tie rod stress equal to that allowable provided for such materials in ASME B31.3 and considers the leads provided on the flanges .

表1中所列的拧紧扭矩是按拉杆计算,且其应力取 ASME B31.3中该材料上的容许施加的应力,同时还考虑了法兰上的负荷。

Composite stud wall is composed of steel stud with plasterboard or Bolivian magnesium board attached to both flanges of the stud with screws at regular intervals.

由钢立柱两侧翼缘和石膏板、玻镁板通过自钻螺钉相连而形成的组合墙体是此种结构的主要竖向承重单元。

Specifications: DN15 ~ DN800; Pressure Range: 10 ~ 900KPa; Flow control tube for a total portfolio of the surface without any plating material; Working Pressure: ALE Series Stroke Stop and Stroke Switch 1600KPa or 2500KPa; Operating temperature: 120 ℃; Mass-flow error:± 5%; Connection: threaded or external flanges.

规格:DN15~DN800;压差范围:10~900KPa;流量控制筒为一整体组合,表面无任何电镀物料;工作压力:1600KPa 或 2500KPa;工作温度:120℃;流量误差:±5%;连接方式:丝扣或外接法兰。

第10/11页 首页 < ... 3 4 5 6 7 8 9 10 11 > 尾页
相关中文对照歌词
Money, Cars, Clothes
推荐网络例句

There are different types of personal loans available.

有许多不同类型的个人贷款优惠。

The above mentioned teaching model of spiral rising can be used to avoid rigidness in teaching.

上述螺旋式上升的教学模式,可以避免教学形成模式後的僵化现象。

In addition, the mass transfer process of main components in the heat pump cycle, such as a generator and an absorber, is analyzed, and the mass trasfer model, the relation of its separation effectiveness with the thermodynamic inconvertibility are described.

根据热力学第一、二定律,从理论上建立了描述该类热泵的数学模型。从热力学不可逆性原理出发,分析了热泵循环过程的热力学不可逆性引起的〓损失。