查询词典 feedback resistance

The influence of background light, reverse biasing voltage and feedback resistance on the performance of APD detection circuit is analyzed in detail.

实验表明：根据该方法设计的前放接收模块使测距仪接收系统获得最大信噪比， APD工作在最佳倍增状态，从而提高测距仪的探测灵敏度和最大测程。

If the feedback resistance, RF, equals 2RIN, where RIN is the input resistance, the closed-loop gain of each channel is –2V/V.

如果反馈电阻RF等于2RIN，其中RIN为输入电阻，各通道的闭环增益为–2V/V。

Finally, RF and CF are the feedback resistance and capacitance respectively.

最后，RF和CF分别是反馈电阻和反馈电容。

A feedback resistance communicates with the input and the output of the fourth OTA.

反馈电阻与第四OTA的输入和输出通信。

Rise time in a feedback picoammeter is a function of the physical or stray capacitance shunting the feedback resistance.

反馈型皮安计的上升时间是反馈电阻上并联的物理电容或寄生电容的函数。

See the component selection table for recommended values of input and feedback resistance as well as feedback capacitance and compensation capacitance.

查看输入和反馈电阻值的元件选择推荐表以及反馈电容和补偿电容。

The principle of the amplifier is get the value of the feedback resistance which can change the gain of the amplifier , then make sure the relay on the right stall, we can get the expectation gain.

本设计实现增益控制的原理是根据OP37G的放大原理公式计算出实现指标增益所需要的反馈电阻值，使用10K继电器选择相应电阻实现增益。

The feedback resistance, R1, is dependent on cell sensitivity and should be chosen for either maximum dynamic range or for a desired scale factor. R2 is elective: in the case of photovoltaic cells or of photodiodes, it is not required in the case of photoconductive cells, it should be chosen to minimize bias current error over the operating range.

反馈电阻R1的取值由电池的灵敏度和要求的最大动态范围，或者需要的电流——电压转换比例决定。R2分情况选取：在光电池和光电二极管时不需要这个电阻，在光电导的时候，电阻的阻值应该能使在工作范围内，由OP输入偏置电流所带来的误差最小。

But in achieving the current-voltage conversion, with the current-voltage feedback circuit we may reach the goal in the feedback resistance using, namely premise the photoelectric current certainly, the feedback resistance is bigger, the voltage is greater.

但是在实现电流-电压转换的时候，用的电流-电压反馈电路，我们可以在反馈电阻的使用上达到目的，即在光电二极管的光电流一定的前提下，反馈电阻越大，电压越大。

A digital AGC circuit using a digital potentiometer to rep lace the feedback resistance of the amp lifierwas designed. In order to get an app rop riate gain, MCU adjusted the resistance of the digital potentiometer automatically according to the voltage value of amp lifierps output.

为使输入信号不受这一限制，设计了一种数字式自动增益放大电路，该电路采用数字电位器取代放大器的反馈电阻，单片机根据放大器输出电压自动调整数字电位器的阻值来调节放大器增益，使输出电压始终维持在所设定的上下限电压之间。

But in the course of internationalization, they meet with misunderstanding and puzzlement.

许多企业已经意识到了这一点，但在国际化的进程中，仍存在一些误区与困惑。

Inorder toaccomplish this goal as quickly as possible, we'll beteamingup with anexperienced group of modelers, skinners, and animatorswhosenames willbe announced in the coming weeks.

为了尽快实现这个目标，我们在未来数周内将公布与一些有经验的模型、皮肤、动画制作小组合作。