查询词典 extraction pump

Series is a kind of mechani-cal seal component with centripetal. inbuilt, single face. multi-spring and non-equil-ibrium structrure and conforms to ISO 3069 and JB1472-75. It applies to all kinds of centri-fugal pump,chemical pump,inline pump,pipe pressure pump,dredge pump and multi-stage feed pump.

本型号机械密封件是一种内流内装，单端面，多弹簧非平衡型结构，符合ISO-3069，JB1472-75标准，应用于各种离心泵，化工泵，管道泵及管道增压泵，排污泵，多级给水泵。

We hope you pay more attention to jobs are as follows haven't been finished this week:(1) right and left side of upper water wall has been aligned and fixed;(2) Nine downcomers been pre-stored;(3) All the wall packing aligned and fixed, then install right and left side rigid beam;(4) Finishing welding counterpart of front wall packing;(5) Get two booster pump for turbine driven boiler feed water pump aligned and make inspection;(6) Electric Feed Water Pump Unit, Coupling and Motor Pump positioned;(7) Equipment in Start-up Boiler House aligned and make inspection;(8) Get three Reusing Water Pump aligned;(9) Equipment in Integrated Water Pump House aligned and make inspection.

本周，以下工作未完成，希望贵单位引起重视：（1）上水左右侧找正完，且加固完；（2）下降管9根预存完；（3）包墙全部找正完，加固完，之后安装左右侧刚性梁；（4）前包墙对口焊接完毕；（5）2台汽动前置泵找平找正，并验收；（6）电动给水泵组，耦合器和电泵就位；（7）启动锅炉房内设备找平找正，并验收；（8）3台复用水泵就位；（9）综合水泵房内设备找平找正，并验收。

For the upper and lower physical decomposition of the fuel pump, pump body can be placed, open side cover, remove the pump head fastening nut, remove the pump head, hand clamp plunger living roots, slowly out the plunger and spring cylinder fault, with clean petrol or diesel repeated washing, wash, after-loading complex (note the plunger into the regulation of regulation must fork arm), and alternately tighten pump head nut, rotating camshaft, oil pump pulled the handle to manipulate the review.

2对于上、下体能分解的喷油泵，可将水泵体平放，打开侧面盖板，卸下泵头紧固螺母，取下泵头，用手钳夹住柱塞根部，慢慢抽出故障缸柱塞和弹簧，用清洁的汽油或柴油反复清洗，洗净后装复(注意柱塞调节臂必须装入调节叉内)，并交替拧紧泵头螺母，转动凸轮轴，扳动油泵操纵手柄复查。

Enterprise specializing in pumps, valves, pipes, pipe fittings, corrosion-resistant equipment, mechanical equipment, steel-lined plastic·úmaterials and various types of product development, design, production and sales of main products have fluoroplastics pump, steel-lined PTFE pump , liquid pumps, self-priming pump, magnetic pump, centrifugal pump, stainless steel pump, fluorine plastic lined plug valves, butterfly valve, ball valve, valve, check valve, valve, gate valve, pipe fittings and steel equipment ten Level of stress, some more than 1120 kinds of model specifications.

企业专门从事水泵、阀门、管道、管件、防腐设备、机械设备、钢衬氟塑料及全塑各类产品的研发、设计、生产和销售，主要产品有氟塑料泵、钢衬四氟泵、液下泵、自吸泵、磁力泵、离心泵、不锈钢泵，氟塑料衬里旋塞阀、蝶阀、球阀、截止阀、止回阀、隔膜阀、闸阀、管道件及钢塑设备十个压力等级，约1120多种型号、规格。

The best extraction parameters are confirmed. The extraction temperature is 30℃, the extraction time is 20min, the extraction ratio is 4:1, and the extraction solution is alkalescency.

通过实验，确定了理论上最佳的萃取工艺条件：萃取温度30℃、萃取时间20min、萃取比4∶1、保持废水在碱性条件下萃取。

The influence of extraction temperature,extraction pressure,extraction time and the dosage of modifier on the extraction of chlorophyl from peach leaf by supercritical CO2 extraction technology was studied.

研究了萃取温度、萃取压力、萃取时间和夹带剂添加量对超临界CO2萃取桃叶中叶绿素的影响。

The factors included the type of extractant, the amount and the extraction times, the type of purified column, the type and dosage of eluviatant about the pre-treatment of the samples. The extraction was 3 minutes (13500rpm) of high speed homogenize extraction. 50mL acetonitrile as an extractant was acted on one time extraction. The florin silicon column was taken as the purified column. The extraction was eluted by 30ml 3:2 acetone - hexane and concentrated by nitrogen blowing under 50 °C water bath.The chromatographic separated conditions were studied applied the Agilent 6890 gas chromatographic apparatus and DB-17 capillary column(30m×0.25mm×0.25μm).

研究了提取剂种类、用量与提取次数，净化柱种类，淋洗剂种类与用量，提取方式与提取时间，柱温和柱流量等因素对油菜籽中有机磷农药残留提取、分离净化和色谱分离的影响，建立了采用高速匀浆提取方式提取3min13500rpm.min~(-1，以50mL乙腈为提取剂一次提取，以弗罗里硅柱为样品液净化柱，以30mL 3：2丙酮-正己烷为淋洗剂，在50℃水浴条件下用氮吹浓缩，气相色谱检测的油菜籽有机磷农药多种残留检测技术。

The results showed that the optimum conditions of Opuntia polysaccharides extraction were as follows: the ratio of water to material of 5.5:1, extraction temperature of 75℃ and extraction time of 2.2h, under such condition the extraction rate could be up to 0.82% at one-time extraction.

在分析各个因素的显著性和交互作用后，得出仙人掌多糖水浸提的最佳工艺条件为：水料比5.5：1，浸提温度75℃，浸提时间2.2h；浸提1次，仙人掌多糖的实际提取率可达0.81%，比单因素实验最高提取率高出5.8%。

The methods of mechanical compression, chemical extraction, soxhlet extraction and supercritical CO2 extraction were taken to extract the oil in perilla seed. With oil yielding rate of perilla seed after extraction as investigation index, the suitable extraction method for oil in perilla seed was screened.

方法］采用机械压榨法、化学萃取法、索氏提取法和超临界CO2萃取法提取紫苏子油，以紫苏子萃取后的出油率为考察指标，筛选适宜的紫苏子油的提取方法。

On the basis of the previous results and according to the central composite experimental design principles,the method of response surface method with 3 factors and 3 levels was adopted.then the factors influencing the technological parameters were determined by means of regression analysis.response surface and contour were finally graphed with the extraction rate as the response value.resultsthe optimum conditions of lycium barbarum polysaccharides extraction were as follows:the ratio of material to solvent of 1∶32,extraction temperature of 84℃ and extraction time of 2.3 h,one time extraction.conclusionthe yield of lycium barbarum polysaccharides is 11.10% under the optimum conditions.

方法在单因素实验基础上选取实验因素与水平，根据中心组合（box-benhnken）实验设计原理采用3因素水平的响应面分析法，依据回归分析确定各工艺条件的影响因子，以多糖提取率为响应值作响应面和等高线。结果在分析各个因素的显著性和交互作用后，得出枸杞多糖水浸提的最佳工艺条件为：料液比1∶32；浸提温度84℃；浸提时间2.3h；浸提1次。结论在最佳工艺条件下，枸杞多糖的实际提取率可达11.10%。

I had a lovely dog named PiPi, he was one of my best friends.

我曾经有过一只小狗，它的名字叫皮皮，它很善良，它是我最忠实的朋友。

Newly ovulated mouse oocytes were cultured in the CZB medium supplemented with different concentrations of pyruvate before treated for activation or assayed for MPF activity.

我们猜测卵母细胞在不含丙酮酸的条件下老化的更快，并且卵丘细胞可能通过消耗不含葡萄糖的CZB中的丙酮酸从而促进卵母细胞老化。